用于超低频信号测量的高精度低功耗增量式模数转换器

陈浩; 孙权; 张鸿; 程军; 张瑞智

doi:10.7652/xjtuxb201706013

您当前的位置：

首页 >

文章列表页 >

用于超低频信号测量的高精度低功耗增量式模数转换器

更新时间：2025-07-09

- 用于超低频信号测量的高精度低功耗增量式模数转换器
- Incremental Analog-to-Digital Converter with High Resolution and Low Power for Measurement of Ultra-Low-Frequency Signals
- 西安交通大学学报 2017年51卷第6期页码：79-85+114
- 作者机构：
  
  西安交通大学微电子学院,西安,710049
- 作者简介：
- 基金信息：
  
  : 2016-12-23。作者简介: 陈浩(1992—),男,硕士生;张鸿(通信作者),男,副教授。基金项目: 国家自然科学基金资助项目(61474092);陕西省科技计划资助项目(2014K05-14)
- DOI：10.7652/xjtuxb201706013
  中图分类号： TN432
- 网络首发：2017-06-10，
  
  纸质出版：2017
- 稿件说明：
移动端阅览
陈浩, 孙权, 张鸿, 等. 用于超低频信号测量的高精度低功耗增量式模数转换器[J]. 西安交通大学学报, 2017,51(6):79-85+114.

Incremental Analog-to-Digital Converter with High Resolution and Low Power for Measurement of Ultra-Low-Frequency Signals[J]. 2017, 51(6): 79-85+114.
陈浩, 孙权, 张鸿, 等. 用于超低频信号测量的高精度低功耗增量式模数转换器[J]. 西安交通大学学报, 2017,51(6):79-85+114. DOI： 10.7652/xjtuxb201706013.

Incremental Analog-to-Digital Converter with High Resolution and Low Power for Measurement of Ultra-Low-Frequency Signals[J]. 2017, 51(6): 79-85+114. DOI： 10.7652/xjtuxb201706013.

摘要

针对超低频信号测量装置对模数转换器(ADC)的高精度、低功耗和小面积要求

提出了一种带有斩波稳零(CHS)和自校准技术的增量式模数转换器(I-ADC)。I-ADC带有复位操作

可避免超低频信号带来的模式噪声。为了尽量降低功耗和芯片面积

I-ADC采用一阶结构

并通过增加一定的转换时间来实现14 bit的转换精度。该I-ADC采用斩波稳零技术来消除运放低频噪声和失调对其精度的影响

I-ADC的系统失调则采用上电自校准技术来消除。采用DongBu 0.5 μm BCD工艺完成了I-ADC电路及其调制器版图的设计。仿真结果表明:在-156.25～156.25 mV输入范围内

I-ADC转换误差的绝对值最大为21 μV

微分非线性误差的绝对值最大为0.12 bit

积分非线性误差的绝对值最大为0.21 bit

调制器的平均电流消耗仅为20 μA; 调制器的版图面积仅为150 μm×310 μm; 所设计的I-ADC可满足锂电池电量计等超低频测量系统所需的14 bit转换精度

并具有显著的低功耗和小面积优势。

Abstract

An incremental analog-to-digital converter(I-ADC)with chopper stabilization(CHS)and self-calibration techniques is presented to meet the requirements of high resolution

low power consumption and small area for measuring devices of ultra-low-frequency signals. The I-ADC has the function of reset operation to avoid pattern noise caused by ultra-low-frequency signals. A first-order architecture is adopted for the I-ADC to reduce power consumption and chip area

and to achieve 14-bit resolution by increasing certain conversion time. The chopper stabilization technique is employed to eliminate the influence of amplifier's low-frequency noise and offset on the I-ADC's precision

and power-on self-calibration is employed to eliminate the systematic offset of the I-ADC. The circuit of the I-ADC and the layout of the modulator are designed with the DongBu 0.5 μm BCD technology. Simulation results in an input range of -156.25～156.25 mV show that the maximum absolute conversion error of the I-ADC is 21 μV

the maximum errors of differential nonlinearity and integral nonlinearity are 0.12 and 0.21 bit

respectively

and the average current consumption of the modulator is only 20 μA. The modulator occupies a chip area of only 150 μm×310 μm. The proposed I-ADC achieves 14 bit resolution

which is required by ultra-low-frequency signal measuring systems

such as lithium-ion battery coulometer

and has significant advantages of low power consumption and small area.

关键词

Keywords

references

何梓滨, 蒋方亮, 柏向春. 超低频信号测量中ADC系统的设计与实现 [J]. 电子测量与仪器学报, 2012(S1): 75-79.

HE Zibin, JIANG Fangliang, BAI Xiangchun. Design and implementation of the ADC system for ultra-low-frequency signal measurement [J]. Journal of Electronic Measurement and Instrumentation, 2012(S1): 75-79.

张鸿, 张牡丹, 张杰, 等. 用于植入式医疗装置的逐次逼近式模数转换器 [J]. 西安交通大学学报, 2015, 49(2): 43-48.

ZHANG Hong, ZHANG Mudan, ZHANG Jie, et al. A successive approximation register analog-to-digital converter for implantable biomedical devices [J]. Journal of Xi'an Jiaotong University, 2015, 49(2): 43-48.

SINGH K, PAVAN S. A 14 bit dual channel incremental continuous-time delta sigma modulator for multiplexed data acquisition [C]∥Proceedings of the IEEE International Conference on VLSI Design. Piscataway, NJ, USA: IEEE, 2016: 230-235.

WANG Xiaofei, ZHANG Hong, YANG Guoqiang, et al. A 12-bit incremental ΣΔ ADC for battery management system in electric vehicles [C]∥Proceedings of the 2014 IEEE 12th International Conference on Solid-State and Integrated Circuit Technology. Piscataway, NJ, USA: IEEE, 2014: 7021299.

MCILRATH L G. A low-power low-noise ultrawide-dynamic-range CMOS imager with pixel-parallel A/D conversion [J]. IEEE Journal of Solid-State Circuits, 2001, 36(5): 846-853.

WANG Xiaofei, ZHANG Hong, ZHANG Jianrong, et al. A multi-cell battery pack monitoring chip based on 0.35-μm BCD technology for electric vehicles [J]. Ieice Electronics Express, 2015, 12(12): 20150367-20150367.

WANG Lei, YAN Taotao, MO Tingting, et al. A 14-b 2MSPS low power sigma-delta ADC using feed-forward structure [C]∥Proceedings of 3rd International Conference on Measuring Technology and Mechatronics Automation. Piscataway, NJ, USA: IEEE, 2011: 3-5.

YU Wenhuan, ASLAN M, TEMES G C. 82 dB SNDR 20-channel incremental ADC with optimal decimation filter and digital correction [C]∥ Proceedings of the Custom Integrated Circuits Conference. Piscataway, NJ, USA: IEEE, 2010: 5617596.

PILLER S, PERRIN M, JOSSEN A. Methods for state-of-charge determination and their applications [J]. Journal of Power Source, 2001, 96(1): 113-120.

杨晴霞, 曹秉刚, 徐俊, 等. 一种估计锂电池充电状态的分数阶阻抗模型 [J]. 西安交通大学学报, 2015, 49(8): 128-132.

YANG Qingxia, CAO Binggang, XU Jun, et al. A fractional impedance model for charge state estimation of lithium battery [J]. Journal of Xi'an Jiaotong University, 2015, 49(8): 128-132.

范腾飞, 陈奕梅. 基于2～4串锂电池组的库仑计法电量计设计 [J]. 电子科技, 2013, 26(2): 7-10.

FAN Tengfei, CHEN Yimei. Design of coulomb counter system based on 2 to 4 cells lithium-powered battery pack [J]. Electronic Science and Technology, 2013, 26(2): 7-10.

CHEN H L, CHEN P S, CHIANG J S. A low-offset low-noise sigma-delta modulator with pseudorandom chopper-stabilization technique [J]. IEEE Transactions on Circuits and Systems: I Regular Papers, 2009, 56(12): 2533-2543.

WANG Luo, JI Huihui, SUN Quan. A sigma-delta modulator with a novel chopper correlated double sampled integrator [C]∥ Proceedings of International Conference on ASIC. Piscataway, NJ, USA: IEEE Computer Society, 2011: 449-452.

DENG Honghui, WANG Zhangmeng. A chopper-stabilized amplifier for input signal amplification of sigma-delta ADC [C]∥Proceedings of the 2014 IEEE International Conference on Anti-Counterfeiting, Security and Identification. Piscataway, NJ, USA: IEEE, 2014: 7064968.

MOLLAZADEH M, MURARI K, CAUWENBERGHS G, et al. Micropower CMOS integrated low-noise amplification, filtering, and digitization of multimodal neuropotentials [J]. IEEE Transactions on Biomedical Circuits Systems, 2009, 3(1): 1-10.

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

流水线模数转换器中高速低功耗开环余量放大器的设计

用于植入式医疗装置的逐次逼近式模数转换器

用于植入式医疗设备的低功耗低位逐次逼近型模数转换器

超临界水异常区域热力学特性研究

电子级超纯氮深冷空分流程节能优化研究