不同堆积结构颗粒床内的流动特性研究

李良星; 邹旭毛; 孔刘波

doi:10.7652/xjtuxb201609008

您当前的位置：

首页 >

文章列表页 >

不同堆积结构颗粒床内的流动特性研究

更新时间：2025-07-09

- 不同堆积结构颗粒床内的流动特性研究
- Investigation on the Flow Characteristics in Particulate Beds with Different Packing Structures
- 西安交通大学学报 2016年50卷第9期页码：49-54
- 作者机构：
  
  西安交通大学动力工程多相流国家重点实验室,西安,710049
- 作者简介：
- 基金信息：
  
  : 2016-01-11。作者简介: 李良星(1979—),男,副教授。基金项目: 国家自然科学基金资助项目(51406143);陕西省自然科学基础研究计划资助项目(2015JM5237)
- DOI：10.7652/xjtuxb201609008
  中图分类号： TK124
- 网络首发：2016-09-10，
  
  纸质出版：2016
- 稿件说明：
移动端阅览
李良星, 邹旭毛, 孔刘波. 不同堆积结构颗粒床内的流动特性研究[J]. 西安交通大学学报, 2016,50(9):49-54.

Investigation on the Flow Characteristics in Particulate Beds with Different Packing Structures[J]. 2016, 50(9): 49-54.
李良星, 邹旭毛, 孔刘波. 不同堆积结构颗粒床内的流动特性研究[J]. 西安交通大学学报, 2016,50(9):49-54. DOI： 10.7652/xjtuxb201609008.

Investigation on the Flow Characteristics in Particulate Beds with Different Packing Structures[J]. 2016, 50(9): 49-54. DOI： 10.7652/xjtuxb201609008.

摘要

为了研究不同堆积结构颗粒床内的流动特性

使用两种尺寸球形颗粒构建了均匀混合堆积结构和分层堆积结构床

在碎片床冷却性实验装置(DEBECO

DEbris BEd COolability)上进行了单相和两相流动实验。基于实验结果

对比分析了两种堆积结构的流动阻力压降

进一步验证了流动阻力模型。实验结果表明:对于不同尺寸颗粒均匀混合的堆积颗粒床

其有效直径在低速(Re

7)条件下更接近面积平均直径; 随着速度(Re

>7)升高

其有效直径更接近长度平均直径。当气液两相同向向上流过均匀堆积结构颗粒床时

实验测量的两相压降总体上与Reed模型预测值较为接近; 与均匀堆积结构床相比

相同颗粒分层堆积结构床内的两相流动阻力压降较低。该实验研究结果对完善多孔介质结构内流动阻力分析具有重要的学术意义。

Abstract

To investigate the flow characteristics in particulate beds with different packing structures

the experiments on flow characteristics of particulate homogeneous and stratified beds consisting of two kinds of spherical particles were performed on the test facility of DEBECO(DEbris BEd COolability). Based on the experimental results

the pressure drops were compared and analyzed

and the flow resistance models were further verified. The experimental results showed that the effective diameter is closer to the area mean diameter at low flow rates(Re

7)for a bed packed with uniform mixture of particles

but more closer to the length mean diameter with increasing flow rates(Re

>7). For gas-water cocurrent flo

w through a homogeneous bed

the predictions of Reed's model were more comparable with the measured pressure drops. Compared with the homogeneous bed filled with the same particles

the stratified bed showed a lower flow resistance. The experimental results may contribute to the analysis of flow resistance in porous media.

关键词

Keywords

references

HOLDICH R G. Fundamentals of particle technology [M]. Leicestershire, UK: Midland Information Technology and Publishing, 2002: 1-4.

JAMIALAHMADI M, MULLER-STEINHAGEN H, IZADPANAH M. Pressure drop, gas hold-up and heat transfer during single and two-phase flow through porous media [J]. International Journal of Heat and Fluid Flow, 2005, 26(1): 156-172.

BEAR J. 多孔介质流体动力学 [M]. 李竞生, 等译. 北京: 中国建筑工业出版社, 1983: 1-18.

杜新龙, 低渗透砂岩油层微流动机理研究 [D]. 成都: 西南石油大学, 2012.

闫晓, 肖泽军, 黄彦平. 多孔介质中流动换热特性的研究进展 [J]. 核动力工程, 2006, 27(1): 77-82.

YAN Xiao, XIAO Zejun, HUANG Yanping. Research progress on flow and heat transfer in porous media [J]. Nuclear Power Engineering, 2006, 27(1): 77-82.

BAI B, LIU M, LV X, et al. Correlations for predicting single phase and two-phase flow pressure drop in pebble bed flow channels [J]. Nuclear Engineering and Design, 2011, 241(12): 4767-4774.

KARBOJIAN A, MA W M, KUDINOV P, et al. A scoping study of debris bed formation in the DEFOR test facility [J]. Nuclear Engineering and Design, 2009, 239: 1653-1659.

MAGALLON D. Characteristics of corium debris bed generated in large-scale fuel-coolant interaction experiments [J]. Nuclear Engineering and Design, 2006, 236: 1998-2009.

NAYAK A K, SEHGAL B R, STEPANYAN A V. An experimental study on quenching of a radially stratified heated porous bed [J]. Nuclear Engineering and Design, 2006, 236(19/20/21): 2189-2198.

THAKRE S, LI L, MA W. An experimental study on coolability of a particulate bed with radial stratification or triangular shape [J]. Nuclear Engineering and Design, 2014, 276: 54-63.

ERGUN S. Fluid flow through packed columns [J]. Chemical Engineering Progress, 1952, 48(2): 89-94.

LIPINSKI R J. A one dimensional particle bed dryout model [J]. ANS Transactions, 1981, 38: 386-387.

REED A W. The effect of channeling on the dryout of heated particulate beds immersed in a liquid pool [D]. Cambridge, USA: Massachusetts Institute of Technology, 1982.

HU K, THEOFANOUS T G. On the measurement and mechanism of dryout in volumetrically heated coarse particle beds [J]. International Journal of Multiphase Flow, 1991, 17(4): 519-532.

SCHULENBERG T, MÜLLER U. An improved model for two-phase flow through beds of course particles [J]. International Journal of Multiphase Flow, 1987, 13(1): 87-97.

李良星, 李会雄. 多尺寸颗粒堆积多孔介质床有效直径研究 [J]. 工程热物理学报, 2014, 35(9): 1785-1788.

LI Liangxing, LI Huixiong. An study on effective diameter of packed porous media bed with multi-size particles [J]. Journal of Engineering Thermophysics, 2014, 35(9): 1785-1788.

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

分层结构颗粒堆积床内的流动阻力特性

不同容积流量下汽轮机低压缸末三级定常流动数值研究

某新型蒸汽脉冲式声频清灰装置的流场分析

接收孔周向倾角对预旋转静盘腔流动特性的影响

烟气挡板流动特性的数值模拟