用于辅助电源Buck变换器的切换滑模控制策略

马光亮; 续丹; 王斌; 张乐; 周佳辉

doi:10.7652/xjtuxb201810014

您当前的位置：

首页 >

文章列表页 >

用于辅助电源Buck变换器的切换滑模控制策略

更新时间：2025-07-09

- 用于辅助电源Buck变换器的切换滑模控制策略
- A Control Strategy of Switching Sliding Mode for Auxiliary Energy Source Buck Converter
- 西安交通大学学报 2018年52卷第10期页码：102-109
- 作者机构：
  
  西安交通大学机械工程学院,西安,710049
- 作者简介：
- 基金信息：
  
  : 2018-05-31。作者简介: 马光亮(1994-),男,硕士生;王斌(通信作者),男,助理研究员。基金项目: 中国博士后科学基金资助项目(2018M631143);陕西省自然科学基础研究计划资助项目(2018JQ5126)
- DOI：10.7652/xjtuxb201810014
  中图分类号： TM46;TP13
- 网络首发：2018-10-10，
  
  纸质出版：2018
- 稿件说明：
移动端阅览
马光亮, 续丹, 王斌, 等. 用于辅助电源Buck变换器的切换滑模控制策略[J]. 西安交通大学学报, 2018,52(10):102-109.

A Control Strategy of Switching Sliding Mode for Auxiliary Energy Source Buck Converter[J]. 2018, 52(10): 102-109.
马光亮, 续丹, 王斌, 等. 用于辅助电源Buck变换器的切换滑模控制策略[J]. 西安交通大学学报, 2018,52(10):102-109. DOI： 10.7652/xjtuxb201810014.

A Control Strategy of Switching Sliding Mode for Auxiliary Energy Source Buck Converter[J]. 2018, 52(10): 102-109. DOI： 10.7652/xjtuxb201810014.

摘要

针对电动汽车辅助电源系统采用滑模控制方法

存在策略实现复杂度高、系统输出不稳定的问题

提出了一种用于辅助电源Buck变换器的切换滑模控制策略。将辅助电源系统输出电压与目标电压进行对比输出电压误差

然后在限制条件下对电压误差进行调节

有效避免了电压误差变化率的负向输出

从而实现了MOSFET开关的高效控制。搭建仿真模型与实验平台

完成了对切换滑模控制策略有效性的验证

结果表明:所提的辅助电源Buck变换器的切换滑模控制策略在降低复杂度的基础上

能有效地消除奇异问题

保证系统的动态响应速度和稳定性; 与传统的滑模控制策略相比

辅助电源采用切换滑模控制策略

系统启动响应调节时间缩短了25%

系统抗干扰能力和鲁棒性均得到了提高。

Abstract

A switching sliding mode control(SSMC)strategy for auxiliary energy source Buck converter is proposed to solve the problems that the implementation of the sliding mode control(SMC)strategy for auxiliary energy source system in electric vehicle is too complicated

and the output voltage of the system might be unstable. The output voltage and target voltage of the auxiliary energy source are compared to output a voltage error. Then

the voltage error is regulated under some restrictive conditions

so that negative output of the change rate of the voltage error is effectively avoided

and the efficient control of MOSFET switch is realized. A simulation model and an experimental platform are established to verify the effectiveness of the proposed SSMC strategy. Results show that the proposed SSMC strategy for auxiliary energy source Buck converter effectively eliminates the singularity problem and reduces the implementation complexity. Moreover

the dynamic response speed and stability of the auxiliary energy source system with Buck converter are guaranteed. A comparison with the SMC strategy shows that the proposed SSMC strategy has 25% improvement in the settling-time of start-up response for the auxiliary energy source system with Buck converter. The anti-interference ability and robustness of the system are improved.

关键词

Keywords

references

YU Hongwei, DUAN Jinhui, DU Wei, et al. China's energy storage industry: develop status, existing problems and countermeasures [J]. Renewable & Sustainable Energy Reviews, 2017, 71: 767-784.

LI Qiyu, ZHAO Shengdun, WANG Mengqi, et al. An improved perturbation and observation maximum power point tracking algorithm based on a PV module four-parameter model for higher efficiency [J]. Applied Energy, 2017, 195: 523-537.

YANG Yong, GUO Su, LIU Deyou, et al. Operation optimization strategy for wind-concentrated solar power hybrid power generation system [J]. Energy Conversion Management, 2018, 160: 243-250.

GANG B G, KIM H, KWON S. Ground simulation of a hybrid power strategy using fuel cells and solar cells for high-endurance unmanned aerial vehicles [J]. Energy, 2017, 141: 1547-1554.

王斌, 徐俊, 曹秉刚, 等. 一种新型电动汽车复合电源结构及其功率分配策略 [J]. 汽车工程, 2015, 37(9): 1053-1058.

WANG Bin, XU Jun, CAO Binggang, et al. A novel hybrid power configuration and its power distribution strategy for electric vehicles [J]. Automotive Engineering, 2015, 37(9): 1053-1058.

WANG Bin, XU Jun, CAO Binggang, et al. A novel multimode hybrid energy storage system and its energy management strategy for electric vehicles [J]. Journal of Power Sources, 2015, 281: 432-443.

CHEN Guipeng, DENG Yan, DONG Jie, et al. Integrated multiple output synchronous buck converter for electric vehicle power supply [J]. IEEE Transactions on Vehicular Technology, 2017, 66(7): 5752-5761.

GORDILLO J, AGUILAR C. A simple sensorless current sharing technique for multiphase DC-DC buck converters [J]. IEEE Transactions on Power Electronics, 2017, 32(5): 3480-3489.

KOMURCUGIL H. Adaptive terminal sliding-mode control strategy for DC-DC buck converters [J]. ISA Transactions, 2012, 51(6): 673-681.

汪建林, 续丹, 周欢, 等. Buck变换器的自适应终端滑模控制策略 [J]. 西安交通大学学报, 2017, 51(4): 103-108.

WANG Jianlin, XU Dan, ZHOU Huan, et al. Adaptive control method of terminal sliding mode with double loop for Buck converters [J]. Journal of Xi'an Jiaotong University, 2017, 51(4): 103-108.

SHEN Liqun, LU D C, LI Chengwei. Adaptive sliding mode control method for DC-DC converters [J]. IET Power Electronics, 2015, 8(9): 1723-1732.

WANG Bin, XU Jun, WAI R J, et al. Adaptive sliding-mode with hysteresis control strategy for simple multi-mode hybrid energy storage system in electric vehicles [J]. IEEE Transactions on Industrial Electronics, 2017, 64(2): 1404-1414.

MU Chaoxu, HE Haibo. Dynamic behavior of terminal sliding mode control [J]. IEEE Transactions on Industrial Electronics, 2018, 65(4): 3480-3490.

MU Bingxian, ZHANG Kunwu, SHI Yang. Integral sliding mode flight controller design for a quadrotor and the application in a heterogeneous multi-agent system [J]. IEEE Transactions on Industrial Electronics, 2017, 64(12): 9389-9398.

王斌, 徐俊, 曹秉刚, 等. 升压型电池-超级电容复合电源的自适应滑模控制 [J]. 西安交通大学学报, 2016, 50(10): 36-41.

WANG Bin, XU Jun, CAO Binggang, et al. An adaptive sliding-mode control strategy for hybrid power sources of battery-supercapacitor with a boost converter [J]. Journal of Xi'an Jiaotong University, 2016, 50(10): 36-41.

WU Yuqiang, YU Xinghuo, MAN Zhihong. Terminal sliding mode control design for uncertain dynamic systems [J]. Systems Control Letters, 1998, 34(5): 281-287.

KOMURCUGIL H. Non-singular terminal sliding-mode control of DC-DC buck converters [J]. Control Engineering Practice, 2013, 21(3): 321-332.

WANG Junxiao, LI Shihua, YANG Jun, et al. Finite-time disturbance observer based non-singular terminal sliding-mode control for pulse width modulation based DC-DC buck converters with mismatched load disturbances [J]. IET Power Electronics, 2016, 9(9): 1995-2002.

BRANICKY M S. Multiple Lyapunov functions and other analysis tools for switched and hybrid systems [J]. IEEE Transactions on Automatic Control, 1998, 43(4): 475-482.

洪乃刚. 电力电子、电机控制系统的建模和仿真 [M]. 北京: 机械工业出版社, 2010: 120-122.

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

双闭环Buck变换器系统模糊PID控制

Buck变换器的自适应终端滑模控制策略

超临界水异常区域热力学特性研究

采用机器学习的大规模并行程序I/O性能建模与预测方法

多工况下离心压气机叶轮-机匣一体联合设计优化