1. 中南大学机电工程学院高性能复杂制造国家重点实验室,长沙,410083
2. 长沙航空职业技术学院航空机械制造系,长沙,410124
网络首发:2019-12-10,
纸质出版:2019
移动端阅览
曾乐 1, 2, 谭建平 1, 等. 阀控非对称缸系统神经网络多逆模型切换控制研究[J]. 西安交通大学学报, 2019,53(12):153-160.
Multi-Inverse Model Switching Control for Valve-Controlled Asymmetric Cylinder Systems Based on Neural Network[J]. 2019, 53(12): 153-160.
曾乐 1, 2, 谭建平 1, 等. 阀控非对称缸系统神经网络多逆模型切换控制研究[J]. 西安交通大学学报, 2019,53(12):153-160. DOI: 10.7652/xjtuxb201912020.
Multi-Inverse Model Switching Control for Valve-Controlled Asymmetric Cylinder Systems Based on Neural Network[J]. 2019, 53(12): 153-160. DOI: 10.7652/xjtuxb201912020.
为提高存在负叠合量的阀控非对称缸系统的控制性能
提出基于神经网络的逆系统控制方法
利用神经网络逼近的逆模型与原系统复合
将复杂非线性系统转变为线性系统进行控制
建立了阀控非对称缸系统的数学模型
系统在(x
0
u)的邻域内存在相对阶
证明了系统的可逆性; 采用基于遗传算法改进的BP神经网络(GA-BP)求解逆模型
并针对伺服阀存在负叠合量
以及流态存在层流和紊流两种状态的问题
建立系统的多个逆模型集
提高了逆系统的求解精度。利用AMESIM和Simulink联合仿真平台
基于参考速度切换的原则
对系统采用比例-积分-微分(PID)闭环控制器。结果表明:普通PID控制的液压缸伸出运动响应和缩回运动响应不一致
伸出运动存在0.20 mm的稳态误差
误差波动范围为0.06 mm
而缩回运动稳态误差较小
约为0.02 mm
但误差波动较大
约为0.09 mm; 多逆系统复合控制的伸出缩回运动响应较一致
伸出和缩回运动均存在0.02 mm的稳态误差
误差波动范围为0.04 mm
验证了多逆模型切换控制方法可以消除阀控非对称缸系统的非对称性
降低波动负载干扰影响
提高系统的响应精度。
A control method based on a neural network inverse system is proposed to improve the control performance of valve-controlled asymmetric cylinder systems with negative overlap. An inverse model of neural network approximation is used to transform the complex nonlinear system into a linear system. A mathematical model is established for the valve-controlled asymmetric cylinder system
and the system exists relative orders in the neighborhood of (x
0
u)
which proves the reversibility of the system. An improved BP neural network based on a genetic algorithm(GA-BP)is used to so
lve the inverse model. Aiming at the problems of the negative overlap and the laminar and turbulent flow in the servo valve
several inverse models for the system are established to improve the accuracy of the inverse system. Finally
a simulation platform combined with AMESIM and Simulink is used
and a proportional-integral-derivative(PID)closed-loop controller is adopted for the system based on the princ
杨军宏, 尹自强, 李圣怡. 阀控非对称缸的非线性建模及其反馈线性化 [J]. 机械工程学报, 2006, 42(5): 203-207.
YANG Junhong, YIN Ziqiang, LI Shengyi. Nonlinear modeling and feedback linearization of valve-controlled asymmetrical cylinder [J]. Journal of Mechanical Engineering, 2006, 42(5): 203-207.
汪首坤, 彭建敏. 带遗忘因子的预测迭代学习控制在阀控非对称缸系统中的应用研究 [J]. 机械工程学报, 2014, 50(10): 191-198.
WANG Shoukun, PENG Jianmin. Forecast iterative learning control with forgetting factor and its application in valve-controlled asymmetric cylinder [J]. Journal of Mechanical Engineering, 2014, 50(10): 191-198.
马立峰, 韩贺永, 黄庆学, 等. 液压滚切剪液压系统的换向冲击分析 [J]. 吉林大学学报(工学版), 2012, 42(6): 1396-1401.
MA Lifeng, HAN Heyong, HUANG Qingxue, et al. Analysis of commutation impact in hydraulic system of hydraulic rolling shear [J]. Journal of Jilin University(Engineering and Technology Edition), 2012, 42(6): 1396-1401.
李洪人, 王栋梁, 李春萍. 非对称缸电液伺服系统的静态特性分析 [J]. 机械工程学报, 2003, 39(2): 18-22.
LI Hongren, WANG Dongliang, LI Chunping. Static property analysis of electrohydraulic single rod cylinder servo systems [J]. Journal of Mechanical Engineering, 2003, 39(2): 18-22.
訚耀保. 高端液压元件理论与实践 [M]. 上海: 上海科学技术出版社, 2017: 222.
柏艳红, 权龙. 电液位置速度复合伺服系统控制策略 [J]. 机械工程学报, 2010, 46(24): 150-155.
BAI Yanhong, QUAN Long. Control strategy of the electro-hydraulic position and speed hybrid servo system [J]. Journal of Mechanical Engineering, 2010, 46(24): 150-155.
张飞, 童朝南, 彭开香, 等. 液压位置控制系统的自适应补偿 [J]. 机械工程学报, 2005, 41(5): 94-97.
ZHANG Fei, TONG Chaonan, PENG Kaixang, et al. Adaptation compensation of hydraulic servo control system [J]. Journal of Mechanical Engineering, 2005, 41(5): 94-97.
潘旭东, 王广林, 邵东向, 等. 伺服阀滑阀叠合量测量方法 [J]. 振动、测试与诊断, 2009, 29(4): 392-397, 475.
PAN Xudong, WANG Guanglin, SHAO Dongxiang, et al. Measurement of spool valve overlap value of servo valve [J]. Journal of Vibration, Measurement and Diagnosis, 2009, 29(4): 392-397, 475.
张辉, 刘江, 关广丰, 等. 伺服比例阀非线性校正方法研究 [J]. 机床与液压, 2010, 38(11): 1-3, 34.
ZHANG Hui, LIU Jiang, GUAN Guangfeng, et al. Approaches to non-linearity compensation of servo valve [J]. Machine Tool Hydraulic, 2010, 38(11): 1-3, 34.
李胜, 阮健, 孟彬, 等. 空载流量特性死区的颤振补偿 [J]. 机械工程学报, 2014, 50(18): 186-192.
LI Sheng, RUAN Jian, MENG Bin, et al. Dither compensation for dead zone of zero load flow of characteristics [J]. Journal of Mechanical Engineering, 2014, 50(18): 186-192.
BORUTZKY W, BARNARD B, THOMA J. An orifice flow model for laminar and turbulent conditions [J]. Simulation Modelling Practice and Theory, 2002, 10(3/4): 141-152.
PAN X, WANG G, LU Z. Flow field simulation and a flow model of servo-valve spool valve orifice [J]. Energy Conversion and Management, 2011, 52(10): 3249-3256.
CERMAN O, HUEK P. Adaptive fuzzy sliding mode control for electro-hydraulic servo mechanism [J]. Expert Systems with Applications, 2012, 39(11): 10269-10277.
陆翔, 戴先中, 张凯锋. 电力系统神经网络逆控制中的闭环控制器设计 [J]. 东南大学学报(自然科学版), 2004, 34(1): 117-121.
LU Xiang, DAI Xianzhong, ZHANG Kaifeng. Closed-loop controller design method in the ANN-inversion-based decoupling and linearizing control of power systems [J]. Journal of Southeast University(Natural Science Edition), 2004, 34(1): 117-121.
戴先中, 刘军, 冯纯伯. 连续非线性系统的神经网络α阶逆系统控制方法 [J]. 自动化学报, 1998, 25(4): 33-38.
DAI Xianzhong, LIU Jun, FENG Chunbo. Neural network α-th order inverse system method for the control of nonlinear continuous systems [J]. Acta Automatica Sinica, 1998, 24(4): 33-38.
戴先中, 张兴华, 刘国海, 等. 感应电机的神经网络逆系统线性化解耦控制 [J]. 中国电机工程学报, 2004, 24(1): 112-117.
DAI Xianzhong, ZHANG Xinghua, LIU Guohai, et al. Decoupling control of induction motor based on neural networks inverse [J]. Proceedings of the CSEE, 2004, 24(1): 112-117.
戴先中, 孟正大, 沈建强, 等. 神经网络α阶逆系统控制方法在机器人解耦控制中的应用 [J]. 机器人, 2001, 23(4): 363-367.
DAI Xianzhong, MENG Zhengda, SHEN Jianqiang, et al. Robot decoupling control based on ANN α-th order inverse system method [J]. Robot, 2001, 23(4): 363-367.
姚建勇, 焦宗夏, 黄澄. 基于动态逆模型的电液位置伺服系统复合控制 [J]. 机械工程学报, 2011, 47(10): 145-151.
YAO Jianyong, JIAO Zongxia, HUANG Cheng. Compound control for electro-hydraulic positioning servo system based on dynamic inverse model [J]. Journal of Mechanical Engineering, 2011, 47(10): 145-151.
KNOHL T, UNBEHAUEN H. Adaptive position control of electrohydraulic servo systems using ANN [J]. Mechatronics, 2000, 10(1/2): 127-143.
MILIC ' V, ITUM S, ESSERT M. Robust H∞position control synthesis of an electro-hydraulic servo system [J]. ISA Transactions, 2010, 49(4): 535-542.
GUO Q, YUT, JIANG D. Robust H∞positional control of 2-DOF robotic arm driven by electro-hydraulic servo system [J]. ISA Transactions, 2015, 59: 55-64.
戴中天. 多变量非线性系统的神经网络逆控制方法 [M]. 北京: 科学出版社, 2005: 122-124.
田延岭, 包亚洲, 王福军, 等. 音圈电机驱动的柔性定位平台设计与控制 [J]. 天津大学学报(自然科学与工程技术版), 2017, 50(10): 1070-1076.
TIAN Yanling, BAO Yazhou, WANG Fujun, et al. Design and control of a flexible positioning stage driven by voice coil motors [J]. Journal of Tianjin University(Science and Technology), 2017, 50(10): 1070-1076.
0
浏览量
5
下载量
1
CSCD
关联资源
相关文章
相关作者
相关机构
京公网安备11010802024621