燃机透平静叶尾缘柱肋通道内的汽雾/空气冷却流动与换热特性数值研究

周子杰; 王新军; 费昕阳

doi:10.7652/xjtuxb201611004

您当前的位置：

首页 >

文章列表页 >

燃机透平静叶尾缘柱肋通道内的汽雾/空气冷却流动与换热特性数值研究

更新时间：2025-07-09

- 燃机透平静叶尾缘柱肋通道内的汽雾/空气冷却流动与换热特性数值研究
- Numerical Investigation for Flow and Heat Transfer Characteristics of Air and Air/Mist Cooling in Gas Turbine Stator Trail Edge Path
- 西安交通大学学报 2016年50卷第11期页码：21-27
- 作者机构：
  
  西安交通大学能源与动力工程学院,西安,710049
- 作者简介：
- 基金信息：
- DOI：10.7652/xjtuxb201611004
  中图分类号： TK47
- 网络首发：2016-11-10，
  
  纸质出版：2016
- 稿件说明：
移动端阅览
周子杰, 王新军, 费昕阳. 燃机透平静叶尾缘柱肋通道内的汽雾/空气冷却流动与换热特性数值研究[J]. 西安交通大学学报, 2016,50(11):21-27.

Numerical Investigation for Flow and Heat Transfer Characteristics of Air and Air/Mist Cooling in Gas Turbine Stator Trail Edge Path[J]. 2016, 50(11): 21-27.
周子杰, 王新军, 费昕阳. 燃机透平静叶尾缘柱肋通道内的汽雾/空气冷却流动与换热特性数值研究[J]. 西安交通大学学报, 2016,50(11):21-27. DOI： 10.7652/xjtuxb201611004.

Numerical Investigation for Flow and Heat Transfer Characteristics of Air and Air/Mist Cooling in Gas Turbine Stator Trail Edge Path[J]. 2016, 50(11): 21-27. DOI： 10.7652/xjtuxb201611004.

摘要

基于通过提高燃气进口温度来提升燃气轮机热效率和增加出力的思想

采用ANSYS-CFX商用软件对模化的燃气轮机透平静叶尾缘楔形柱肋冷却通道中流动与换热特性进行了数值模拟

对比研究了冷却工质为空气和汽雾/空气时的冷却性能

以及不同的雷诺数和雾滴初始直径下雾滴在流动过程中的分布、努塞尔数、摩擦系数以及热力综合效率的变化情况。研究表明:雾滴初始直径越大、雷诺数越大

雾滴的流动距离越长; 相同雷诺数条件下

相对于空气冷却

加入不同初始直径的雾滴可提高通道底面平均努塞尔数

换热效果强化越明显; 底面平均努塞尔数的增幅与雷诺数和雾滴初始直径有关

为了达到最佳冷却效果

应考虑雾滴蒸发吸热和扰流两方面的影响; 在冷却空气中加入雾滴后流动摩擦系数变化较小

综合考虑换热性能与流动阻力

加入汽雾可使热力综合效率最高提高26%。该结果可为燃机设计提供参考。

Abstract

Increasing the turbine inlet temperature is a feasible method to improve the cycle thermal efficiency and power output of a gas turbine. The heat transfer and flow characteristics of air and air/mist cooling in the trail edge path of a gas turbine stator are numerically investigated with ANSYS-CFX. The simulations for different working fluids(air and air/mist)are carried out to find their cooling performance difference. The changes of mist distribution

Nusselt number

flow friction factor and thermodynamic efficiency are analyzed in the cases of different Reynolds number and different initial diameter of mist. The results show that the mist flow distance goes up when Reynolds number and mist initial diameter increase. At the same Reynolds number

the bottom averaged Nusselt number increases when spraying mist with different initial diameter into cooling air. The enhancement of the bottom averaged Nusselt number is related to Reynolds number and the initial mist diameter. To reach the highest cooling performance

the evaporating and disturbance effects of mist ought to be taken into consideration. Spraying mist into cooling air slightly affects the friction factor

but the increase of thermodynamic efficiency can reach up to 26% considering both heat transfer and flow friction.

关键词

Keywords

references

张效伟, 朱惠人. 大型燃气涡轮叶片冷却技术 [J]. 热能动力工程, 2008, 23(1): 1-6.

ZHANG Xiaowei, ZHU Huiren. Blade cooling technology of heavy-duty gas turbines [J]. Journal of Engineering for Thermal Energy and Power, 2008, 23(1): 1-6.

GUO T, WANG T, GADDIS J L. Mist/steam cooling in a heated horizontal tube: part 1 Experimental system [J]. ASME Journal of Turbomachinery, 2000, 122(2): 360-365.

HWANG J J, LIU C C. Measurement of endwall heat transfer and pressure drop in a pin-fin wedge duct [J]. International Journal of Heat and Mass Transfer, 2002, 45: 877-889.

METZGER D E, BERRY R A, BRONSON J P. Developing heat transfer in rectangular ducts with staggered arrays of short pin fins: 81-WA/HT-6 [R]. New York, USA: ASME, 1981.

RAGAB R, WANG T. An investigation of applicability of transporting water mist for cooling turbine vanes [C]∥ASME 2014 Turbine Technical Conference and Exposition. New York, USA: ASME, 2014: V05AT 12A021.

ZHAO L, WANG T. An experimental study of mist/air film cooling on a flat plate with application to gas turbine airfoils: part I Heat transfer [J]. ASME Journal of Turbomachinery, 2013, 136(7): V03BT 13A014.

ZHAO L, WANG T. An experimental study of mist/air film cooling on a flat plate with application to gas turbine airfoils: part 2 Two-phase flow measurements and droplet dynamics [J]. ASEM Journal of Turbomachinery, 2013, 136(136): V03BT13A015.

LIAO G, WANG X, LI J, et al. A numerical comparison of thermal performance of in-line pin-fins in a wedge duct with three kinds of coolant [J]. International Journal of Heat and Mass Transfer, 2014, 77(3): 1033-1042.

GUO T, WANG T, GADDIS J L. Mist/steam cooling in a heated horizontal tube: part 2 Results and modeling [J]. ASME Journal of Turbomachinery, 2000, 122(2): 366-374.

史晓军, 税琳棋, 陶小兵, 等. 叶片内冷通道中采用汽雾换热或蒸汽换热的实验研究 [J]. 中国电机工程学报, 2015(12): 3061-3067.

SHI Xiaojun, SHUI linqi, TAO Xiaobing, et al. Heat transfer experimental investigation of mist/steam or steam within gas turbine blade internal cooling passage [J]. Proceedings of the CSEE, 2015(12): 3061-3067.

张峰, 王新军, 李军. 带肋U型通道中的汽雾/空气流动与换热数值研究 [J]. 西安交通大学学报, 2015, 49(9): 52-57.

ZHANG Feng, WANG Xinjun, LI Jun. Numerical investigation for flow and heat transfer characteristics of air/mist coolant in ribbed two-pass channel [J]. Journal of Xi'an Jiaotong University, 2015, 49(9): 52-57.

CHANG S W, LEES A W. Endwall heat transfer and pressure drop in scale-roughened pin-fin channels [J]. International Journal of Thermal Sciences, 2010, 49(4): 702-713.

WACHTERS L H J, WESTERLING N A J. The heat transfer from a hot wall to impinging water drops in the spheroidal state [J]. Chemical Engineering Science, 1966, 21(11): 1047-1056.

ELWEKEEL F N M, ZHENG Q, ABDALA A M M. Air/mist cooling in a rectangular duct with varying shapes of ribs [J]. ARCHIVE Proceedings of the Institution of Mechanical Engineers: Part C Journal of Mechanical Engineering Science, 2013, 228(11): 1925-1935.

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

低雷诺数对透平叶片间隙泄漏流动影响的研究

液氢管路输运中静电积聚机理与电流密度分布特征研究

面向燃气轮机氨氢融合燃料的氨催化裂解研究

X射线辐照下聚酰亚胺材料空间电荷分布特性的数值模拟

气膜孔缺陷对冷却性能影响不确定性量化研究