多段转弯连接回转通道的换热和压力分布研究

赵曙 1; 朱惠人 1; 郭涛 1; 张丽 1; 付猛 2

doi:10.7652/xjtuxb201410021

您当前的位置：

首页 >

文章列表页 >

多段转弯连接回转通道的换热和压力分布研究

更新时间：2025-07-09

- 多段转弯连接回转通道的换热和压力分布研究
- Heat Transfer and Pressure Drop on Multi-Turn Connected Internal Cooling Channels
- 西安交通大学学报 2014年48卷第10期页码：131-136
- 作者机构：
  
  西北工业大学动力与能源学院,西安,710072
- 作者简介：
- 基金信息：
  
  : 2014-03-21。作者简介: 赵曙(1984—),男,博士生;朱惠人(通信作者),男,教授,博士生导师。基金项目: 国家重点基础研究发展计划资助项目(2013CB035702)
- DOI：10.7652/xjtuxb201410021
  中图分类号： V231.1
- 网络首发：2014-10-10，
  
  纸质出版：2014
- 稿件说明：
移动端阅览
赵曙 1, 朱惠人 1, 郭涛 1, 等. 多段转弯连接回转通道的换热和压力分布研究[J]. 西安交通大学学报, 2014,48(10):131-136.

Heat Transfer and Pressure Drop on Multi-Turn Connected Internal Cooling Channels[J]. 2014, 48(10): 131-136.
赵曙 1, 朱惠人 1, 郭涛 1, 等. 多段转弯连接回转通道的换热和压力分布研究[J]. 西安交通大学学报, 2014,48(10):131-136. DOI： 10.7652/xjtuxb201410021.

Heat Transfer and Pressure Drop on Multi-Turn Connected Internal Cooling Channels[J]. 2014, 48(10): 131-136. DOI： 10.7652/xjtuxb201410021.

摘要

为了掌握涡轮叶片内的多段通道连接关系对回转通道壁面换热和沿程压力分布的影响

采用数值模拟方法研究了带肋单通道、回转通道模型的流动特性

通过瞬态液晶实验测量了回转通道壁面换热分布

揭示了多段通道连接关系对回转通道壁面换热的影响机理。实验结果表明:转弯连接使各段通道的速度分布不均; 回转通道沿程压力系数逐渐减小; 转弯连接使回转通道各段通道的换热分布不对称

沿流向的努赛尔数Nu逐渐减小; 沿程展向平均Nu呈多波峰状分布

肋的扰流作用沿流向逐渐减弱

且两肋之间的高换热区沿流向逐渐向肋下游的背风面偏移; 肋间区域的平均Nu沿流向逐渐减小; 回转通道各段平均Nu随雷诺数的增加而增大

且增加幅度逐渐减小。

Abstract

Numerical simulations for a single channel and muti-turn connected cooling channel model with 90°ribs is conducted to understand the effect of multi-turn connection on heat transfer and pressure coefficient of internal channel in rotor blade. The heat transfer of turned channel is measured by utilizing transient liquid crystal measurement

and the influence mechanism of multi-turn connection in tuning channel is revealed. Experimental results show that the velocity distribution is uneven in each passage due to tuning eddy. Both the pressure coefficient and the Nusset number(Nu)decrease along the flow direction. The Nu distribution is asymmetric in each passage due to turn-connection. The distribution of averaged Nu numbers has a multiple-peak form as a result of secondary flow induced by rib turbulations. The area of high Nu between two continuous ribs is gradually shifted to the rib downstream. The average Nu in each passage gradually increases while the ratio is slowly reduced as the Reynolds number increases.

关键词

Keywords

references

SU Guoguang, CHEN Hamnching, HAN Jechin. Computation of flow and heat transfer in two-pass rotating rectangular channels(AR=1:1, AR=1:2, AR=1:4)with 45-deg angled ribs by a Reynolds stress turbulence model[C]∥Proceedings of the 2004 ASME Turbo Expo. Norcross, GA, USA: American Society of Mechanical Engineers, 2004: 603-612.

HAN Jechin. Heat transfer and friction channels with two opposite rib-roughened walls[J]. ASME Journal of Heat Transfer, 1984, 106(4): 774-781.

FU Wenlung, WRIGHT L M, HAN Jechin. Heat transfer in two-pass rotating rectangular channels(AR=1:2 and AR=1:4)with 45 deg angled rib turbulators[J]. ASME Journal of Turbomacinery, 2005, 127(1): 164-174.

HUANG S C, LIU Y S. High rotation number effect on heat transfer in a leading edge cooling channel with three channel orientations[C]∥Proceedings of the 2012 ASME Turbo Expo. Norcross, GA, USA: American Society of Mechanical Engineers, 2012: 1289-1298.

KHALATOV A A, DAHEVSKYY Y Y, PYSMENNYI D M. Heat transfer and friction factor in the rib roughened blade leading edge cooling passage[C]∥Proceedings of the 2011 ASME Turbo Expo. Norcross, GA, USA: American Society of Mechanical Engineers, 2011: 1193-1203.

WRIGHT L M, GOHARDANI A S. Effect of coolant ejection in rectangular and trapezoidal trailing edge cooling passages[C]∥Proceedings of the 2008 ASME Turbo Expo. Norcross, GA, USA: American Society of Mechanical Engineers, 2008: 399-408.

苏福斌, 朱惠人, 郭涛, 等. 内冷通道带肋和出流孔壁面的换热研究[J]. 航空动力学报, 2009, 24(7): 1500-1506.

SU Fubin, ZHU Huiren, GUO Tao, et al. Heat transfer enhancement within an internal passage by combinations of ribs and suction holes[J]. Journal of Aerospace Power, 2009, 24(7): 1500-1506.

陈伟, 阚瑞, 任静, 等. 涡轮叶片内部冷却通道传热和压力分布特性的实验[J]. 航空动力学报, 2010, 25(12): 2779-2786.

CHEN Wei, KAN Rui, REN Jing, et al. Experimental investigation of heat transfer and pressure drop in a two-pass internal coolant passages of gas turbine airfoil[J]. Journal of Aerospace Power, 2010, 25(12): 2779-2786.

朱剑琴, 徐国强, 陶智, 等. 带肋变截面回转通道内流动与换热的数值模拟[J]. 北京航空航天大学学报, 2009, 35(1): 18-22.

ZHU Jianqin, XU Guoqiang, TAO Zhi, et al. Numerical investigation of heat transfer and flow resistance in U-shaped variable cross-section channels with different rib heights[J]. Journal of Beijing University of Aeronautics and Astronautics, 2009, 18(1): 18-22.

赵曙, 朱惠人, 郭涛, 等. 旋转带肋回转通道流动换热数值模拟[J]. 西安交通大学学报, 2014, 48(2): 125-130.

ZHAO Shu, ZHU Huiren, GUO Tao, et al. Numerical predictions of flow and heat transfer for rotating internal cooling channels with rib turbulators[J]. Journal of Xi'an Jiaotong University, 2014, 48(2): 125-130.

YAN Y Y, OWEN J M. Uncertainties in transient heat transfer measurements with liquid crystal[J]. International Journal of Heat and Fluid Flow, 2002, 23(1): 29-35.

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

旋转带肋回转通道流动换热数值模拟

张角凹坑气膜孔对双层壁气膜冷却特性的影响

带锥形孔的矩阵冷却通道流动换热多目标优化

涡轮叶片的热流固耦合数值方法研究及应用

涡轮叶片裂纹方位角的三维叶尖间隙动态响应特性研究