3 mm闭式脉动热管传热性能的实验研究

王学会; 袁晓蓉; 郑豪策; 阮一逍; 韩晓红; 陈光明

doi:10.7652/xjtuxb201409017

您当前的位置：

首页 >

文章列表页 >

3 mm闭式脉动热管传热性能的实验研究

更新时间：2025-07-09

- 3 mm闭式脉动热管传热性能的实验研究
- Experimental Research on Heat Transfer Performance of 3 mm Closed Pulsating Heat Pipe
- 西安交通大学学报 2014年48卷第9期页码：101-106
- 作者机构：
  
  浙江大学制冷与低温研究所,杭州,310027
- 作者简介：
- 基金信息：
  
  : 2014-01-23。作者简介: 王学会(1989—),男,博士生;韩晓蓉(通信作者),女,副教授。基金项目: 国家自然科学基金资助项目(51176166);中央高校基本科研业务费专项资金资助项目(2013QNA4014)
- DOI：10.7652/xjtuxb201409017
  中图分类号： TB65
- 网络首发：2014-09-10，
  
  纸质出版：2014
- 稿件说明：
移动端阅览
王学会, 袁晓蓉, 郑豪策, 等. 3 mm闭式脉动热管传热性能的实验研究[J]. 西安交通大学学报, 2014,48(9):101-106.

Experimental Research on Heat Transfer Performance of 3 mm Closed Pulsating Heat Pipe[J]. 2014, 48(9): 101-106.
王学会, 袁晓蓉, 郑豪策, 等. 3 mm闭式脉动热管传热性能的实验研究[J]. 西安交通大学学报, 2014,48(9):101-106. DOI： 10.7652/xjtuxb201409017.

Experimental Research on Heat Transfer Performance of 3 mm Closed Pulsating Heat Pipe[J]. 2014, 48(9): 101-106. DOI： 10.7652/xjtuxb201409017.

摘要

为了研究大管径脉动热管的传热性能

设计并搭建了一种闭式脉动热管传热性能的测试装置

管道内径为3 mm

由此实验研究了该装置在加热功率为0～90 W范围内的传热性能

通过对冷凝段壁面温度波动特性进行分析

研究了不同加热方式对脉动热管传热性能的影响。结果表明:充液率为27.5%～67.5%时

脉动热管具有较好的传热性能

加热功率为90 W时

各充液率下的热阻值均在0.4 ℃/W以下; 当加热段的输入功率变化(加热功率以波动的方式输入)时

脉动热管的热阻大于对应的以恒定功率加热时的热阻

两者之间的差值随着加热功率的增大而减小; 加热功率突变且超过启动功率时

脉动热管很快启动

但达到稳定需要较长的时间

而采用渐进的加热方式时

脉动热管在短时间内即可达到稳定。加热功率较小时推荐采用较小的充液率

加热功率较大时充液率的选择应综合考虑工质的热容量和传热特性。

Abstract

To investigate the heat transfer performance of large diameter pulsating heat pipe(PHP)

an experimental device for closed PHP with 3 mm inner diameter was designed and constructed. The heat transfer performance of PHP was investigated within heat power range of 0-90 W. The influence of different heating modes on the performance of PHP was tested by analyzing the fluctuation characteristics of wall temperatures in the condensation section. The experimental results indicate that the PHP well performs in a wide charge ratio range of 27.5%-67.5%

and the thermal resistances get less than 0.4 ℃/W at all tested charge ratios. When the input heat power fluctuates

the thermal resistances of PHP get greater than those heated by constant heat power

and the difference between them decreases with the increasing heat power. If the heat power suddenly reaches beyond the starting power of the PHP

the PHP quickly starts up

but takes a long period to become stable. However

the PHP quickly tends to be stable for gradual heating-mode. The small charge ratio is suggested in the case of lower heat power

otherwise

both the heat capability of working fluid and heat transfer performance ought to be considered.

关键词

Keywords

references

GARIMELLA S V, FLEISCHER A S, MURTHY J Y, et al. Thermal challenges in next-generation electronic systems[J]. IEEE Trans on Components and Packaging Technologies, 2008, 31(4): 801-815.

韩晓红, 闵旭伟, 李鹏. 一种利用气泡泵效应重力辅助回路热管的实验研究[J]. 西安交通大学学报, 2012, 46(3): 9-14.

HAN Xiaohong, MIN Xuwei, LI Peng. Experimental study on an thermosyphon loop with bubble pump effect[J]. Journal of Xi'an Jiaotong University, 2012, 46(3): 9-14.

AKACHI H, KANAGAW A. Structure of a heat pipe: USA, US4921041[P].1990-05-01.

XIAO L, CAO Y. Recent advances in pulsating heat pipes and its derivatives[J]. Journal of Enhanced Heat Transfer, 2012, 19(3): 213-231.

SHAFFI M B, FAGHRI A, ZHANG Y W. Thermal modeling of unlooped and looped pulsating heat pipes[J]. Journal of Heat Transfer, 2001, 123(6): 1159-1172.

HOSODA M, NISHIO S, SHIRAKASHI R. Study of meandering closed-loop heat-transport device(vapor-plug propagation phenomena)[J]. JSME International Journal: Series B Fluids and Thermal Engineering, 1999, 42(4): 737-744.

马永锡, 张红. 低于临界通道弯数振荡热管的传热特性[J]. 北京化工大学学报: 自然科学, 2005, 32(4): 87-90.

MA Yongxi, ZHANG Hong. Heat transfer characteristics of oscillating heat pipes with under-critical turns[J]. Journal of Beijing University of Chemical Technology: Natural Science, 2005, 32(4): 87-90.

马永锡, 张红. 振荡热管当量导热系数的理论推导与分析[J]. 化学工程, 2006, 34(10): 17-20.

MA Yongxi, ZHANG Hong. Theoretical deduction and analysis of equivalent thermal conductivity of oscillating heat pipes[J]. Chemical Engineering, 2006, 34(10): 17-20.

LIU S, LI J T, DONG X Y, et al. Experimental study of flow patterns and improved configurations for pulsating heat pipes[J]. Journal of Thermal Science, 2007, 16(1): 56-62.

CAI Q, CHEN C L, ASFIA J F. Heat transfer enhancement of planar heat pipe device[C]∥2006 International Mechanical Engineering Congress and Exposition. New York, USA: ASME, 2006: 153-158.

KIM J S, BUI N H, JUNG H S, et al. The study on pressure oscillation and heat transfer characteristics of oscillating capillary tube heat pipe[J]. KSME International Journal, 2003, 17(10): 1533-1542.

PARK Y, TANSHEN M R, NINE M J, et al. Characterizing pressure fluctuation into single-loop oscillating heat pipe[J]. Journal of Central South University, 2012, 19(9): 2578-2583.

YANG H H, KHANDEKAR S, GROLL M. Operational limit of closed loop pulsating heat pipes[J]. Applied Thermal Engineering, 2008, 28(1): 49-59.

CHAROENSAWAN P, TERDTOON P. Thermal performance of horizontal closed-loop oscillating heat pipes[J]. Applied Thermal Engineering, 2008, 28(5): 460-466.

RITTIDECH S, TERDTOON P, MURAKAMI M, et al. Correlation to predict heat transfer characteristics of a closed-end oscillating heat pipe at normal operating condition[J]. Applied Thermal Engineering, 2003, 23(4): 497-510.

MOHAMMADI M, MOHAMMADI M, SHAFII M B. Experimental investigation of a pulsating heat pipe using ferro fluid(magnetic nanofluid)[J]. Journal of Heat Transfer, 2012, 134(1): 014504.

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

充灌磁性液体的脉动热管试验研究

燃气透平双肩壁凹槽叶顶流动传热性能优化研究

反蛋白石吸液芯均热板传热特性实验研究

面向高海拔空冷发电机防晕性能演化规律的电热耦合研究

冷库水平空气幕热湿阻隔性能数值模拟研究