离心压缩机级通流与盘盖侧泄漏流的耦合分析

王晟旻 1; 2; 琚亚平 1; 张楚华 1

doi:10.7652/xjtuxb201707011

您当前的位置：

首页 >

文章列表页 >

离心压缩机级通流与盘盖侧泄漏流的耦合分析

更新时间：2025-07-09

- 离心压缩机级通流与盘盖侧泄漏流的耦合分析
- Coupling Analysis between Through Flow and Hub-Shroud Side Leakage Flow of a Centrifugal Compressor Stage
- 西安交通大学学报 2017年51卷第7期页码：73-77
- 作者机构：
  
  1. 西安交通大学能源与动力工程学院,西安,710049
  2. 沈阳鼓风机集团股份有限公司,沈阳,100869
- 作者简介：
- 基金信息：
  
  : 2016-10-08。作者简介: 王晟旻(1986—),男,硕士,工程师;琚亚平(通信作者),女,副教授。基金项目: 国家自然科学基金资助项目(51406148);国家重点研发计划资助项目(2016YFB0200903);教育部重大科技基础培育计划课题
- DOI：10.7652/xjtuxb201707011
  中图分类号： TH452
- 网络首发：2017-07-10，
  
  纸质出版：2017
- 稿件说明：
移动端阅览
王晟旻 1, 2, 琚亚平 1, 等. 离心压缩机级通流与盘盖侧泄漏流的耦合分析[J]. 西安交通大学学报, 2017,51(7):73-77.

Coupling Analysis between Through Flow and Hub-Shroud Side Leakage Flow of a Centrifugal Compressor Stage[J]. 2017, 51(7): 73-77.
王晟旻 1, 2, 琚亚平 1, 等. 离心压缩机级通流与盘盖侧泄漏流的耦合分析[J]. 西安交通大学学报, 2017,51(7):73-77. DOI： 10.7652/xjtuxb201707011.

Coupling Analysis between Through Flow and Hub-Shroud Side Leakage Flow of a Centrifugal Compressor Stage[J]. 2017, 51(7): 73-77. DOI： 10.7652/xjtuxb201707011.

摘要

为揭示离心压缩机通流与轮盘及轮盖侧迷宫密封泄漏流动之间的耦合作用机理

以某天然气管线用离心压缩机首级为研究对象

数值分析了压缩机级在不考虑密封结构模型以及考虑密封结构模型下的流场分布。结果表明:在考虑密封结构的情况下

压缩机整级的等熵效率和总压比都有所下降

且在小流量工况时下降更为明显; 等厚度高低密封齿和梯形密封齿均能有效衰减泄漏气流压力能和动能

从而有效降低泄漏量; 密封通道内的泄漏气流在叶轮进出口与通流区气流掺混时易造成通流分离; 受轮盖密封泄漏气流的影响

在叶轮进口轮盖侧存在明显的熵增区域

使得压缩机整级性能下降。研究工作为深入了解离心压缩机密封流动结构及其对通流的影响、完善离心压缩机在实际运行状态下的气动性能预测模型奠定了坚实理论基础。

Abstract

In order to reveal the coupling interaction between centrifugal compressor's through flow and hub-shroud labyrinth seal leakage flow

the inlet stage of a centrifugal compressor in natural gas pipeline was studied in this paper. Numerical simulations of internal flow fields of the centrifugal compressor stage with and without labyrinth seal were carried out. The results showed that the model with seal has lower isotropic efficiency and total-to-total pressure ratio than the model without seal

especially at low flow rates. Both the seal cavities with the alternate long-short seal teeth of identical thickness and with the trapezoid seal teeth are capable of dissipating the gas pressure and kinetic energy into heat energy

thus significantly decreasing the leakage flow rate. The mixing of leakage flow and through flow can lead to the separation of through flow near inlet and outlet of centrifugal impeller. Subject to shroud-side leakage flow

the through flow near the impeller inlet suffers significant increase in entropy and hence a deterioration in the aerodynamic performance of the whole stage. The present work would provide a theoretical foundation for the in-depth understanding of the interaction between through flow and hub-shroud side leakage flow and for the improvement in the aerodynamic performance prediction model of the in-service centrifugal compressors.

关键词

Keywords

references

宁喜, 王维民, 张娅, 等. 离心式压缩机密封动态特性分析及稳定性评价 [J]. 振动与冲击, 2013, 32(13): 153-158.

NING Xi, WANG Weimin, ZHANG Ya, et al. Dynamic performance analysis of seals in a centrifugal compressor and rotor stability evaluation [J]. Journal of Vibration and Shock, 2013, 32(13): 153-158.

李军, 晏鑫, 宋立明, 等. 透平机械密封技术研究进展 [J]. 热力透平, 2008, 37(3): 141-148.

LI Jun, YAN Xin, SONG Liming, et al. A review of sealing technologies in turbomachinery [J]. Thermal Turbine, 2008, 37(3): 141-148.

XU L Q, WANG Z H, XI G. An improvement of labyrinth seal in shroud of centrifugal compressor with low flow coefficient [J]. Journal of Engineering Thermophysics, 2012, 33(7): 1131-1134.

MARECHALE R, JI M, CAVE M. Experimental and numerical investigation of labyrinth seal clearance impact on centrifugal impeller performance [C]∥ASME Turbo Expo 2015: Turbine Technical Conference and Exposition. New York, USA: ASME, 2015: V02CT 42A035.

SHIMADA K, KIMURA K, OHTA H, et al. Phenomenon of labyrinth seal with low static pressure difference and large clearance: prediction of performance and experimental result [J]. Journal of Visualization, 2003, 6(4): 395-405.

GAMAL A J M, VANCE J M. Labyrinth seal leakage tests: tooth profile, tooth thickness, and eccentricity effects [J]. ASME Journal of Engineering for Gas Turbines and Power, 2008, 130(1): 012510.

SURYANARAYANAN S, MORRISON G L. Analysis of flow parameters influencing carry-over coefficient of labyrinth seals [C]∥ASME Turbo Expo 2009: Power for Land, Sea, and Air. New York, USA: ASME, 2009: 1137-1145.

周国宇, 王旭东, 林智荣, 等. 高低齿迷宫密封泄漏量实验及计算分析 [J]. 工程热物理学报, 2015, 36(9): 1889-1893.

ZHOU Guoyu, WANG Xudong, LIN Zhirong, et al. Preliminary analysis to the leakage of the staggered labyrinth seal based on experiment and simulation [J]. Journal of Engineering Thermophysics, 2015, 36(9): 1889-1893.

李志刚, 李军, 丰镇平. 迷宫密封泄漏特性影响因素的研究 [J]. 西安交通大学学报, 2010, 44(3): 16-20.

LI Zhigang, LI Jun, FENG Zhenping. Effects of gap pressure ratio and rotational speed on discharge behavior of labyrinth seal [J]. Journal of Xi'an Jiaotong University, 2010, 44(3): 16-20.

秦瑞鸿, 孙一颉, 王晟旻, 等. 轮盘侧空腔流动结构及其对离心压缩机气动性能的影响 [J]. 工程热物理学报, 2016, 37(11): 2349-2354.

QIN Ruihong, SUN Yijie, WANG Shengmin, et al. Flow structure in impeller backside cavity and its effect on aerodynamic performance of a centrifugal compressor [J]. Journal of Engineering Thermophysics, 2016, 37(11): 2349-2354.

SUN Z, TAN C, ZHANG D. Flow field structures of the impeller backside cavity and its influences on the centrifugal compressor [C]∥ASME Turbo Expo 2009: Power for Land, Sea, and Air. New York, USA: ASME, 2009: 1349-1360.

MISCHO B, RIBI B, SEEBASS-LINGGI C, et al. Influence of labyrinth seal leakage on centrifugal compressor performance [C]∥ASME Turbo Expo 2009: Power for Land, Sea, and Air. New York, USA: ASME, 2009: 1283-1293.

DAY I. Stall, surge and 75 years of research [J]. Journal of Turbomachinery, 2015, 138(1): 011001.

王晟旻. 离心压缩机级间影响及泄漏特性分析 [D]. 西安: 西安交通大学, 2016.

李燕坡, 王吉鹏, 曹彦恒, 等. 离心式压缩机密封技的应用综述 [J]. 风机技术, 2011, 53(6): 58-62.

LI Yanpo, WANG Jipeng, CAO Yanheng, et al. Overview of the application of centrifugal compressor seal technology [J]. Compressor Blow Fan Technology, 2011, 53(6): 58-62.

张楚华, 琚亚平. 流体机械内流理论与计算 [M]. 北京: 机械工业出版社, 2016: 105-144.

JU Y P, ZHANG C H. Design optimization and experimental study of tandem impeller for centrifugal compressor [J]. AIAA Journal of Propulsion and Power, 2014, 30(6): 1490-1501.

JU Y P, ZHANG C H, CHI X L. Optimization of centrifugal impellers for uniform discharge flow and wide operating range [J]. AIAA Journal of Propulsion and Power, 2012, 28(5): 888-899.

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

离心压缩机性能预测中雷诺平均湍流模型的不确定度量化与分析

R1234ze（E）替代R134a对二级压缩循环离心压缩机及制冷性能的影响

离心压缩机级间加气的出口流场特性

考虑转轴伸长效应的刷式密封泄漏流动和摩擦传热特性

基于喘振频域特性的失稳预警技术研究