液滴撞击不同粗糙度固体表面动力学行为实验研究

秦梦晓; 张旭辉; 汤成龙

doi:10.7652/xjtuxb201709004

您当前的位置：

首页 >

文章列表页 >

液滴撞击不同粗糙度固体表面动力学行为实验研究

更新时间：2025-07-09

- 液滴撞击不同粗糙度固体表面动力学行为实验研究
- Experimental Study on the Droplet Impact on Solid Surface with Different Roughness
- 西安交通大学学报 2017年51卷第9期页码：26-31
- 作者机构：
  
  西安交通大学动力工程多相流国家重点实验室,西安,710049
- 作者简介：
- 基金信息：
  
  : 2016-11-21。作者简介: 秦梦晓(1996—),女,本科生;汤成龙(通信作者),男,副教授。基金项目: 科学挑战专题资助项目(JCKY2016212A501);国家自然科学基金资助项目(51206131)
- DOI：10.7652/xjtuxb201709004
  中图分类号： TK402
- 网络首发：2017-09-10，
  
  纸质出版：2017
- 稿件说明：
移动端阅览
秦梦晓, 张旭辉, 汤成龙. 液滴撞击不同粗糙度固体表面动力学行为实验研究[J]. 西安交通大学学报, 2017,51(9):26-31.

Experimental Study on the Droplet Impact on Solid Surface with Different Roughness[J]. 2017, 51(9): 26-31.
秦梦晓, 张旭辉, 汤成龙. 液滴撞击不同粗糙度固体表面动力学行为实验研究[J]. 西安交通大学学报, 2017,51(9):26-31. DOI： 10.7652/xjtuxb201709004.

Experimental Study on the Droplet Impact on Solid Surface with Different Roughness[J]. 2017, 51(9): 26-31. DOI： 10.7652/xjtuxb201709004.

摘要

针对液滴撞击固体表面时动力学行为的不同影响因素

利用高速摄像技术捕捉了4种物性不同的液滴

即癸烷、十四烷、蒸馏水和无水乙醇液滴撞击不同粗糙度固体表面后的铺展与飞溅形态。探究了黏度、表面张力与实验壁面粗糙度对液滴撞击壁面后的最大铺展因数和铺展-飞溅临界韦伯数的影响。结果表明:实验流体的动力黏度越大

液滴在铺展过程中受到的阻力越大

也就越不容易铺展

相同韦伯数下的最大铺展因数越小; 表面张力越大

液滴碰壁后更有可能发生回缩。在实验过程中也观察到

只有表面张力明显大于其他工质的蒸馏水液滴在碰壁后发生了回缩。壁面越粗糙

液滴在铺展过程中需要润湿越大面积的壁面

增加了黏性耗散

且受到的阻力也更大

相同韦伯数的液滴碰壁后的最大铺展因数也越小。对Laan的公式进行了粗糙度的补充

得到了最大铺展因数与韦伯数、雷诺数及粗糙度的关系。壁面粗糙度对液滴铺展后的边缘造成扰动

使液滴更容易发生飞溅

铺展-飞溅的临界韦伯数随着壁面粗糙度的增加而减小

且壁面粗糙度对小奥内佐格数流体的临界韦伯数影响更大。

Abstract

The impact dynamics of droplets of different liquids onto solid surfaces with different roughness was investigated by using the high-speed microphotography. The influences of viscosity

surface tension and surface roughness on the non-dimensional maximum spreading diameter and the critical Weber number for transition from spreading to splashing were discussed. The results showed that the non-dimensional maximum spreading diameter decreases with the increasing liquid viscosity

and higher surface tension makes droplet more possible to retract after impacting on the solid surface. It was also observed that water is the only liquid that retracts in the experiment since it has obviously higher surface tension than other three liquids. The droplet needs to wet larger surface and will have higher viscous dissipation with the increase of surface roughness

leading to the decrease of the maximum spreading diameter at the same Weber number. The relationship of the maximum spreading diameter with Weber number

Ohnesorge number and surface roughness was obtained by introducing surface roughness to Laan's equation. The “finger-like” disturbance around the rim becomes more obvious with the increase of surface roughness

which makes the droplet more likely to splash after impact onto the solid surface and leads to lower critical Weber number for transition from spreading to splashing. In addition

the surface roughness influences the critical Weber number more significantly for the liquids with smaller Ohnesorge number.

关键词

Keywords

references

WORTHINGTON A M. On the forms assumed by drops of liquids falling vertically on a horizontal plate [J]. Proceedings of the Royal Society of London, 1876, 25(171/178): 261-271.

YARIN A L, WEISS D A. Impact of drops on solid surfaces: self-similar capillary waves, and splashing as a new type of kinematic discontinuity [J]. Journal of Fluid Mechanics, 1995, 283(283): 141-173.

RIOBOO R, TROPEA C, MARENGO M. Outcomes from a drop impact on solid surfaces [J]. Atomization and Sprays, 2001, 11(2): 155-165.

陆军军, 陈雪莉, 曹显奎, 等. 液滴撞击平板的铺展特征 [J]. 化学反应工程与工艺, 2007, 23(6): 506-511.

LU Junjun, CHEN Xueli, CAO Xiankui, et al. Characteristic phenomenon and analysis of a single liquid droplet impacting on dry surfaces [J]. Chemical Reaction Engineering and Technology, 2007, 23(6): 506-511.

RANGE K, FEUILLEBOIS F. Influence of surface roughness on liquid drop impact [J]. Journal of Colloid and Interface Science, 1998, 203(1): 16-30.

魏明锐, 刘明嘉, 颜伏伍, 等. 液滴平壁铺展过程分析 [J]. 内燃机学报, 2012, 30(6): 538-543.

WEI Mingrui, LIU Mingjia, YAN Fuwu, et al. Analysis of spreading process of droplet on flat surface [J]. Transactions of CSICE, 2012, 30(6): 538-543.

SCHELLER B L, BOUSFIELD D W. Newtonian drop impact with a solid surface [J]. AIChE J, 1995, 41(6): 1357-1367.

CLANET C, BÉGUIN C, RICHARD D, et al. Maximal deformation of an impacting drop [J]. Fluid Mech, 2004, 517(517): 199-208.

UKIWE C, KWOK D. On the maximum spreading diameter of impacting droplets on well-prepared solid surfaces [J]. Langmuir, 2005, 21(2): 666-673.

曾祥辉, 杨方, 齐乐华, 等. 液滴喷射过程中碰撞的形态及流畅模拟分析 [J]. 西北工业大学学报, 2007, 25(4): 528-532.

ZENG Xianghui, YANG Fang, QI Lehua, et al. Simulation of the shape and flow field of a droplet after impacting a substrate [J]. Journal of Northwestern Polytechnical University, 2007, 25(4): 528-532.

JOSSERAND C, THORODDSEN S T. Drop impact on a solid surface [J]. Annual Review of Fluid Mechanics, 2016, 48(1): 365-391.

LAAN N, DE BRUIN K G, BARTOLO D, et al. Maximum diameter of impacting liquid droplets [J]. Phys Rev, 2014, 2(4): 044018.

马志豪,贾义,李智博,等.单滴燃料高压着火与燃烧特性的试验研究.2017,51(5):95-101.[doi:10.7652/xjtuxb201705 014]

阮一逍,薛绒,赖欢,等.单液氮液滴在气流中的蒸发运动特性研究.2017,51(6):147-152.[doi:10.7652/xjtuxb201706023]

范增华,荣伟彬,王乐锋,等.压电微喷辅助液滴的多物理场耦合与实验.2016,50(11):56-61.[doi:10.7652/xjtuxb2016 11009]

李耀庭,黄勇成,孟凡胜,等.增压直喷汽油机中润滑油液滴诱发早燃机制的数值研究.2016,50(7):51-57.[doi:10.7652/xjtuxb201607009]

张彬,郭朋华,李景银.液滴与水平壁面碰撞力的实验方法.2015,49(11):8-13.[doi:10.7652/xjtuxb201511002]

孙皖,牛璐,赖天伟,等.氮气在缩放喷管中非平衡自发凝结的数值研究.2015,49(4):130-133.[doi:10.7652/xjtuxb 201504021]

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

相对浸润性对双元液滴碰撞影响的数值研究

液滴撞击弹性悬臂梁行为的全拉格朗日数值方法

低冲击能量液滴与球面碰撞沉积特性的数值研究

高温燃气中单个液滴的蒸发特性

应用改进粒子水平集法对液滴碰撞的数值研究