一种单相阶梯接缝变压器铁芯的空载损耗计算方法

张良县 1; 陈模生 1; 彭宗仁 1; 谢庆峰 2; 龚宜祥 2

doi:10.7652/xjtuxb201404010

您当前的位置：

首页 >

文章列表页 >

一种单相阶梯接缝变压器铁芯的空载损耗计算方法

更新时间：2025-04-29

- 一种单相阶梯接缝变压器铁芯的空载损耗计算方法
- Algorithm for Calculating No-Load Losses of Single-Phase Transformer Core with Step-Lap Joints
- 西安交通大学学报 2014年48卷第4期页码：52-58
- 作者机构：
  
  西安交通大学电力设备电气绝缘国家重点实验室,西安,710049
- 作者简介：
- 基金信息：
  
  : 2013-08-26。作者简介: 张良县(1985—),男,博士生;彭宗仁(通信作者),男,教授,博士生导师。基金项目: 国家重点基础研究发展计划资助项目(2011CB209404)
- DOI：10.7652/xjtuxb201404010
  中图分类号： TM411.1
- 网络首发：2014-04-10，
  
  纸质出版：2014
- 稿件说明：
移动端阅览
张良县 1, 陈模生 1, 彭宗仁 1, 等. 一种单相阶梯接缝变压器铁芯的空载损耗计算方法[J]. 西安交通大学学报, 2014,48(4):52-58.

Algorithm for Calculating No-Load Losses of Single-Phase Transformer Core with Step-Lap Joints[J]. 2014, 48(4): 52-58.
张良县 1, 陈模生 1, 彭宗仁 1, 等. 一种单相阶梯接缝变压器铁芯的空载损耗计算方法[J]. 西安交通大学学报, 2014,48(4):52-58. DOI： 10.7652/xjtuxb201404010.

Algorithm for Calculating No-Load Losses of Single-Phase Transformer Core with Step-Lap Joints[J]. 2014, 48(4): 52-58. DOI： 10.7652/xjtuxb201404010.

摘要

提出了一种适用于大型单相变压器阶梯接缝结构铁芯的空载损耗计算方法。该方法首先运用等效磁特性方法对铁芯阶梯接缝区进行等效分析

得出接缝区的等效材料特性

然后将一个工作周期按等时间间隔进行划分

分别计算各个时刻铁芯的静态磁场分布

通过样条插值得到磁感应强度随时间变化的曲线

最后运用快速傅里叶变换算法对磁感应强度曲线进行离散

提取出磁感应强度各次谐波幅值

并将其在对应频率的损耗曲线上进行线性插值得到损耗值

将各单元所有损耗值进行求和得到总损耗值。以一台实际工程中的大型单相变压器为模型

分别采用提出的方法及不考虑铁芯接缝结构的传统计算方法对其空载损耗进行计算

并将计算结果与变压器空载试验的结果进行对比

结果表明

提出的方法比传统方法得到的结果更趋近于测量值

在50%～100%的额定电压范围内

精度最高可提高9.8%。

Abstract

An algorithm for calculating no-load losses of large single-phase transformer core with step-lap joints was proposed. Equivalent magnetic property method was employed to obtain the equivalent material properties of joints. A cycle was divided according to the equal time interval

and then the static magnetic flux density distribution was calculated at each instant moment. Spline-interpolated method was chosen to draw up the temporal curve of magnetic flux density. FFT analysis was used to determine the each harmonic amplitude of magnetic flux density. The losses were evaluated by linear interpolation from loss curves with corresponding frequency

and the total transformer core loss was gotten by summing losses of all elements. A large single-phase transformer used in practical project was taken as the object

and the proposed algorithm and the traditional scheme without considering joint structure were used to calculate no-load losses. The comparison with the result of no-load transformer test shows that the result from the proposed algorithm gets closer to the test data

which enables to improve the accuracy by 9.8% in the rated voltage range of 50% to 100%.

关键词

Keywords

references

周克定. 工程电磁场数值计算的理论方法及应用[M]. 北京: 高等教育出版社, 1994: 229-232.

谢毓城. 电力变压器手册[M]. 北京: 机械工业出版社, 2003: 231-238.

杜永, 程志光, 颜威利, 等. 电力变压器全斜接缝叠片铁心工作条件下的磁性能模拟[J]. 电工技术学报, 2010, 25(3): 14-19.

DU Yong, CHENG Zhiguang, YAN Weili, et al. Working magnetic property modeling of the power transformer laminated core with mitred joints[J]. Transactions of China Electrotechnical Society, 2010, 25(3): 14-19.

DU Yong, CHENG Zhiguang. Magnetic flux and iron loss modeling at laminated core joints in power transformers[J]. IEEE Transactions on Applied Superconductivity, 2010, 20(3): 1878-1882.

MOHAMMED E, MICHEL P. New transformer model including joint air gaps and lamination anisotropy[J]. IEEE Transactions on Magnetics, 1998, 34(5): 3701-3711.

ADALBERT K, JEAN F. Virtual air gap length computation with the finite-element method[J]. IEEE Transactions on Magnetics, 2007, 43(4): 1829-1832.

HIHAT N, NAPIERALSKA-JUSZCZAK E, LECOINTE J, et al. Equivalent permeability of step-lap joints of transformer cores: computational and experimental considerations[J]. IEEE Transactions on Magnetics, 2011, 47(1): 244-251.

BOTTAUSCIO O, CHIADOPIAT V, CHIAMPI M, et al. Nonlinear homogenization technique for saturable soft magnetic composites[J]. IEEE Transactions on Magnetics, 2008, 44(11): 2955-2958.

MAE A, HARADA K, ISHIHARA Y. A study of characteristic analysis of the three-phase transformer with step-lap wound-core[J]. IEEE Transactions on Magnetics, 2002, 38(2): 829-832.

TENYENHUIS E G, MECHLER G F, GIRGIS R S. Flux distribution and core loss calculation for single phase and five limb three phase transformer core designs[J]. IEEE Transactions on Power Delivery, 2000, 15(1): 204-209.

MECHLER G F, GIRGIS R S. Calculation of spatial loss distribution in stacked power and distribution transformer cores[J]. IEEE Transactions on Power Delivery, 1998, 13(2): 532-537.

程志光, 高桥则雄, 博扎德·弗甘尼. 电气工程电磁热场模拟与应用[M]. 北京: 科学出版社, 2009: 274-275.

WANG Jian, LIN Heyun, HUANG Yunkai. Numerical analysis of 3D eddy current fields in laminated media under various frequencies[J]. IEEE Transactions on Magnetics, 2012, 48(2): 267-270.

HIROYUKI K, AKIHISA K, KOJI F. FEM computation of magnetic field and iron loss in laminated iron core using homogenization method[J]. IEEE Transactions on Magnetics, 2007, 43(4): 1405-1408.

胡启凡. 变压器试验技术[M]. 北京: 中国电力出版社, 2009: 269-272.

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

三塔合一间接空冷系统结构参数对夏季运行特性的影响研究

混合电解槽阵列协同的风光耦合制氢系统双层多目标优化

语义区分和子图整合驱动的知识图谱表示学习方法

结构-语义-残差协同的图像压缩框架：面向隐私保护与高保真重建

张角凹坑气膜孔对双层壁气膜冷却特性的影响