空心静叶汽膜孔排吹扫除湿的数值研究

谢金伟; 王新军; 周骏飞

doi:10.7652/xjtuxb201507011

您当前的位置：

首页 >

文章列表页 >

空心静叶汽膜孔排吹扫除湿的数值研究

更新时间：2025-07-09

- 空心静叶汽膜孔排吹扫除湿的数值研究
- Numerical Investigation on Steam Film Holes Blowing for moisture removal on Steam Turbine Hollow Blade Surface
- 西安交通大学学报 2015年49卷第7期页码：61-66
- 作者机构：
  
  西安交通大学能源与动力工程学院,西安,710049
- 作者简介：
- 基金信息：
- DOI：10.7652/xjtuxb201507011
  中图分类号： TK263
- 网络首发：2015-07-10，
  
  纸质出版：2015
- 稿件说明：
移动端阅览
谢金伟, 王新军, 周骏飞. 空心静叶汽膜孔排吹扫除湿的数值研究[J]. 西安交通大学学报, 2015,49(7):61-66.

Numerical Investigation on Steam Film Holes Blowing for moisture removal on Steam Turbine Hollow Blade Surface[J]. 2015, 49(7): 61-66.
谢金伟, 王新军, 周骏飞. 空心静叶汽膜孔排吹扫除湿的数值研究[J]. 西安交通大学学报, 2015,49(7):61-66. DOI： 10.7652/xjtuxb201507011.

Numerical Investigation on Steam Film Holes Blowing for moisture removal on Steam Turbine Hollow Blade Surface[J]. 2015, 49(7): 61-66. DOI： 10.7652/xjtuxb201507011.

摘要

为了降低蒸汽轮机末级叶片表面的蒸汽凝结和水滴沉积、抑制水膜形成

通过借鉴燃气轮机气膜冷却思想提出在汽轮机空心静叶表面设置离散的汽膜孔排进行吹扫除湿

使用ANSYS-CFX软件求解了三维定常黏性雷诺时均N-S方程

采用k-ω湍流模型及壁面函数法数值研究了孔排吹扫除湿性能及其对叶栅主流场的影响。结果表明:当吹汽比小于1.0%时

静叶表面能够形成良好的热汽膜层

叶片表面湿度降低明显且对主流影响较小; 随着吹汽比的增大和吹扫温度的提高

叶栅出口的平均湿度降低

主流的流动效率急剧降低。综合考虑叶片表面湿度和主流的流动效率

在所提除湿结构和0.5%～1.0%吹汽比下除湿效果最好。该结果为开发汽轮机新型高效的除湿方式提供了有益的探索。

Abstract

To reduce the steam condensation and moisture deposition on the last stage of steam turbine

three rows of disperse steam film holes are set on the surface of a hollow stator blade with the reference of the gas turbine film cooling system. The moisture removal performance of this method and its influence on the blade main flow field are numerically investigated by solving the 3-D Reynold time averaged Navier-Stokes equation with the ANSYS-CFX commercial code

as well as the k-ω turbulence model and the wall function. The results show that when the steam blowing ratio gets less than 1.0%

the hot steam film on the blade surface is prone to form and the wetness of the surface declines apparently

and this level of blowing ratio slightly affects the main flow. With the increase of the blowing mass flow rate or the blowing temperature

the averaged cascade outlet wetness decreases

however

the flow efficiency of the main flow decreases sharply in consequence. Considering the blade surface wetness and the main flow efficiency

the best moisture removal performance can be achieved in this designed structure as the steam blowing ratio is taken between 0.5% and 1.0%.

关键词

Keywords

references

HESKETH J A, WALKER P J. Effects of wetness in steam turbines [J]. Proceedings of the Institution of Mechanical Engineers: Part C Journal of Mechanical Engineering Science, 2005, 219: 1301-1314.

TODD K W, FALLON J B. Erosion control in the wet steam turbine [J]. Proceedings of the Institution of Mechanical Engineers, 1965, 180: 50-63.

Brown Boveri Company Limited. Improvement in and relating to steam turbines and methods of operating the same: UK, GB1074762 A1 [P]. 1967-07-05.

刘建成, 林志鸿, 闻雪友, 等. 汽轮机内部除湿技术的发展 [J]. 热能动力工程, 2005, 20(1): 1-5.

LIU Jiancheng, LIN Zhihong, WEN Xueyou, et al. The development of the inner moisture removal technology for steam turbines [J]. Journal of Engineering for Thermal Energy and Power, 2005, 20(1): 1-5.

王新军, 卢澄, 李振光, 等. 缝隙吹扫对静叶出口二次水滴直径影响的试验研究 [J]. 西安交通大学学报, 2007, 41(7): 764-767.

WANG Xinjun, LU Cheng, LI Zhenguang, et al. Experimental study on effects of slot hot gas blowing on secondary water droplet diameter downstream of the stationary blade [J]. Journal of Xi'an Jiaotong University, 2007, 41(7): 764-767.

李春国, 王新军, 程代京, 等. 汽轮机空心静叶吹扫性能的试验研究和数值计算 [J]. 动力工程, 2009(7): 635-639.

LI Chunguo, WANG Xinjun, CHENG Daijing, et al. Experimental study and numerical calculation of blowing performance for hollow static blade of steam turbine [J]. Journal of Power Engineering, 2009(7): 635-639.

王松涛, 刘建成. 蒸汽轮机气膜加热除湿技术的研究 [C]∥中国动力工程学会透平专业委员会, 中国动力工程学会透平专业委员会2007年学术研讨会论文集. 北京: 中国动力工程学会透平专业委员会, 2007: 511-515.

徐亮, 颜培刚, 黄洪雁, 等. 静叶内弧中部热蒸汽喷射的数值研究 [J]. 哈尔滨工业大学学报, 2009, 41(9): 46-50.

XU Liang, YAN Peigang, HUANG Hongyan, et al. Numerical research on hot steam injection at the central part of stator inner arc [J]. Journal of Harbin Institute of Technology, 2009, 41(9): 46-50.

CRANE R I. Droplet deposition in steam turbines [J]. Proceedings of the Institution of Mechanical Engineers: Part C Journal of Mechanical Engineering Science, 2004, 218: 859-870.

SLATER S A, LEEMING A D, YOUNG J B. Particle deposition from two-dimensional turbulent gas flows [J]. International Journal of Multiphase Flow, 2003, 29: 721-750.

BAKHTAR F, EBRAHIMI M, WEBB R A. On the performance of a cascade of turbine rotor tip section blading in nucleating steam: part 1 Surface pressure distributions [J]. Proceedings of the Institution of Mechanical Engineers: Part C Journal of Mechanical Engineering Science, 1995, 209(2): 115-124.

汪丽莉. 低压汽轮机内湿蒸汽两相流的测量技术与实验研究 [D]. 上海: 上海理工大学, 2003.

李亮,薛太旭,刘启凡,等.湿蒸汽条件下空心静叶缝隙抽吸性能的试验研究.2014,48(11):1-7.[doi:10.7652/xjtuxb 201411001]

程鹏,王新军,张峰,等.核电汽轮机弯管式汽水分离器的改进结构及其除湿性能.2014,48(5):61-66+77.[doi:10.7652/xjtuxb201405011]

李瑜,宁德亮,李亮,等.汽轮机中湿汽损失的定量计算.2014,48(1):25-30.[doi:DOI:10.7652/xjtuxb201401005]

潘家成,徐亮,高建民,等.轴向间距对二次水滴运动特性及沉积规律的影响.2012,46(7):1-6.[doi:10.7652/xjtuxb 201207001]

李瑜,李亮,钟刚云,等.末级透平对低压缸气动和凝结特性的影响.2012,46(7):16-20.[doi:10.7652/xjtuxb201207004]

李春国,王新军,关盼龙,等.汽轮机静叶表面水膜缝隙抽吸的试验研究.2009,43(1):20-23.[doi:10.7652/xjtuxb2009 01005]

王新军,卢澄,李振光,等.缝隙吹扫对静叶出口二次水滴直径影响的试验研究.2007,41(7):764-767.[doi:10.7652/xjtuxb200707002]

王世柱,李志刚,李军,等.补汽对透平级气动性能和静叶汽封转子动力特性影响的数值模拟.2015,49(5):56-61.[doi:10.7652/xjtuxb201505009]

杜昆,李军,晏鑫.槽缝射流对静叶端壁冷却性能的影响.2015,49(1):21-26.[doi:10.7652/xjtuxb201501004]

李彬,宋立明,李军,等.长叶片透平级多学科多目标优化设计.2014,48(1):1-6.[doi:DOI:10.7652/xjtuxb201401001]

陶加银,高庆,宋立明,等.涡轮轮缘密封非定常主流入侵特性的数值研究.2014,48(1):53-59.[doi:10.7652/xjtuxb 201401010]

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

高声压激励下多孔金属材料的吸声性能数值计算

求解三维准静态矢量磁位的快速多极方法

同步回转式制冷压缩机的运动分析

混压式超声速进气道喉道长度的设计与数值研究

射流式漩涡发生器对离心叶轮性能的影响