在轨运行低温液氢箱体蒸发量计算与增压过程研究

刘展 1; 厉彦忠 1; 2; 王磊 1; 晋永华 1

doi:10.7652/xjtuxb201502023

您当前的位置：

首页 >

文章列表页 >

在轨运行低温液氢箱体蒸发量计算与增压过程研究

更新时间：2025-07-09

- 在轨运行低温液氢箱体蒸发量计算与增压过程研究
- Evaporation Calculation and Pressurization Process of on-Orbit Cryogenic Liquid Hydrogen Storage Tank
- 西安交通大学学报 2015年49卷第2期页码：135-140
- 作者机构：
  
  西安交通大学能源与动力工程学院,西安,710049
- 作者简介：
- 基金信息：
  
  : 2014-06-09。作者简介: 刘展(1988—),男,博士生;厉彦忠(通信作者),男,教授,博士生导师。基金项目: 国家自然科学基金资助项目(51376142);航天低温推进剂技术国家重点实验室开放课题资助项目(SKLTSCP1311)
- DOI：10.7652/xjtuxb201502023
  中图分类号： V511
- 网络首发：2015-02-10，
  
  纸质出版：2015
- 稿件说明：
移动端阅览
刘展 1, 厉彦忠 1, 2, 等. 在轨运行低温液氢箱体蒸发量计算与增压过程研究[J]. 西安交通大学学报, 2015,49(2):135-140.

Evaporation Calculation and Pressurization Process of on-Orbit Cryogenic Liquid Hydrogen Storage Tank[J]. 2015, 49(2): 135-140.
刘展 1, 厉彦忠 1, 2, 等. 在轨运行低温液氢箱体蒸发量计算与增压过程研究[J]. 西安交通大学学报, 2015,49(2):135-140. DOI： 10.7652/xjtuxb201502023.

Evaporation Calculation and Pressurization Process of on-Orbit Cryogenic Liquid Hydrogen Storage Tank[J]. 2015, 49(2): 135-140. DOI： 10.7652/xjtuxb201502023.

摘要

为了研究低温箱体在外部漏热下的在轨增压过程

采用FLUENT软件中的流体体积(VOF)方法

对AS-203飞行试验中低温液氢箱体进行数值模拟。通过对默认可实现k-ε模型进行参数调整

并与试验结果对比发现

调整参数后的模型可较好地预测低温液氢箱体在轨增压过程。因此

采用该模型对所研究低温液氢箱体进行500 s增压数值模拟

计算结果表明:与气枕接触的壁面漏热绝大部分用来使箱体增压

小部分用来产生相变; 在外部漏热下低温箱体压增速率约49.6 Pa/s

箱体气液界面的蒸发率约为0.101 6%/h; 在一定的微重力水平下

自然对流作用依然存在

其对流强弱主要取决于箱体尺寸以及外部漏热热流大小; 在整个模拟过程中

气枕区热分层较之液相区更为严重; 随着重力水平的降低

表面张力的作用逐渐凸显

界面形状变为曲面。

Abstract

To investigate the on-orbit pressurization of cryogenic storage tank

the volume of fluid method in FLUENT is chosen to simulate the AS-203 flight experimental liquid hydrogen tank. Improving the original realizable k-ε turbulence model and comparing with the experiment data

the modified model successfully predicts the on-orbit pressurization process of cryogenic liquid hydrogen storage tank. Therefore the calibrated realizable k-ε model is adopted to research the liquid hydrogen storage tanks on-orbit pressurization for 500 seconds. The calculation shows that most of wall heat leakage increases the storage tank pressure

only a small part of external heat leakage facilitates vapor-liquid phase change. The pressure increase rate of the liquid hydrogen tank and the evaporation rate happened in the gas-liquid interfacial

for the effect of external heat leakage

are about 49.6 Pa/s and 0.1016%/hour respectively. Natural convection still exists under certain microgravity

and its intensity depends on the tank size and the external heat flux density. The thermal stratification of vapor region is more obvious than liquid region in the whole pressurization process. With the decreasing gravity level

the effects of surface tension are gradually prominent

and the gas-liquid interface shape becomes curved surface.

关键词

Keywords

references

CHATO D J. Cryogenic technology development for explorations missions [C]∥45th AIAA Aerospace Sciences Meeting and Exhibit. Washington, DC, USA: AIAA, 2007: 1-10.

ZILLIAC G, KARABEYOGLU M A. Modeling of propellant tank pressurization [C]∥41th AIAA/ASME/ASEE Joint Propulsion Conference. Washington, DC, USA: AIAA, 2005: 1-25.

王赞社, 顾兆林, 冯诗愚, 等. 低温推进剂贮箱增压过程的传热传质数学模拟 [J]. 低温工程, 2008(6): 28-31.

WANG Zanshe, GU Zhaolin, FENG Shiyu, et al. Simulation of heat transfer and mass transfer in cryogenic propellant tank pressurization process [J]. Cryogenics, 2008(6): 28-31.[4] PANZARELLA C H, KASSEMI M. On the validity of purely thermodynamic descriptions of two-phase cryogenic fluid storage [J]. Journal of Fluid Mechanics, 2003, 484: 41-68.

PANZARELLA C, PLACHTA D, KASSEMI M. Pressure control of large cryogenic tanks in microgravity [J]. Cryogenics, 2004, 44(6): 475-483.

PANZARELLA C H, KASSEMI M. Self-pressurization of large spherical cryogenic tanks in space [J]. Journal of Spacecraft and Rockets, 2005, 42(2): 299-308.

BARSI S, KASSEMI M. Numerical and experimental comparisons of the self-pressurization behavior of an LH2 tank in normal gravity [J]. Cryogenics, 2008, 48(3): 122-129.

GRAYSON G D, LOPEZ A, CHANDLER F O, et al. Cryogenic tank modeling for the Saturn AS-203 experiment [C]∥42nd AIAA/ASME/SAE/ASEE Joint Propulsion Conference and Exhibit. Washington, DC, USA: AIAA, 2006: 1-7.

MATTICK S J, LEE C P, HOSANGADI A, et al. Progress in modeling pressurization in propellant tanks [C]∥46th AIAA/ASME/SAE/ASEE Joint Propulsion Conference and Exhibit. Washington, DC, USA: AIAA, 2010: 1-13.

KARTUZOVA O, KASSEMI M. Modeling interfacial turbulent heat transfer during ventless pressurization of a large scale cryogenic storage tank in microgravity [C]∥47th AIAA/ASME/SAE/ASEE Joint Propulsion Conference and Exhibit. Washington, DC, USA: AIAA, 2011: 1-18.

HIRT C W, NICHOLSB D. Volume of fluid(VOF)method for the dynamics of free boundaries [J]. Journal of Computational Physics, 1981, 39(1): 201-225.

陶文铨. 数值传热学 [M]. 2版. 西安: 西安交通大学出版社, 2005: 2-8.

BRACKBILL J U, KOTHE D B, ZEMACH C. A continuum method for modeling surface tension [J]. Journal of Computational Physics, 1992, 100(2): 335-354.

王磊, 厉彦忠, 李翠, 等. 液体火箭贮箱增压排液过程温度场数值研究 [J]. 航空动力学报, 2011, 26(8): 1893-1899.

WANG Lei, LI Yanzhong, LI Cui, et al. Numerical study on temperature distribution of tank pressurization process of liquid rocket during outflow [J]. Journal of Aerospace Power, 2011, 26(8): 1893-1899.

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

新型运载火箭射前预冷液氧贮箱热分层的数值研究

升空过程中低温液氧贮箱压力变化及热分层研究

低温流体微重力池沸腾气泡脱落特性研究

蓄冰球内定向凝固过程蓄冷特性的实验研究

冷库水平空气幕热湿阻隔性能数值模拟研究