准东煤旋风燃烧的数值模拟

张向宇; 杨玉; 白文刚; 徐宏杰

doi:10.7652/xjtuxb201911016

您当前的位置：

首页 >

文章列表页 >

准东煤旋风燃烧的数值模拟

更新时间：2025-07-09

- 准东煤旋风燃烧的数值模拟
- Numerical Simulation on the Cyclone Combustion of Zhundong Coal
- 西安交通大学学报 2019年53卷第11期页码：112-117
- 作者机构：
  
  西安热工研究院有限公司电站锅炉煤清洁燃烧国家工程研究中心,西安,710032
- 作者简介：
- 基金信息：
  
  : 2019-05-08。作者简介: 张向宇(1984—),男,博士,高级工程师。基金项目: 国家自然科学基金青年科学基金资助项目(51806172);国家重点研发计划资助项目(2018YFB0604100)
- DOI：10.7652/xjtuxb201911016
  中图分类号： TQ546
- 网络首发：2019-11-10，
  
  纸质出版：2019
- 稿件说明：
移动端阅览
张向宇, 杨玉, 白文刚, 等. 准东煤旋风燃烧的数值模拟[J]. 西安交通大学学报, 2019,53(11):112-117.

Numerical Simulation on the Cyclone Combustion of Zhundong Coal[J]. 2019, 53(11): 112-117.
张向宇, 杨玉, 白文刚, 等. 准东煤旋风燃烧的数值模拟[J]. 西安交通大学学报, 2019,53(11):112-117. DOI： 10.7652/xjtuxb201911016.

Numerical Simulation on the Cyclone Combustion of Zhundong Coal[J]. 2019, 53(11): 112-117. DOI： 10.7652/xjtuxb201911016.

摘要

为掌握准东煤在液态排渣旋风炉中的燃烧特性

对准东煤旋风燃烧过程进行了数值模拟。通过建立传热传质模型求解熔渣层的热物性参数

并作为边界条件代入燃烧CFD模拟中构建联合迭代算法。结果表明

迭代收敛后火焰温度与热电偶测量值基本吻合

误差小于4%。大于10 μm的飞灰颗粒与熔渣层碰撞并被黏附

颗粒沉积可简化为一次碰撞。熔渣层厚度沿筒长方向呈非均匀分布

最大厚度约为2 mm

可近似为牛顿流体的流动边界层。排渣口处熔渣温度大于黏度25 Pa·s对应的温度

能够实现稳定液态排渣。立式旋风炉捕渣率大于0.6

捕渣率分布主要受配风方式的影响。

Abstract

To understand the combustion characteristics of Zhundong coal in the cyclone furnace with liquid slagging

numerical simulation of cyclone combustion process of Zhundong coal was conducted. The heat and mass transfer models were established to solve the thermophysical parameters of the slag film

and the parameters were introduced into the combustion CFD model as the boundary condition. The results show that the calculated flame temperature is consistent with the measured value of thermocouple

and the maximum error is less than 4%. The ash particles larger than 10 -m may collide with the slag film and be adhered to the slag

and the particle deposition can be simplified to a single collision. The slag film thickness is non-uniformly distributed along the cyclone furnace length

and the maximum thickness is about 2 mm. The slag film can be approximated as the flow boundary layer of Newtonian fluid. The slag temperature in the slagging outlet is higher than the temperature correspondin

关键词

Keywords

references

XU L, LIU J, KANG Y, et al. Safely burning high alkali coal with kaolin additive in a pulverized fuel boiler [J]. Energy & Fuels, 2014, 28(9): 5640-5648.

WEI B, TAN H, WANG Y, et al. Investigation of characteristics and formation mechanisms of deposits on different positions in full-scale boiler burning high alkali coal [J]. Applied Thermal Engineering, 2017, 119(5): 449-458.

CHUDNOVSKY B, TALANKER A, BERMAN Y, et al. Prediction of performance from PRB coal fired in utility boilers with various furnace and firing system arrangements [J]. Journal of Engineering for Gas Turbines and Power, 2010, 32(12): 27-34.

李小宇, 李广宇, 许世森, 等. 液态排渣煤气化炉炉内灰渣的流动和换热研究 [J]. 中国电机工程学报, 2009, 29(14): 12-17.

LI Xiaoyu, LI Guangyu, XU Shisen, et al. Research on flow and heat transfer of slag film in gasifier with liquid slag-removal process [J]. Proceedings of the CSEE, 2009, 29(14): 12-17.

李代力, 王智化, 许岩韦, 等. 液态排渣炉燃烧过程的数值模拟 [J]. 浙江大学学报, 2013, 47(2): 280-286.

LI Daili, WANG Zhihua, XU Yanwei, et al. Numerical simulation of combustion process for a slag tapping boiler [J]. Journal of Zhejiang University, 2013, 47(2): 280-286.

VANEYK P J, ASHMAN P J, NATHAN G J. Mechanism and kinetics of sodium release from brown coal char particles during combustion [J]. Combustion and Flame, 2011, 158(12): 2512-2523.

周俊虎, 匡建平, 周志军, 等. 粉煤气化炉冷态和热态流场分布特性的数值模拟 [J]. 中国电机工程学报, 2007, 27(20): 30-35.

ZHOU Junhu, KUANG Jianping, ZHOU Zhijun, et al. Numerical simulation for pulverized coal gasifier's fluid flow characteristic on cold and hot condition [J]. Proceedings of the CSEE, 2007, 27(20): 30-35.

周俊虎, 匡建平, 周志军, 等. 粉煤气化炉喷嘴受热分析和渣层模型的数值模拟 [J]. 中国电机工程学报, 2007, 27(26): 23-29.

ZHOU Junhu, KUANG Jianping, ZHOU Zhijun, et al. Numerical simulation for pulverized coal gasifier heating nozzle and slag building model [J]. Proceedings of the CSEE, 2007, 27(26): 23-29.

WANG X, ZHAO D, HE L, et al. Modeling of a coal-fired slagging combustor: development of a slag sub-model [J]. Combustion Flame, 2007, 149(3): 249-260.

WANG X, ZHAO D, HE L, et al. A review on numerical modeling of ash deposition during the process of pulverized coal combustion [J]. Advances in Mechanics, 2005, 35(3): 417-426.

LIU S, HAO Y. Numerical simulation of flow and heat transfer of s lag layer in an entrained-flow coal gasifier [J]. Journal of Engineering Thermophysics, 2009, 30(4): 631-634.

刘升, 郝英立, 杜敏, 等. 气流床煤气化炉壁面反应模型 [J]. 化工学报, 2010, 61(5): 1219-1225.

LIU Sheng, HAO Yingli, DU Min, et al. A model of wall reaction in entrained-flow coal gasifier [J]. CIESC Journal, 2010, 61(5): 1219-1225.

ZHANG X, ZHENG S, ZHOU H, et al. Simultaneously reconstruction of inhomogeneous temperature and radiative properties by radiation image processing [J]. International Journal of Thermal Science, 2016, 107: 121-130.

SEGGIANI M. Modelling and simulation of time varying slag flow in a Prenflo entrained-flow gasifier [J]. Fuel, 1998, 77(14): 1611-1621.

RICHARDS G H, SLATER P N, HARB J N. Simulation of ash deposit growth in a pulverized coal fired pilot scale reactor [J]. Energy Fuels, 1993, 7(6): 774-781.

WATANABE H, OTAKA M. Numerical simulation of coal gasification in entrained flow coal gasifier [J]. Fuel, 2006, 85(6): 1935-1943.

水利电力部热工研究所. 旋风炉及其灰渣综合利用 [M]. 北京: 水利电力出版社, 1979: 44-46.

DONG G, LI Z, ZHANG Z. Study on the vortex structure of coupling combustion stabilizer with square cylinder-strong swirl flow [J]. Procedia Engineering, 2015, 99: 741-745.

要雅姝,温渡,周屈兰,等.高温水蒸气氛围中煤燃烧特性研究.2018,52(12):84-92.[doi:10.7652/xjtuxb201812013]

李沁伦,王璐凯,刘银河,等.300 MW一次再热亚临界燃煤发电站系统改进研究.2018,52(9):54-63.[doi:10.7652/xjtuxb201809007]

陶子宸,王长安,王鹏乾,等.半焦富氧燃烧扩散效应研究.2018,52(9):155-161.[doi:10.7652/xjtuxb201809021]

赵磊,王长安,朱晨钊,等.灰化方式和温度对新疆高碱煤灰理化特性的影响.2018,52(8):139-145.[doi:10.7652/xjtuxb201808021]

王振林,李祥晟,庄士超,等.旋进涡核与火焰面耦合作用对燃烧稳定性影响的数值研究.2018,52(7):60-67.[doi:10.7652/xjtuxb201807009]

王朝阳,常仁杰,朱庆玉,等.两种水煤比控制策略下调峰机组的能耗特性.2018,52(7):115-122.[doi:10.7652/xjtuxb 201807017]

李艳,谭厚章,王学斌,等.生物质高温热解气、液、固三相产物及碳烟生成特性.2018,52(1):61-68.[doi:10.7652/xjtuxb201801010]

王长安,Justin K.WATSON,Enette LOUW,等.耦合堆垛与孔径分布的高碱金属煤焦分子建模方法.2017,51(9):1-10.[doi:10.7652/xjtuxb201709001]

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

蒸发毛细弯液面热质传输特征及其稳定性分析

水洗对准东煤煤质特性影响的实验研究

O2/CO2燃烧条件下NO2还原特性的实验研究

板翅式换热器热通道结霜过程的数值模拟

立式径向流吸附器传热传质过程模拟研究