低干度两相流工质在矩形流道冷板内的换热特性实验研究

刘腾 1; 钱吉裕 2; 孔祥举 2; 曹锋 1; 束鹏程 1

doi:10.7652/xjtuxb201501010

您当前的位置：

首页 >

文章列表页 >

低干度两相流工质在矩形流道冷板内的换热特性实验研究

更新时间：2025-07-09

- 低干度两相流工质在矩形流道冷板内的换热特性实验研究
- Experimental Study on Heat Transfer Performance of Low Quality Two-Phase Working Medium in Cool Plate Evaporation with Rectangular Channels
- 西安交通大学学报 2015年49卷第1期页码：59-64
- 作者机构：
  
  西安交通大学能源与动力工程学院,西安,710049
- 作者简介：
- 基金信息：
- DOI：10.7652/xjtuxb201501010
  中图分类号： TB654
- 网络首发：2015-01-10，
  
  纸质出版：2015
- 稿件说明：
移动端阅览
刘腾 1, 钱吉裕 2, 孔祥举 2, 等. 低干度两相流工质在矩形流道冷板内的换热特性实验研究[J]. 西安交通大学学报, 2015,49(1):59-64.

Experimental Study on Heat Transfer Performance of Low Quality Two-Phase Working Medium in Cool Plate Evaporation with Rectangular Channels[J]. 2015, 49(1): 59-64.
刘腾 1, 钱吉裕 2, 孔祥举 2, 等. 低干度两相流工质在矩形流道冷板内的换热特性实验研究[J]. 西安交通大学学报, 2015,49(1):59-64. DOI： 10.7652/xjtuxb201501010.

Experimental Study on Heat Transfer Performance of Low Quality Two-Phase Working Medium in Cool Plate Evaporation with Rectangular Channels[J]. 2015, 49(1): 59-64. DOI： 10.7652/xjtuxb201501010.

摘要

为了提高电子设备在两相蒸发沸腾冷却换热系统中的冷却效果

对低干度两相流工质R22在矩形流道蒸发冷板内的换热特性进行实验研究。通过调节板式电加热的输入功率来控制工质进入蒸发冷板前的干度

从而得到不同负荷不同干度下系统的换热性能

结果表明:在低干度、低充灌量以及低流量的两相流蒸发冷却系统中

系统的换热能力随着干度的增大而降低。通过分析系统内部压力与流量的关系发现

系统内部压力受气液相比例影响

随系统负荷增大而增大

系统流量随系统内部压力的增大而增大

最终达到特定工况下的最大值。由此可见

低干度、低充灌量、低流量的两相流蒸发冷却系统对电子设备的降温效果是有利的

其可以降低系统能耗

保证系统运行安全

降低系统振动。该结果为板式两相流蒸发冷却系统设计提供了实验依据。

Abstract

The heat transfer performance of the low quality two-phase working medium R22 in cool plate evaporation with rectangular channels was experimentally studied with the purpose of improving the cooling effect of electronic equipment in two-phase boiling heat transfer system. The quality of working medium before performing cool plate evaporation can be determined by controlling the input power of board-type electric heating

hence the heat transfer performance can be obtained under different system loadings and qualities. The results showed that the heat transfer performance in two-phase boiling heat transfer system under the condition of low quality

low charge and low flow rates decreased with the increase of quality. The relationship between the system pressure and flow rate was analyzed. It was showed that the system pressure increased with the system loading under the influence of vapor-liquid ratio

and the system flow increased with the system pressure until reaching the maximum under special working conditions. So the two-phase boiling heat transfer system has a positive impact on the cooling of electronic equipment under the condition of low quality

low charge and low flow

and the system can operate safely with a reduced vibration and energy consumption. In addition

the results can provide an experimental base for designing the board-type two-phase boiling heat transfer system.

关键词

Keywords

references

JANICKI M, NAPIERALSKI A. Modelling electronic circuit radiation cooling using analytical thermal model [J]. Microelectronics Journal, 2000, 31(9/10): 781-785.

吕洪涛. 电子设备散热技术探讨 [J]. 电子机械工程, 2011, 27(5): 8-11.

LV Hongtao. Discussion on cooling techniques for electronic equipment [J]. Electro-Mechanical Engineering, 2011, 27(5): 8-11.

HOA C, DEMOLDER B, ALEXANDRE A. Roadmap for developing heat pipes for ALCATEL SPACE's satellites [J]. Applied Thermal Engineering, 2003, 23(9): 1099-1108.

RICARDO J, JOHN R. Flow boiling in horizontal smooth tubes: new heat transfer results for R-134a at three saturation temperatures [J]. Applied Thermal Engineering, 2009, 29(7): 1289-1298.

ZHU Yu, HU Haitao, SUN Shuo. Heat transfer measurements and correlation of refrigerant flow boiling in tube filled with copper foam [J]. International Journal of Refrigeration, 2014, 38(10): 215-226.

邓定国, 束鹏程. 回转压缩机 [M]. 北京: 机械工业出版社, 2001: 219-228.

缪道平, 吴业正. 制冷压缩机 [M]. 西安: 西安交通大学出版社, 2011: 247-260.

赵学科. 旋叶式压缩机型线设计与理论研究 [D]. 重庆: 重庆大学, 2011: 8-14.

殷翔,钱吉裕,孔祥举,等.天线阵面沸腾换热的数值分析及优化.2014,48(11):64-69.[doi:10.7652/xjtuxb201411011]

施东晓,毕勤成,周荣启.磁性液体两相界面演变特性的数值研究.2014,48(9):123-129.[doi:10.7652/xjtuxb201409021]

翟强,朱永生,闫柯,等.高速角接触轴承油气润滑两相流动特性数值研究.2014,48(6):86-90.[doi:10.7652/xjtuxb 201406015]

何联格,左正兴,向建华.气缸盖中两相流沸腾换热热机耦合仿真分析.2013,47(7):23-28.[doi:10.7652/xjtuxb2013070 05]

何联格,左正兴,向建华.气缸盖冷却水腔内两相流动沸腾传热仿真研究.2013,47(1):21-26.[doi:10.7652/xjtuxb2013 01005]

冯永昌,李会雄,王太.Richtmyer-Meshkov不稳定性的格子Boltzmann数值模拟.2012,46(11):44-48.[doi:10.7652/xjtuxb201211009]

孙东亮,徐进良,王丽.求解两相蒸发和冷凝问题的气液相变模型.2012,46(7):7-11.[doi:10.7652/xjtuxb201207002]

张冬青,杨冬,刘计武,等.超临界循环流化床下降水冷屏流量分配特性试验研究.2012,46(5):32-37.[doi:10.7652/xjtuxb201205006]

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

不同跨临界CO2直冷系统架构下动力电池冷却系统性能分析

基于VOF模型的相界面面积和形心计算方法

弦月型通道热虹吸提升管流动特性的数值计算

求解两相蒸发和冷凝问题的气液相变模型