多通道烘缸水平矩形管内冷凝换热特性及流型

严彦 1; 董继先 1; 高秀峰 2

doi:10.7652/xjtuxb201704018

您当前的位置：

首页 >

文章列表页 >

多通道烘缸水平矩形管内冷凝换热特性及流型

更新时间：2025-07-09

- 多通道烘缸水平矩形管内冷凝换热特性及流型
- Heat Transfer Characteristics of Condensation and Flow Regime in Horizontal Rectangle Channel of Multi-Channel Cylinder Dryer
- 西安交通大学学报 2017年51卷第4期页码：116-121
- 作者机构：
  
  陕西科技大学机电工程学院,西安,710021
- 作者简介：
- 基金信息：
  
  : 2016-08-28。作者简介: 严彦(1988—),女,博士生;董继先(通信作者),男,教授,博士生导师。基金项目: 国家自然科学基金资助项目(51375286)
- DOI：10.7652/xjtuxb201704018
  中图分类号： TK124
- 网络首发：2017-04-10，
  
  纸质出版：2017
- 稿件说明：
移动端阅览
严彦 1, 董继先 1, 高秀峰 2. 多通道烘缸水平矩形管内冷凝换热特性及流型[J]. 西安交通大学学报, 2017,51(4):116-121.

Heat Transfer Characteristics of Condensation and Flow Regime in Horizontal Rectangle Channel of Multi-Channel Cylinder Dryer[J]. 2017, 51(4): 116-121.
严彦 1, 董继先 1, 高秀峰 2. 多通道烘缸水平矩形管内冷凝换热特性及流型[J]. 西安交通大学学报, 2017,51(4):116-121. DOI： 10.7652/xjtuxb201704018.

Heat Transfer Characteristics of Condensation and Flow Regime in Horizontal Rectangle Channel of Multi-Channel Cylinder Dryer[J]. 2017, 51(4): 116-121. DOI： 10.7652/xjtuxb201704018.

摘要

为研究多通道烘缸内蒸汽的冷凝换热特性

提高烘缸干燥效率

降低造纸工业能耗

采用可视化方法对多通道烘缸中的单边换热水平矩形管内蒸汽冷凝现象进行了观测实验。实验观察到了环状流、波状流、弹状流以及塞状流4种流型。实验结果表明:当质量流率较小时

小干度下流型主要为塞状流和弹状流

随着干度的增大

流型转变为波状流; 当质量流率较大时

即使小干度下流型仍主要为波状流和环状流

冷凝过程无塞状流和弹状流出现。经比较

Tandon流型图可较好地预测实验观察到的流型。此外

当质量流率较小(G

35 kg?m

-2

-1

)时

换热系数受质量流率和干度影响较小; 随着质量流率增大

换热系数受质量流率和干度的影响变大

且随着质量流率和干度的增大而增大。最后

将实验值与传统经验关联式计算值进行了对比

发现Cavallini的关联式能较好地预测该实验结果。

Abstract

The phenomenon of steam condensation within a horizontal rectangle channel with one-side cooling in multi-channel cylinder dryer is experimentally studied to investigate the characteristics of steam condensing in the multi-channel cylinder dryer

to improve the efficiency and to reduce the energy consumption of paper industry. Experiments are conducted via the visualization method under the quality of 0.2-0.8 and mass flux of 20-50 kg?m

-2

-1

. Four flow patterns

including annular

wave

slug and plug flows

are observed. The slug flow

plug flow and wave flow are observed at low mass flux

the wave flow and annular flow are observed at high mass flux with

a low steam quality

while the slug and plug flows are not found during the entire condensation process. It is found that the observed flow patterns agree well with Tandon's flow pattern map. The effects of quality and mass flux on condensing heat transfer are analyzed. The experimental results show that the effect of low mass flux(G

35 kg?m

-2

-1

)on condensing heat transfer coefficient can be ignored

and the condensing heat transfer coefficient increases obviously with increasing quality and high mass flux. Four kinds of correlations are employed to predict the coefficients of condensing heat transfer

and the result reveals that Cavallini's correlation agrees with the experimental results relatively well.

关键词

Keywords

references

CHOI S U S, YU W, FRANCE D M. A novel multiport cylinder dryer [J]. TAPPI Journal, 2001, 84(2): 1-15.

HALL D B, MONROE J F, TIMM G L. Application of stationary and rotary siphons [J]. TAPPI Journal, 1993, 76(8): 97-105.

WANG J C Y, QIU L J, WANG S F. Enhanced condensation inside a horizontal rotating drum-drier [J]. Drying Technology, 1990, 8(4): 829-843.

HALL D B, MONROE J F, TIMM G L. Application of stationary and rotary siphons [J]. TAPPI Journal, 1993, 76(8): 97-105.

APPEL D W, HONG S H. Optimizing heat-transfer using bars in dryers [J]. Paper Technology and Industry, 1975, 16(4): 264-269.

CHINNOV E A, RONSHIN F V, KABOV O A. Two-phase flow patterns in short horizontal rectangular microchannels [J]. International Journal of Multiphase Flow, 2015, 80(4): 57-68.

JEONG S S, MOO H K. An experimental study of flow condensation heat transfer inside circular and rectangular mini-channels [J]. Heat Transfer Engineering, 2005, 26(3): 36-44.

SONG Weiming, MENG Jian, ZHI Xin. Optimization of flue gas convective heat transfer with condensation in a rectangular channel [J]. Chinese Science Bulletin, 2011, 56(3): 263-268.

GUO Zhongyu, ANAND N K. Condensation of R-410A in a rectangular channel [J]. Hvac R Research, 2000, 5(5): 97-122.

KOSKY P G, STAUB F W. Local condensing heat transfer coefficients in the annular flow regime [J]. Aiche Journal, 1971, 17(5): 1037-1043.

BOYKO L D, KRUZHILIN G N. Heat transfer and hydraulic resistance during condensation of steam in a horizontal tube and in a bundle of tubes [J]. International Journal of Heat and Mass Transfer, 1967, 10(3): 361-373.

JUNG P K, YOUNG L K, DONGSOO J. Flow condensation heat transfer coefficients of R22, R410A and propane in aluminum multi-channel tube [J]. International Journal of Multiphase Flow, 2005, 17(7): 628-635.

杨英英, 李敏霞, 马一太. 水平光滑细管内R32冷凝换热的流型特性 [J]. 化工学报, 2014, 65(2): 445-452.

YANG Yingying, LI Minxia, MA Yitai. Characteristics of flow pattern for condensation heat transfer of R32 in horizontal small tube [J]. CIESC Journal, 2014, 65(2): 445-452.

SON C H, LEE H S. Condensation heat transfer characteristics of R-22, R-134a and R-410A in small diameter tubes [J]. Heat and Mass Transfer, 2009, 45(9): 1153-1166.

MANDHANE J M, GREGORY G A, AZIZ K. A flow pattern map for gas-liquid flow in horizontal pipes [J]. International Journal of Multiphase Flow, 1974, 1(4): 537-553.

TANDON T N, VARMA H K, GUOTA C P. Prediction of flow patterns during condensation of binary mixtures in a horizontal tube [J]. Journal of Heat Transfer, 1985, 107(2): 424-430.

TANDON T N, VARMA H K, GUPTA C P. Heat transfer during forced convection condensing inside horizontal tube [J]. International Journal of Refrigeration, 1995, 18(3): 210-214.

SHAH M M. A general correlation for heat transfer during film condensation inside pipes [J]. International Journal of Heat and Mass Transfer, 1979, 22(4): 547-556.

DOBSON M K, CHATO J C. Condensation in smooth horizontal tubes [J]. ASME Journal of Heat Transfer, 1998, 120(1): 193-213.

JUNG D, SONG K H, CHOI Y. Flow condensation heat transfer coefficients of pure refrigerants [J]. International Journal of Refrigeration, 2003, 26(1): 4-11.

CAVALLINI A, DAVIDE D C, DORETTI L. Condensation in horizontal smooth tubes: a new heat transfer model for heat exchanger design [J]. Heat Transfer Engineering, 2006, 27(8): 31-38.

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

压缩空气储能储气装置充气过程的动态热力特性研究

超临界流体换热可视化实验研究进展

水-酒精混合蒸气在竖直管外凝结特性的研究

轴向旋转通道内浮升力对湍流影响的直接模拟

全气膜冷却叶片表面换热系数和冷却效率研究