球凹平板冲击冷却性能的数值研究及结构改进

张峰; 王新军; 李军

doi:10.7652/xjtuxb201601019

您当前的位置：

首页 >

文章列表页 >

球凹平板冲击冷却性能的数值研究及结构改进

更新时间：2025-07-09

- 球凹平板冲击冷却性能的数值研究及结构改进
- Numerical Investigation on the Impingement Cooling Performance and Structural Improvement of Dimpled Plates
- 西安交通大学学报 2016年50卷第1期页码：124-130
- 作者机构：
  
  西安交通大学能源与动力工程学院,西安,710049
- 作者简介：
- 基金信息：
- DOI：10.7652/xjtuxb201601019
  中图分类号： TK263
- 网络首发：2016-01-10，
  
  纸质出版：2016
- 稿件说明：
移动端阅览
张峰, 王新军, 李军. 球凹平板冲击冷却性能的数值研究及结构改进[J]. 西安交通大学学报, 2016,50(1):124-130.

Numerical Investigation on the Impingement Cooling Performance and Structural Improvement of Dimpled Plates[J]. 2016, 50(1): 124-130.
张峰, 王新军, 李军. 球凹平板冲击冷却性能的数值研究及结构改进[J]. 西安交通大学学报, 2016,50(1):124-130. DOI： 10.7652/xjtuxb201601019.

Numerical Investigation on the Impingement Cooling Performance and Structural Improvement of Dimpled Plates[J]. 2016, 50(1): 124-130. DOI： 10.7652/xjtuxb201601019.

摘要

采用SST湍流模型数值研究了球凹平板冲击冷却的流动与换热特性

分析了4种球凹布置形式对带有最大横向流的冲击冷却性能的影响

提出了球凹布置的改进结构。研究表明:球凹结构对气流压力损失的影响很小

展向偏移布置和叉排布置的球凹能够增大通道对称面和下游的湍动能

顺排布置和流向偏移布置的球凹使通道中心处的湍动能降低; 展向偏移布置和叉排布置的球凹平板换热效果最好

其次是平板

然后是顺排布置的球凹平板

流向偏移布置的球凹平板换热效果最差; 在通道上游

展向偏移布置的球凹表面换热效果优于叉排布置

而通道下游的趋势正好相反。综合展向偏移布置和叉排布置的球凹表面换热优点

布置新的球凹排列方式

改进布置的球凹表面换热效果与预期的效果相吻合; 通道底面的换热效果基本不受球凹沿对称面的布置位置的影响。

Abstract

The flow and heat transfer characteristics of impingement cooling on dimpled plates were numerically investigated using SST turbulence model. The effect of four types of dimple arrangements on the impingement cooling performance with maximum crossflow was analyzed and the structural improvement of dimple plates was performed. The results show that the effect of dimple structure on the pressure loss is small. The turbulent kinetic energy acting on the symmetry wall and downstream of channel can be enhanced by the span-wise shifted arrangement and staggered arrangement; while for in-line arrangement and stream-wise shifted arrangement

the turbulent kinetic energy acting on the channel center is reduced. The heat transfer performance for the span-wise shifted arrangement and staggered arrangement is the best

then followed by flat plate

in-line arrangement and stream-wise shifted arrangement. In the upstream of channel

the Nusselt number on the dimpled surface for span-wise shifted arrangement is larger than that for staggered arrangement

while the trend is reversed in the downstream of channel. Considering the heat transfer enhancement on dimpled surface for span-wise shifted arrangement and staggered arrangement

a new dimple arrangement is performed

and the heat transfer performance of dimpled surface for improved arrangement can achieve the desired results. The heat transfer performance on the channel's bottom wall is not significantly dependent on the dimple arrangement along the symmetrical plane.

关键词

Keywords

references

WEIGAND B, SPRING S. Multiple jet impingement: a review [J]. Heat Transfer Research, 2011, 42(2): 101-142.

XING Y, SPRING S, WEIGAND B. Experimental and numerical investigation of heat transfer characteristics of inline and staggered arrays of impinging jets [J]. ASME Journal of Heat Transfer, 2010, 132(9): 092201.

XING Y, SPRING S, WEIGAND B. Experimental and numerical investigation of impingement heat transfer on a flat and micro-rib roughened plate with different crossflow schemes [J]. International Journal of Thermal Sciences, 2011, 50(7): 1293-1307.

MILLER N, SIW S C, CHYU M K, et al. Effects of jet diameter and surface roughness on internal cooling with single array of jets [C]∥Proceedings of ASME Turbo Expo 2013. New York, USA: ASME, 2013: 95400.

KANOKJARUVIJIT K, MARTINEZ-BOTAS R F. Jet impingement on a dimpled surface with different crossflow schemes [J]. International Journal of Heat and Mass Transfer, 2005, 48(1): 161-170.

KANOKJARUVIJIT K, MARTINEZ-BOTAS R F. Heat transfer and pressure investigation of dimple impingement [J]. ASME Journal of Turbomachinery, 2008, 130(1): 011003.

XING Y, WEIGAND B. Experimental investigation of impingement heat transfer on a flat and dimpled plate with different crossflow schemes [J]. International Journal of Heat and Mass Transfer, 2010, 53(19): 3874-3886.

张靖周, 李永康, 谭晓茗, 等. 阵列射流冲击冷却局部对流换热特性的数值计算与实验研究 [J]. 航空学报, 2004, 25(4): 339-342.

ZHANG Jingzhou, LI Yongkang, TAN Xiaoming, et al. Numerical computation and experimental investigation on local convective heat transfer characteristics for jet array impingement [J]. Acta Aeronautica et Astronautica Sinica, 2004, 25(4): 339-342.

刘钊, 丰镇平, 宋立明. 实际叶片前缘冲击冷却流动和换热的数值研究 [J]. 西安交通大学学报, 2011, 45(1): 5-9.

LIU Zhao, FENG Zhenping, SONG Liming. Numerical study on flow and heat transfer of impingement cooling on leading edge of actual turbine blade [J]. Journal of Xi'an Jiaotong University, 2011, 45(1): 5-9.

CHO H H, RHEE D H. Local heat/mass transfer measurement on the effusion plate in impingement/effusion cooling systems [J]. ASME Journal of Turbomachinery, 2001, 123(3): 601-608.

季家东,葛培琪,毕文波.换热器内弹性管束流体组合诱导振动响应的数值分析.2015,49(9):24-29.[doi:10.7652/xjtuxb201509005]

周俊安,刘立军,肖萍,等.带叶片扩压器离心压缩机模型级内流研究.2015,49(9):30-35.[doi:10.7652/xjtuxb201509 006]

王伟,曹军义,林京,等.一种非线性双稳态人体运动能量俘获技术.2015,49(8):58-63.[doi:10.7652/xjtuxb201508010]

褚坤明,王家序,蒲伟,等.混合润滑状态下滤波减速器的啮合冲击分析与修形方法.2015,49(7):140-148.[doi:10.7652/xjtuxb201507023]

王世柱,李志刚,李军,等.补汽对透平级气动性能和静叶汽封转子动力特性影响的数值模拟.2015,49(5):56-61.[doi:10.7652/xjtuxb201505009]

曾立飞,刘观伟,毛靖儒,等.调节阀内流型分布及利用声音突变判别流型转变的方法.2015,49(5):116-121.[doi:10.7652/xjtuxb201505018]

李兴文,晁攸闯,吴坚,等.水中金属丝电爆炸冲击波一维数值模拟.2015,49(4):1-5.[doi:10.7652/xjtuxb201504001]

刘小民,赵嘉,李典.单圆弧等厚叶片前后缘多元耦合仿生设计及降噪机理研究.2015,49(3):1-10.[doi:10.7652/xjtuxb 201503001]

刘小民,李烁.仿鸮翼前缘蜗舌对多翼离心风机气动性能和噪声的影响.2015,49(1):14-20.[doi:10.7652/xjtuxb201501 003]

于渤,韩宾,倪长也,等.空心及PMI泡沫填充铝波纹夹芯梁冲击性能实验研究.2015,49(1):86-91.[doi:10.7652/xjtuxb201501014]

陈洁,郭洁,邱爱慈,等.特快波前下金属氧化物电阻片伏安特性试验研究.2014,48(10):54-59.[doi:10.7652/xjtuxb 201410009]

蒋进科,方宗德,苏进展.宽斜齿轮多目标修形优化设计.2014,48(8):91-97.[doi:10.7652/xjtuxb201408016]

闵为,冀宏,王峥嵘,等.单级压力调节阀的阻尼孔射流响应特性分析.2014,48(6):80-85.[doi:10.7652/xjtuxb201406 014]

张超,徐自力,刘石,等.采用热固双向耦合模型的转子热应力计算方法研究.2014,48(4):68-72.[doi:10.7652/xjtuxb 201404012]

冯斌,梅雪松,杨军,等.数控机床摩擦误差自适应补偿方法研究.2013,47(11):65-69.[doi:10.7652/xjtuxb201311012]

张健,赵桂平,卢天健.泡沫金属在冲击载荷下的能量吸收特性.2013,47(11):105-112.[doi:10.7652/xjtuxb201311019]

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

带肋曲面双层壁偏转内流与传热冷却特性数值研究

曲面双层壁结构的内外复合流动及综合冷却特性数值研究

带肋曲面双层壁偏转内流与传热冷却特性数值研究

燃气透平冲击冷却的射流孔形状优化方法及验证

气膜抽吸作用下透平叶片冲击冷却的一维管网计算方法研究