超声法测量圆柱滚子轴承润滑油膜厚度

许聪; 李猛; 景敏卿; 刘恒

doi:10.7652/xjtuxb201510010

您当前的位置：

首页 >

文章列表页 >

超声法测量圆柱滚子轴承润滑油膜厚度

更新时间：2025-07-09

- 超声法测量圆柱滚子轴承润滑油膜厚度
- Measurement of Lubricant Film Thickness of Cylindrical Roller Bearing Using Ultrasound
- 西安交通大学学报 2015年49卷第10期页码：61-66
- 作者机构：
  
  西安交通大学机械工程学院,西安,710049
- 作者简介：
- 基金信息：
  
  : 2015-06-04。作者简介: 许聪(1990—),男,硕士生;刘恒(通信作者),男,教授,博士生导师。基金项目: 国家自然科学基金资助项目(51175410)
- DOI：10.7652/xjtuxb201510010
  中图分类号： TH117
- 网络首发：2015-10-10，
  
  纸质出版：2015
- 稿件说明：
移动端阅览
许聪, 李猛, 景敏卿, 等. 超声法测量圆柱滚子轴承润滑油膜厚度[J]. 西安交通大学学报, 2015,49(10):61-66.

Measurement of Lubricant Film Thickness of Cylindrical Roller Bearing Using Ultrasound[J]. 2015, 49(10): 61-66.
许聪, 李猛, 景敏卿, 等. 超声法测量圆柱滚子轴承润滑油膜厚度[J]. 西安交通大学学报, 2015,49(10):61-66. DOI： 10.7652/xjtuxb201510010.

Measurement of Lubricant Film Thickness of Cylindrical Roller Bearing Using Ultrasound[J]. 2015, 49(10): 61-66. DOI： 10.7652/xjtuxb201510010.

摘要

针对实际工况下圆柱滚子轴承接触区润滑油膜薄而窄难以测量的问题

利用基于等效弹簧模型的超声测量原理进行研究

设计并搭建了专用圆柱滚子弹流润滑油膜厚度测量实验台

对超声测量圆柱滚子轴承润滑油膜厚度进行实验研究。通过该实验台来模拟圆柱滚子在实际工况下的运行状态

高频测量探头安装在5自由度微动平台上以便调整合适的测量位置; 在轴承保持架上贴一个反光片作为每个工况下开始测量的触发信号

保证每次测量同一个滚子; 使用温度传感器实时测量实验轴承温度

考虑温度对润滑油的影响。实验所能测量的最大转速取决于重复频率

重复频率不足会导致较大的测量误差; 超声探头聚焦直径区域内的平均效应导致无法测量比聚焦区域更小的油膜分布信息。在最高转速600 r/min、最大载荷16 kN的范围内成功测量到了圆柱滚子轴承在实际工况下0.2～1.2 μm的膜厚。实验结果表明:最小膜厚会随转速的升高而增大

随载荷的增大而减小

与理论计算结果拟合程度较高

证明了该方法在实际工况下测量圆柱滚子轴承油膜厚度的有效性和准确性。

Abstract

The rollers and raceways in cylindrical roller bearings are separated by an extremely thin lubricant film in a narrow region

which is difficult to measure directly in actual working conditions. A cylindrical roller bearing oil film experiment platform is established in this study

and the method to measure the elastohydrodynamic lubrication film thickness in the contact area between the roller and outer raceway in actual working conditions is experimentally researched based on the principle of stiffness equivalence. The experiment platform is used to simulate the running states of a cylindrical roller bearing in actual working conditions

and a 50-MHz focus ultrasonic transducer is fixed on a micro-motion platform with 5-DOF so as to adjust the measuring position. A reflecting plate is pasted on the bearing cage to trigger the measurement so that the same roller can be measured at each time. A thermocouple is used to measure the bearing temperature. The maximum rotational speed that can be measured depends on the pulse repetition rate(PRR)

and low PRR will cause measurement errors. The averaging effect of the transducer in its focal zone makes it hard to pick out the detail of the film thickness in the contact area. Oil films between 0.2 μm and 1.2 μm are measured in actual working conditions under a maximum speed 600 r/min and a maximum load 16 kN. Experimental results show that the thickness increases as the shaft speed increases

and decreases as the radial load increases. The correctness and effectiveness of the proposed method are proved through a comparison between the experimental results and theoretical values.

关键词

Keywords

references

陆思聪. 弹流参量的测量(三): 二、电阻测量法 [J]. 润滑与密封, 1984(6): 40-48.

LU Sicong. Measurement of the EHD parameters(3): measurement by using electrical resistance [J]. Lubrication Engineering, 1984(6): 40-48.

张鹏顺, 朱宝库, 刘树春, 等. 用电容法对弹流油膜厚度测量的研究 [J]. 润滑与密封, 1982(2): 18-24.

ZHANG Pengshun, ZHU Baoku, LIU Shuchun, et al. Study of measuring EHL oil-film thickness with electric capacity method [J]. Lubrication Engineering, 1982(2): 18-24.

RICHARDSON D E, BORMAN G L. Using fibre optics and laser fluorescence for measuring thin oil films with applications to engines, 912388 [R]. Warrendale, PA, USA: SAE International, 1991.

DWYER-JOYCE R S, DRINKWATER B W, DONOHOE C J. The measurement of lubricant film thickness using ultrasound [J]. Proceedings of the Royal Society of London: Series A, 2003, 459: 957-976.

ZHANG Jie, DRINKWATER B W, DWYER-JOYCE R S. Monitoring of lubricant film failure in a ball bearing using ultrasound [J]. ASME Journal of Tribology, 2006, 128(3): 612-618.

DRINKWATER B W, ZHANG Jie, KIRK K J, et al. Ultrasonic measurement of rolling bearing lubrication using piezoelectric thin films [J]. ASME Journal of Tribology, 2009, 131(1): 1-8.

WAN IBRAHIM M K, GASNI D, DWYER-JOYCE R S. Profiling a ball bearing oil film with ultrasonic reflection [J]. Tribology Transactions, 2012, 55(4): 409-421.

REDDYHOFF T, KASOLANG S, DWYER-JOYCE R S, et al. The phase shift of an ultrasonic pulse at an oil layer and determination of film thickness [J]. Proceedings of the Institution of Mechanical Engineers: Part J Journal of Engineering Tribology, 2005, 219(6): 387-400.

焦敬品, 张强, 吴斌, 等. 机械结构流体层厚度超声测量方法理论研究 [J]. 声学技术, 2009, 28(3): 240-244.

JIAO Jingpin, ZHANG Qiang, WU Bin, et al. Theoretical research on thickness measurement of fluid layer in mechanical structure by using ultrasonic technique [J]. Technical Acoustics, 2009, 28(3): 240-244.

ZHANG Jie, DRINKWATER B W, DWYER-JOYCE R S. Acoustic measurement of lubricant-film thickness distribution in ball bearings [J]. Journal of the Acoustical Society of America, 2006, 119(2): 863-871.

HARRIS T A, KOTZALAS M N. Advanced conc-epts of bearing technology: rolling bearing analysis [M]. 5th ed. New York, USA: Taylor and Francis, 2006: 23-37.

BAIR S. High pressure rheology for quantitative elastohydrodynamics [M]. Amsterdam, Netherlands: Elsevier Science, 2007: 54-71.

FAKHREDDINE Y A, ZOLLER P. The Equation of state of a polydimethylsiloxane fluid [J]. Journal of Applied Polymer Science, 1990, 41(5/6): 1087-1093.

REIG G, KASS D, NELLIGAN T. Application considerations in specifying high frequency ultrasonic transducers [EB/OL].(2006-04-06)[2014-06-06]. http:∥www.olympus-ims.com/en/applications-and-solutions/high-frequency/.

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

液压压紧式牵引传动装置传动效率研究

卷吸速度方向与椭圆短轴成一夹角的弹流润滑渐近网格加密算法

滑动轴承润滑油膜厚度光纤动态精密检测模型

无侧隙平面一次包络端面啮合环面蜗杆副弹流润滑分析

倾斜式双圆柱滚子包络环面蜗杆传动的等温弹流润滑分析