靶丸位置对冷冻靶物理场的影响规律研究

李翠; 赵小迪; 郭富城; 胡孟华; 陈冠华; 厉彦忠

doi:10.7652/xjtuxb202110014

您当前的位置：

首页 >

文章列表页 >

靶丸位置对冷冻靶物理场的影响规律研究

更新时间：2025-07-09

- 靶丸位置对冷冻靶物理场的影响规律研究
- Effects of Capsule Sag and Shift on the Thermal Environment of Cryogenic Target
- 西安交通大学学报 2021年55卷第10期页码：123-130
- 作者机构：
  
  西安交通大学能源与动力工程学院,西安,710049
- 作者简介：
- 基金信息：
  
  : 2021-01-13。作者简介: 李翠(1982—),女,博士,副教授。基金项目: 国防重大专项资助项目
- DOI：10.7652/xjtuxb202110014
  中图分类号： TB661
- 网络首发：2021-10-10，
  
  纸质出版：2021
- 稿件说明：
移动端阅览
李翠, 赵小迪, 郭富城, 等. 靶丸位置对冷冻靶物理场的影响规律研究[J]. 西安交通大学学报, 2021,55(10):123-130.

Effects of Capsule Sag and Shift on the Thermal Environment of Cryogenic Target[J]. 2021, 55(10): 123-130.
李翠, 赵小迪, 郭富城, 等. 靶丸位置对冷冻靶物理场的影响规律研究[J]. 西安交通大学学报, 2021,55(10):123-130. DOI： 10.7652/xjtuxb202110014.

Effects of Capsule Sag and Shift on the Thermal Environment of Cryogenic Target[J]. 2021, 55(10): 123-130. DOI： 10.7652/xjtuxb202110014.

摘要

针对冷冻靶丸装配工艺误差导致靶丸表面温度特性变化的问题

建立带充气管的三维模型

基于Boussinesq假设和离散坐标辐射模型

采用数值模拟方法

研究了靶丸及充气管在竖直和水平方向进行偏移时靶丸表面温度分布的变化

并分析比较了充气管、辅助加热及辐射对靶丸偏移敏感性的影响。结果表明:充气管对靶丸表面温度均匀性影响显著

相较于无充气管结构

具有单充气管和对侧双充气管的靶丸其外表面最大温差分别增大78.9%、76.7%; 对于具有充气管结构的靶丸

存在使均匀性改善的最佳偏移工况; 单充气管结构靶丸竖直向上适当偏移时

靶丸表面温度均匀性更好

最佳偏移距离为5 μm

且单充气管结构在水平方向容许向左112 μm的偏移; 随着加热功率增大

竖直方向最佳偏移距离基本不变

但靶丸对水平方向装配工艺误差的容忍度增大; 封口膜透射率越大

靶丸位置偏移越敏感

相同偏移距离下靶丸表面最大温差越大。

Abstract

Three-dimensional numerical models are established to investigate the effects of capsule sag and shift on its thermal environment in cryogenic target with micro filling tubes. The simulation bases on Boussinesq hypothesis and a discrete ordinates radiation model. Variations of the target temperature and velocity distributions are studied when the capsule and its gas filling tube are offset in the vertical and horizontal directions and effects of gas filling tube

shimming heating and thermal radiation on the shift-and-sag sensitivity are analyzed. The results show that the gas filling tube has a significant effect on the surface temperature uniformity of the capsule

and the maximum temperature differences on the outer surface of the capsule with single filling tube and two opposite filling tubes increase by 78.9% and 76.7% respectively

compared with no filling tube configurations. For the case of the single filling tube

the capsule temperature uniformity can be improved when the target is offset vertically within a certain distance. Under given conditions

the optimal offset distance for maximum uniformity improvement is 5 μm

while the horizontal offset of 112 μm is allowed for the single gas filling tube configuration. With an increase in shimming heating power

the optimal offset distance in the vertical direction is almost unchanged

but the tolerance of the horizontal shift of the target increases. As to the thermal radiation

the larger the transmittance of sealing films is

the more sensitive the capsule temperature to the target offset is

along with the larger temperature difference.

关键词

Keywords

references

SHEFFIELD J. World population and energy demand growth: the potential role of nuclear energy in an efficient world [J]. Fusion Technology, 1998, 34: 281-287.

江少恩, 丁永坤, 缪文勇, 等. 我国激光惯性约束聚变实验研究进展 [J]. 中国科学: D辑, 2009, 39(11): 1571-1583.

JIANG Shaoen, DING Yongkun, MIU Wenyong, et al. Recent progress of inertial confinement fusion experiments in China [J]. Science China: D, 2009, 39(11): 1571-1583.

张杰. 浅谈惯性约束核聚变 [J]. 物理, 1999, 28(3): 142-152.

ZHANG Jie. An overview of inertial confinement fusion [J]. Physics, 1999, 28(3): 142-152.

HURRICANE O, ACALLAHAN D, ACASEY D T, et al. Fuel gain exceeding unity in an inertially confined fusion implosion [J]. Nature, 2014, 506(7488): 343-348.

HAAN S W, LINDL J D, CALLAHAN D A, et al. Point design targets specifications and requirements for the 2010 ignition campaign on the national ignition facility [J]. Physics of Plasmas, 2011, 18(5): 041006.

HEZ J, JGIEDT W H. Thin films for reducing tamping gas convection heat transfer effects in a national ignition facility hohlraum [J]. Fusion Science and Technology, 2003, 44(4): 811-819.

MOLL G, MARTIN MBACLET P. Thermal simulations of the LMJ cryogenic target [J]. Fusion Science and Technology, 2007, 51(4): 737-746.

HAAN S, MSALMONSON, JCLARK D, et al. NIF ignition target requirements margins and uncertainties: status February 2010 [J]. Fusion Science and Technology, 2011, 59(1): 17.

MCKENTY, PGONCHAROV, VTOWN R, et al. Analysis of a direct-drive ignition capsule designed for the national ignition facility [J]. Physics of Plasmas, 2001, 8(5): 2315-2322.

HUO Wenyi, LI Zhichao, CHEN Yaohua, et al. First investigation on the radiation field of the spherical hohlraum [J]. Physical Review Letters, 2016, 117(2): 025002.

陈鹏玮, 厉彦忠, 辛毅, 等. 冷却气体对黑腔系统温度场影响数值模拟 [J]. 原子能科学技术, 2018, 52(3): 553-561.

CHEN Pengwei, LI Yanzhong, XIN Yi, et al. Numerical simulation of cooling gas effect on temperature distribution inside cryotarget system [J]. Atomic Energy Science and Technology, 2018, 52(3): 553-561.

郭富城, 李翠, 陈冠华, 等. 辐射条件下冷冻靶靶丸表面及充气管温度特性数值研究 [J]. 原子能科学技术, 2020, 54(11): 2201-2208.

GUO Fucheng, LI Cui, CHEN Guanhua, et al. Numerical investigation on temperature characteristic of capsule surface and filling tube of cryogenic target under radiation condition [J]. Atomic Energy Science and Technology, 2020, 54(11): 2201-2208.

陈鹏玮, 厉彦忠, 李翠, 等. 低温冷冻靶温度动态特性的数值模拟研究 [J]. 物理学报, 2017, 66(19): 18-29.

CHEN Pengwei, LI Yanzhong, LI Cui, et al. Simulation of dynamic thermal characteristics of cryogenic target [J]. Acta Physica Sinica, 2017, 66(19): 18-29.

高莎莎, 吴小军, 何智兵, 等. 激光惯性约束聚变靶制备技术研究进展 [J]. 强激光与粒子束, 2020, 32(3): 5-14.

GAO Shasha, WU Xiaojun, HE Zhibing, et al. Research progress of fabrication techniques for laser inertial confinement fusion target [J]. High Power Laser and Particle Beams, 2020, 32(3): 5-14.

CLARK D S, WEBER C R, KRITCHER A L, et al. Modeling and projecting implosion performance for the National Ignition Facility [J]. Nuclear Fusion, 2019, 59: 032008.

EDWARDS M J, MARINAK M, DITTRICH T, et al. The effects of fill tubes on the hydrodynamics of ignition targets and prospects for ignition [J]. Physics of Plasmas, 2005, 12: 056318.

HAMMEL B A, HAAN S W, CLARK D S, et al. High-mode Rayleigh-Taylor growth in NIF ignition capsules [J]. High Energy Density Physics, 2010, 6(2): 171.

MACPHEE A G, SMALYUK V A, LANDEN O L, et al. Mitigation of X-ray shadow seeding of hydrodynamic instabilities on inertial confinement fusion capsules using a reduced diameter fuel fill-tube [J]. Physics of Plasmas, 2018, 25: 054505.

GIBSON C R, ATKINSON D P, BALTZ J A, et al. Design of the NIF cryogenic target system [J]. Fusion Science and Technology, 2009, 55(3): 233-236.

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

液化天然气浸没燃烧式气化器数值模拟方法研究

微充气管残留燃料冰对冷冻靶控温过程的影响分析

冷冻靶温度场瞬态响应特性及二级冷屏影响分析

EBSILON软件在热电联产系统优化中的应用综述

离子液体改性燃料的电流体动力学效应研究