基于虚功原理的流固耦合面力和位移传递方法

仲继泽 1; 谢志强 1; 沈渡 1; 徐自力 2

doi:10.7652/xjtuxb201803022

您当前的位置：

首页 >

文章列表页 >

基于虚功原理的流固耦合面力和位移传递方法

更新时间：2025-07-09

- 基于虚功原理的流固耦合面力和位移传递方法
- Load and Displacement Transfer Method Based on Virtual Work Principle for Fluid Structure Interaction
- 西安交通大学学报 2018年52卷第3期页码：160-167
- 作者机构：
  
  中国舰船研究设计中心船舶振动噪声重点实验室,武汉,430064
- 作者简介：
- 基金信息：
  
  : 2017-08-10。作者简介: 仲继泽(1990—),男,博士,工程师;徐自力(通信作者),男,教授,博士生导师。基金项目: 国家自然科学基金资助项目(51675406)
- DOI：10.7652/xjtuxb201803022
  中图分类号： O323
- 网络首发：2018-03-10，
  
  纸质出版：2018
- 稿件说明：
移动端阅览
仲继泽 1, 谢志强 1, 沈渡 1, 等. 基于虚功原理的流固耦合面力和位移传递方法[J]. 西安交通大学学报, 2018,52(3):160-167.

Load and Displacement Transfer Method Based on Virtual Work Principle for Fluid Structure Interaction[J]. 2018, 52(3): 160-167.
仲继泽 1, 谢志强 1, 沈渡 1, 等. 基于虚功原理的流固耦合面力和位移传递方法[J]. 西安交通大学学报, 2018,52(3):160-167. DOI： 10.7652/xjtuxb201803022.

Load and Displacement Transfer Method Based on Virtual Work Principle for Fluid Structure Interaction[J]. 2018, 52(3): 160-167. DOI： 10.7652/xjtuxb201803022.

摘要

为解决已有力和位移传递方法的额外插值误差问题

提出了一种能量守恒的流固耦合面力和位移传递方法。首先将结构网格、流场网格粘贴为一个整体

然后直接采用流固耦合面处流场网格节点的气动力向量作为这一整体系统的激励。提出的方法没有在结构和流场网格之间插值

所以不会引入额外的插值误差

理论分析表明

该方法能够自动满足能量守恒。采用提出的方法对弹性梁、Agard Wing 445.6颤振问题进行计算

得到的弹性梁颤振周期与文献结果偏差约为0.5%

机翼颤振流速与实验值的偏差约为1.3%

而已有的传递方法对弹性梁的计算结果与文献的偏差要比该方法高出约0.8%

对机翼的计算结果与实验值的偏差要比该方法高出约1.9%。

Abstract

To avoid the additional interpolation error of existing load and displacement transfer methods

a new load and displacement transfer method based on energy conservation is developed in this paper. The structure mesh and the flow mesh are jointed to be an integral system. Then the nodal aerodynamic force vector of the flow mesh located on the fluid structure interface is taken as the excitation force for the system. There is no numerical interpolation between the structure mesh and the flow mesh during the load and displacement transfer by the present method

so the additional interpolation error does not exist. Theoretical analysis shows that the present method is conservative in energy. Computations are performed for an elastic beam and the Agard Wing 445.6

and the calculated flutter period of the beam using the present method deviates from the reported data by 0.5% and the calculated flutter flow speed by this method for the wing 445.6 differs from the experimental data by 1.3%. While the computational deviation of the existing transfer method is 0.8% higher than that of the present method for the beam and 1.9% higher for the wing.

关键词

Keywords

references

BILLAH K Y, SCANLAN R H. Resonance, Tacoma narrows bridge failure, and undergraduate physics textbooks [J]. American Journal of Physics, 1991, 59(2): 118-124.

王俊毅, 招启军, 肖宇. 基于CFD/CSD耦合方法的新型桨尖旋翼气动弹性载荷计算 [J]. 航空学报, 2014, 35(9): 2426-2437.

WANG Junyi, ZHAO Qijun, XIAO Yu. Calculations on aeroelastic loads of rotor with advanced blade-tip based on CFD/CSD coupling method [J]. Acta Aeronautica and Astronautica Sinica, 2014, 35(9): 2426-2437.

仲继泽, 徐自力. 流固单向耦合的能量法及机翼颤振预测 [J]. 西安交通大学学报, 2017, 51(1): 109-114.

ZHONG Jize, XU Zili. Wing flutter prediction using an energy method based on one-way fluid structure coupling [J]. Journal of Xi'an Jiaotong University, 2017, 51(1): 109-114.

刘占生, 马瑞贤, 杨帆, 等. 基于流固耦合作用的柔性体流噪声降噪机理研究 [J]. 机械工程学报, 2016, 52(10): 176-184.

LIU Zhansheng, MA Ruixian, YANG Fan, et al. Study on noise reduction mechanism of flow induced noise for flexible body based on fluid-structure interaction [J]. Journal of Mechanical Engineering, 2016, 52(10): 176-184.

周岱, 李磊, 邓麟勇, 等. 流固耦合问题的网格更新与信息传递新方法 [J]. 工程力学, 2010, 27(5): 83-90.

ZHOU Dai, LI Lei, DENG Linyong, et al. Novel methods for mesh update and data transfer technique of fluid-structure interaction [J]. Engineering Mechanics, 2010, 27(5): 83-90.

DE BOER A, VAN ZUIJLENA H, BIJL H. Review of coupling methods for non-matching meshes [J]. Computer Methods in Applied Mechanics and Engineering, 2007, 196(8): 1515-1525.

安伟刚, 梁生云, 陈殿宇. 一种局部动态数据交换方法在流固耦合分析中的应用 [J]. 航空学报, 2013, 34(3): 541-546.

AN Weigang, LIANG Shengyun, CHEN Dianyu. Local dynamic data exchange in fluid structure interaction analysis [J]. Acta Aeronautica and Astronautica Sinica, 2013, 34(3): 541-546.

KIM Y H, KIM J E. New hybrid interpolation method for motion transfer in fluid-structure interactions [J]. Journal of Aircraft, 2006, 43(2): 567-569.

杨敏, 王福军, 戚兰英, 等. 流固耦合界面模型及其在水力机械动力学分析中的应用 [J]. 水利学报, 2011, 42(7): 819-825.

YANG Min, WANG Fujun, QI Lanying, et al. Fluid-structure coupling interface model and its application in dynamic analysis of hydraulic machinery [J]. Journal of Hydraulic Engineering, 2011, 42(7): 819-825.

TEZDUYAR T E. Stabilized finite element formulations for incompressible flow computations [J]. Advances in Applied Mechanics, 1991, 28: 1-44.

仲继泽, 徐自力, 陶磊. 基于虚拟弹性体的快速动网格方法 [J]. 西安交通大学学报, 2016, 50(10): 132-138.

ZHONG Jize, XU Zili, TAO Lei. An efficient dynamic mesh method based on pseudo elastic solid [J]. Journal of Xi'an Jiaotong University, 2016, 50(10): 132-138.

仲继泽, 徐自力. 采用快速动网格技术的时空同步流固耦合算法 [J]. 振动工程学报, 2017, 30(1): 41-48.

ZHONG Jize, XU Zili. Time-space synchronizing fluid structure coupling method using a fast dynamic mesh technique [J]. Journal of Vibration Engineering, 2017, 30(1): 41-48.

TUREK S, HRON J. Proposal for numerical benchmarking of fluid-structure interaction between an elastic object and laminar incompressible flow [M]. Berlin, Germany: Springer, 2006: 371-385.

YATES J E C. AGARD standard aeroelastic configurations for dynamic response: I Wing 445.6 [R]. Washington, DC, USA: NASA, 1987: 1-74.

仲继泽,徐自力.流固单向耦合的能量法及机翼颤振预测.2017,51(1):109-114.[doi:10.7652/xjtuxb201701017]

范增华,荣伟彬,王乐锋,等.压电微喷辅助液滴的多物理场耦合与实验.2016,50(11):56-61.[doi:10.7652/xjtuxb2016 11009]

仲继泽,徐自力,陶磊.基于虚拟弹性体的快速动网格方法.2016,50(10):132-138.[doi:10.7652/xjtuxb201610020]

姜涛,黄伟,王安麟.多路阀阀芯节流槽拓扑结构组合的神经网络模型.2016,50(6):36-41.[doi:10.7652/xjtuxb201606 006]

高炎,晏鑫,李军.燃气透平叶片尾缘开缝结构冷却性能的数值研究.2016,50(3):29-37.[doi:10.7652/xjtuxb201603005]

郭涛,管志成,孙光普,等.调频振子-液体联合水平减振的流固耦合机理研究.2016,50(1):28-33.[doi:10.7652/xjtuxb 201601005]

宋明毅,吴伟烽,李直.汽车空调压缩机气阀运动规律模拟.2015,49(12):144-150.[doi:10.7652/xjtuxb201512023]

季家东,葛培琪,毕文波.换热器内弹性管束流体组合诱导振动响应的数值分析.2015,49(9):24-29.[doi:10.7652/xjtuxb201509005]

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

利用能量守恒和径向基函数插值的流固耦合界面数据传递方法

微灌压力调节器调压特性流固耦合数值计算及分析

矩形微悬臂梁的流固耦合谐振频率分析

移动粒子半隐式法流固耦合模型及自由浮体数值研究

内嵌晃荡液体减振的流固耦合分析