汽油机部分负荷应用热废气再循环实现临界爆震的性能优化

韩林沛 1; 洪伟 1; 王建军 2; 苏岩 1; 解方喜 1

doi:10.7652/xjtuxb201510019

您当前的位置：

首页 >

文章列表页 >

汽油机部分负荷应用热废气再循环实现临界爆震的性能优化

更新时间：2025-07-09

- 汽油机部分负荷应用热废气再循环实现临界爆震的性能优化
- Performance Optimization of Partial Load of Gasoline Engine at Critical Knock Status Using Hot Exhaust Gas Recirculation
- 西安交通大学学报 2015年49卷第10期页码：116-122
- 作者机构：
  
  吉林大学汽车仿真与控制国家重点实验室,长春,130025
- 作者简介：
- 基金信息：
  
  : 2014-12-20。作者简介: 韩林沛(1988—),男,博士生;解方喜(通信作者),男,讲师。基金项目: 国家自然科学基金资助项目(51206059,51276080);吉林省科技引导计划青年科研基金资助项目(20140520128JH)
- DOI：10.7652/xjtuxb201510019
  中图分类号： TN411.2
- 网络首发：2015-10-10，
  
  纸质出版：2015
- 稿件说明：
移动端阅览
韩林沛 1, 洪伟 1, 王建军 2, 等. 汽油机部分负荷应用热废气再循环实现临界爆震的性能优化[J]. 西安交通大学学报, 2015,49(10):116-122.

Performance Optimization of Partial Load of Gasoline Engine at Critical Knock Status Using Hot Exhaust Gas Recirculation[J]. 2015, 49(10): 116-122.
韩林沛 1, 洪伟 1, 王建军 2, 等. 汽油机部分负荷应用热废气再循环实现临界爆震的性能优化[J]. 西安交通大学学报, 2015,49(10):116-122. DOI： 10.7652/xjtuxb201510019.

Performance Optimization of Partial Load of Gasoline Engine at Critical Knock Status Using Hot Exhaust Gas Recirculation[J]. 2015, 49(10): 116-122. DOI： 10.7652/xjtuxb201510019.

摘要

以某款1.4 L缸内直喷汽油机为研究对象

结合其标定参数和实验结果

利用三维仿真软件Fire研究了热废气再循环对汽油机部分负荷的影响规律。结果表明:当进气压力为68 kPa和24 kPa时

在低于爆震限值的热废气再循环率(η

hot

)范围内

随着η

hot

的增大

混合气的爆震指数均呈现逐渐增大的趋势

且显著低于相同进气温度下的无废气再循环工况; 热废气能够起到强化燃烧和降低进气泵气损失的双重效果

相比常温进气工况

在进气压力为68 kPa、η

hot

=10%工况下的指示功增幅为4.6%

在进气压力为24 kPa、η

hot

=17.5%工况下的指示功增幅可达65.8%; 进气压力为24 kPa、η

hot

=12.5%工况与常温进气工况的火焰传播速度几乎相当

缸压峰值可提高约1/4

而且还能降低52%的CO排放量和78.3%的NO排放量; 通过耦合进气加热或者废气中冷

可以进一步拓展热废气再循环的应用潜力

并且负荷越小耦合进气加热以后的改善效果越显著。

Abstract

Effects of hot exhaust gas recirculation(EGR)on partial load performance of a gasoline engine are studied using the software CFD Fire based on a 1.4 L gasoline direct injection(GDI)engine and its calibrated and experimental data. Results show that increasing hot EGR rate increases the knock index when the intake pressure are 68 kPa and 24 kPa within knock limit

but the knock index is significantly below that in same intake temperature conditions without EGR. Both enhancement of combustion and reduction of pumping loss can be acquired by introducing hot EGR. The indicated work increases by

4.6% when the intake pressure is 68 kPa and η

hot

=10%

and it increases by 65.8% when the intake pressure is 24 kPa and η

hot

=17.5%

compared with that in normal intake temperature condition. The flame propagation velocity is almost the same as the one under the normal intake condition when η

hot

is 12.5% and the intake pressure is 24 kPa

and the peak cylinder pressure increases by about 1/4. Moreover

emissions of CO and NO are reduced by 52% and 78.3%

respectively. Great potential for further application of hot EGR exists by coupling heating intake air or cooling EGR

and more significant improvements can be obtained by coupling heating intake air with lower loads.

关键词

Keywords

references

PARK C, KIM S, KIM H. Stratified lean combustion characteristics of a spray-guided combustion system in a gasoline direct injection engine [J]. Energy, 2012, 41: 401-407.

WEI Haiqiao, ZHU Tianyu, SHU Gequn. Gasoline engine exhaust gas recirculation: a review [J]. Applied Energy, 2012, 99: 534-544.

XIE Fangxi, LI Xiaoping, HONG Wei. Research on using EGR and ignition timing to control load of a spark-ignition engine fueled with methanol [J]. Applied Thermal Engineering, 2013, 50: 1084-1094.

ALGER T, GINGRICH J. The effect of hydrogen enrichment on EGR tolerance in spark ignited engines, SAE 2007-01-0475 [R]. Detroit, MI, USA: SAE, 2007.

GALLONI E, FONTANA G. Effects of exhaust gas recycle in a downsized gasoline engine [J]. Applied Energy, 2013, 105: 99-107.

高青, 金英爱, 李明, 等. 点燃式发动机临界爆震控制及其特性 [J]. 吉林大学学报: 工学版, 2003, 33(4): 7-11.

GAO Qing, JIN Yingai, LI Ming, et al. Control and characteristics of critical knock in S.I. engine [J]. Journal of Jilin University: Engineering and Technology Edition, 2003, 33(4): 7-11.

AMANA M, ALGER T. The effect of EGR on low-speed pre-ignition in boosted SI engines, SAE 2011-01-0339 [R]. Detroit, MI, USA: SAE, 2011.

陈贵堂, 王永珍. 工程热力学 [M]. 北京: 北京理工大学出版社, 2008: 52-56.

史春涛, 秦德, 唐琦, 等. 内燃机燃烧模型的发展现状 [J]. 农业机械学报, 2007, 38(4): 181-186.

SHI Chuntao, QIN De, TANG Qi, et al. Developments in combustion modeling in I.C.E [J]. Transactions of the Chinese Society for Agricultural Machinery, 2007, 38(4): 181-186.

GERTY M D, HEYWOOD J B. An investigation of gasoline engine knock limited performance and the effects of hydrogen enhancement, SAE 2006-01-0228 [R]. Detroit, MI, USA: SAE, 2006.

李小平, 洪伟. 利用EGR控制甲醇发动机负荷 [J]. 燃烧科学与技术, 2012, 18(6): 528-532.

LI Xiaoping, HONG Wei. Load control of a methanol engine by using EGR [J]. Journal of Combustion Science and Technology, 2012, 18(6): 528-532.

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

配气相位和废气再循环对Atkinson循环发动机泵气损失影响及优化

进气运动对汽油机瞬态冷起动混合气形成影响的研究

融合物理信息与深度算子网络的变压器绕组热-流场快速计算方法

水蒸气掺混对氨裂解气旋流燃烧与排放特性的影响研究

超临界二氧化碳向心透平轮背间隙内风阻损失及流动特性研究