1.北京天兵科技有限公司, 100076,北京
2.西安交通大学叶轮机械研究所, 710049,西安
宋会玲(1979—),女,高级工程师;
李志刚,男,教授,博士生导师。
收稿:2025-01-13,
网络首发:2025-03-11,
纸质出版:2025-07-10
移动端阅览
宋会玲, 魏阳国, 李永鹏, 等. 深径比对孔型阻尼密封泄漏特性和流体激振动力学性能的影响研究[J]. 西安交通大学学报, 2025,59(7):87-98.
SONG Huiling, WEI Yangguo, LI Yongpeng, et al. Study on the Influence of Depth-to-Diameter Ratio on the Leakage and Rotordynamic Characteristic of Hole-Pattern Damper Seals[J]. Journal of Xi’an Jiaotong University, 2025, 59(7): 87-98.
宋会玲, 魏阳国, 李永鹏, 等. 深径比对孔型阻尼密封泄漏特性和流体激振动力学性能的影响研究[J]. 西安交通大学学报, 2025,59(7):87-98. DOI: 10.7652/xjtuxb202507009.
SONG Huiling, WEI Yangguo, LI Yongpeng, et al. Study on the Influence of Depth-to-Diameter Ratio on the Leakage and Rotordynamic Characteristic of Hole-Pattern Damper Seals[J]. Journal of Xi’an Jiaotong University, 2025, 59(7): 87-98. DOI: 10.7652/xjtuxb202507009.
为揭示孔深对孔型阻尼密封封严性能和刚度阻尼动力学性能的影响规律,探究最佳孔深方案,采用非定常多频摄动数值方法,研究了不同孔深下孔型阻尼密封的泄漏特性和动力学特性。首先,通过3种孔深下孔型阻尼密封泄漏量和动力特性系数的数值与试验数据对比,验证了数值方法的准确性;然后,计算分析了3种不同孔径(
D
为2.0、3.175、5.0 mm)下连续变化孔深(深径比
A
r
为0.1~1.25)的孔型阻尼密封的泄漏量;最后,评估了2种进口预旋(
μ
0
为0、0.5)、5种不同孔深(
H
为0.5、1.0、1.9、3.3、6.6 mm,
D
为3.175 mm)下孔型密封的动力特性系数、腔室动态压力及旋流速度发展。数值结果表明:深径比
A
r
是影响孔型密封泄漏特性的关键几何参数;从密封封严性能角度来看,
A
r
为0.4~0.5是最佳孔深方案,此时不同孔径的密封泄漏量均达到最小值;从密封动力学稳定性角度来看,较小孔深的孔型阻尼密封动力学稳定性更优,在确定最佳孔深时,需考虑污染物沉积、腐蚀磨损对孔深的影响,避免选择过小的孔深(
H
≥1.0 mm)。
To reveal the influence of hold depth on the sealing performance and dynamic characteristics of hole-pattern damper seals
and to explore the optimal hold depth scheme
this paper employs an unsteady multi-frequency perturbation numerical method to investigate the leakage and dynamic characteristics of hole-pattern damper seals at different depths. First
the accuracy of the numerical method is validated by comparing the leakage amounts and dynamic characteristic coefficients of hole-pattern damper seals at three different depths with experimental data. Then
the leakage amounts of hole-pattern damper seals with three different diameters (
D
=2.0
3.175
5.0 mm) and continuously varying depths (depth-to-diameter ratio
A
r
=0.1—1.25) are calculated and analyzed. Finally
the dynamic characteristic coefficients
chamber dynamic pressures
and vortex velocity developments of the seals under two types of inlet pre-rotation (
μ
0
=0
0.5) and five different depths (
H
=0.5
1.0
1.9
3.3
6.6 mm
D
=3.175 mm) are evaluated. Numerical results indicate that the depth-to-diameter ratio
A
r
is a key geometric parameter affecting the leakage characteristics of hole-pattern seals. From the perspective of sealing performance
A
r
=0.4—0.5 represents the optimal hole depth scheme
at which the leakage amounts for different diameters reach their minimum. In terms of dynamic stability
hole-pattern damper seals with smaller depths exhibit better dynamic stability. When determining the optimal hold depth
it is necessary to consider the impact of contaminant deposition and corrosion wear
avoiding excessively small depths (
H
≥1.0 mm).
ARMSTRONG J , PERRICONE F . Turbine instability solution-honeycomb seals [C ] // 25th Turbomachinery Symposium . College Station, USA : Texas A & M University , 1996 : 47 - 56 .
LI Zhigang , LI Jun , FENG Zhenping . Numerical investigations on the leakage and rotordynamic characteristics of pocket damper seals:Part Ⅰ effects of pressure ratio, rotational speed, and inlet preswirl [J ] . Journal of Engineering for Gas Turbines and Power , 2015 , 137 ( 3 ): 032503 .
ZEIDAN F Y , PEREZ R X , STEPHENSON E M . The use of honeycomb seals in stabilizing two centrifugal compressors [C ] // 22nd Turbomachinery Symposium . College Station, USA : Texas A & M University , 1993 : 3 - 16 .
VANCE J M , SCHULTZ R R . A new damper seal for turbomachinery [C ] // ASME 1993 Design Technical Conferences . New York, USA : ASME , 1993 : 139 - 148 .
CHILDS D W , MOYER D S . Vibration characteristics of the HPOTP (high-pressure oxygen turbopump) of the SSME (space shuttle main engine) [J ] . Journal of Engineering for Gas Turbines and Power , 1985 , 107 ( 1 ): 152 - 159 .
YU Z , CHILDS D W . A comparison of experimental rotordynamic coefficients and leakage characteristics between hole-pattern gas damper seals and a honeycomb seal [J ] . Journal of Engineering for Gas Turbines and Power , 1998 , 120 ( 4 ): 778 - 783 .
MOORE J J , WALKER S T , KUZDZAL M J . Rotordynamic stability measurement during full-load, full-pressure testing of a 6000 psi reinjection centrifugal compressor [C ] // 31st Turbomachinery Symposium . College Station : Texas A & M University , 2002 : 29 - 38 .
YAN Xin , HE Kun , LI Jun , et al . Numerical investigations on rotordynamic characteristic of hole-pattern seals with two different hole-diameters [J ] . Journal of Turbomachinery , 2015 , 137 ( 7 ): 071011 .
VANNARSDALL M , CHILDS D W . Static and rotordynamic characteristics for a new hole-pattern annular gas seal design incorporating larger diameter holes [J ] . Journal of Engineering for Gas Turbines and Power , 2014 , 136 ( 2 ): 022507 .
晏鑫 , 李军 , 丰镇平 . 孔型气体密封转子的动力特性研究 [J ] . 动力工程 , 2009 , 29 ( 1 ): 31 - 35 .
YAN Xin , LI Jun , FENG Zhenping . Research on dynamic characteristics of the rotor with annular seal of hole-pattern [J ] . Journal of Power Engineering , 2009 , 29 ( 1 ): 31 - 35 .
KLEYNHANS G F , CHILDS D W . The acoustic influence of cell depth on the rotordynamic characteristics of smooth-rotor/honeycomb-stator annular gas seals [J ] . Journal of Engineering for Gas Turbines and Power , 1997 , 119 ( 4 ): 949 - 956 .
李志刚 , 李军 , 丰镇平 . 进口防旋板对孔型密封非定常气流激振特性的影响 [J ] . 西安交通大学学报 , 2016 , 50 ( 1 ): 16 - 21 .
LI Zhigang , LI Jun , FENG Zhenping . Effect of swirl brakes on unsteady flow excitation characteristics of hole-pattern seal [J ] . Journal of Xi'an Jiaotong University , 2016 , 50 ( 1 ): 16 - 21 .
LI Zhigang , LI Jun , YAN Xin . Multiple frequencies elliptical whirling orbit model and transient RANS solution approach to rotordynamic coefficients of annual gas seals prediction [J ] . Journal of Vibration and Acoustics , 2013 , 135 ( 3 ): 031005 .
CHOCHUA G , SOULAS T A . Numerical modeling of rotordynamic coefficients for deliberately roughened stator gas annular seals [J ] . Journal of Tribology , 2007 , 129 ( 2 ): 424 - 429 .
晏鑫 , 李军 , 丰镇平 . Bulk Flow方法分析孔型密封转子动力特性的有效性 [J ] . 西安交通大学学报 , 2009 , 43 ( 1 ): 24 - 28 .
YAN Xin , LI Jun , FENG Zhenping . Validation of two-control-volume bulk flow method for rotordynamic characteristics of hole-pattern seals [J ] . Journal of Xi'an Jiaotong University , 2009 , 43 ( 1 ): 24 - 28 .
SHIN Y S . Modifications to a two-control-volume, frequency dependent, transfer-function analysis of hole-pattern gas annular seals [D ] . College Station : Texas A & M University , 2007 .
CHILDS D W , KIM C H . Analysis and testing for rotordynamic coefficients of turbulent annular seals with different, directionally-homogeneous surface-roughness treatment for rotor and stator elements [J ] . Journal of Tribology , 1985 , 107 ( 3 ): 296 - 305 .
CHILDS D W , KIM C H . Test results for round-hole-pattern damper seals: optimum configurations and dimensions for maximum net damping [J ] . Journal of Tribology , 1986 , 108 ( 4 ): 605 - 609 .
CHILDS D W , NOLAN S A , KILGORE J J . Additional test results for round-hole-pattern damper seals: leakage, friction factors, and rotordynamic force coefficients [J ] . Journal of Tribology , 1990 , 112 ( 2 ): 365 - 371 .
张子涵 , 陈涛文 , 李志刚 , 等 . 孔的排布方式对孔型阻尼密封泄漏特性和动力学性能影响研究 [J ] . 西安交通大学学报 , 2024 , 58 ( 4 ): 75 - 84 .
ZHANG Zihan , CHEN Taowen , LI Zhigang , et al . Effect of hole arrangement modes on the leakage and rotordynamic characteristics of hole-pattern seals [J ] . Journal of Xi'an Jiaotong University , 2024 , 58 ( 4 ): 75 - 84 .
CHILDS D W , WADE J . Rotordynamic-coefficient and leakage characteristics for hole-pattern-stator annular gas seals: measurements versus predictions [J ] . Journal of Tribology , 2004 , 126 ( 2 ): 326 - 333 .
BROWN P D , CHILDS D W . Measurement versus predictions of rotordynamic coefficients of a hole-pattern gas seal with negative preswirl [J ] . Journal of Engineering for Gas Turbines and Power , 2012 , 134 ( 12 ): 122503 .
CHILDS D W , ARTHUR S , MEHTA N J . The impact of hole depth on the rotordynamic and leakage characteristics of hole-pattern-stator gas annular seals [J ] . Journal of Engineering for Gas Turbines and Power , 2014 , 136 ( 4 ): 042501 .
方志 , 李志刚 , 李军 . 孔型几何参数对孔型密封泄漏和鼓风加热特性影响研究 [J ] . 西安交通大学学报 , 2019 , 53 ( 1 ): 135 - 141 .
FANG Zhi , LI Zhigang , LI Jun . Investigation on the effects of hole geometrical parameters on leakage and windage heating characteristics of hole-pattern seals [J ] . Journal of Xi'an Jiaotong University , 2019 , 53 ( 1 ): 135 - 141 .
方志 , 李志刚 , 李军 . 孔型参数对流体孔型密封泄漏特性和转子耗功的影响 [J ] . 西安交通大学学报 , 2020 , 54 ( 9 ): 81 - 88 .
FANG Zhi , LI Zhigang , LI Jun . Effects of hole depth and diameter on the leakage characteristics and rotor power loss of liquid hole-pattern seals [J ] . Journal of Xi'an Jiaotong University , 2020 , 54 ( 9 ): 81 - 88 .
0
浏览量
27
下载量
0
CSCD
关联资源
相关文章
相关作者
相关机构
京公网安备11010802024621