透平叶栅非轴对称端壁优化设计

孙皓; 宋立明; 李军

doi:10.7652/xjtuxb201309006

您当前的位置：

首页 >

文章列表页 >

透平叶栅非轴对称端壁优化设计

更新时间：2025-07-09

- 透平叶栅非轴对称端壁优化设计
- Optimization Design of Nonaxisymmetrical End Wall Profiling for Turbine Cascade
- 西安交通大学学报 2013年47卷第9期页码：35-40
- 作者机构：
  
  西安交通大学叶轮机械研究所,西安,710049
- 作者简介：
- 基金信息：
  
  : 2012-12-12。作者简介: 孙皓(1982—),男,博士生;李军(通信作者),男,教授,博士生导师。基金项目: 国家自然科学基金资助项目(51106123);教育部博士点基金资助项目(20100201120010)
- DOI：10.7652/xjtuxb201309006
  中图分类号： TK263
- 网络首发：2013-09-10，
  
  纸质出版：2013
- 稿件说明：
移动端阅览
孙皓, 宋立明, 李军. 透平叶栅非轴对称端壁优化设计[J]. 西安交通大学学报, 2013,47(9):35-40.

Optimization Design of Nonaxisymmetrical End Wall Profiling for Turbine Cascade[J]. 2013, 47(9): 35-40.
孙皓, 宋立明, 李军. 透平叶栅非轴对称端壁优化设计[J]. 西安交通大学学报, 2013,47(9):35-40. DOI： 10.7652/xjtuxb201309006.

Optimization Design of Nonaxisymmetrical End Wall Profiling for Turbine Cascade[J]. 2013, 47(9): 35-40. DOI： 10.7652/xjtuxb201309006.

摘要

为减小透平叶栅二次流损失、提高气动效率

建立了结合透平叶栅非轴对称端壁造型双控制型线参数化方法、全局优化自适应差分进化算法和基于Reynolds-Averaged Navier-Stokes(RANS)方程求解技术的叶栅气动性能评价方法于一体的透平叶栅非轴对称端壁优化设计体系

同时验证了全局优化自适应差分进化算法和透平叶栅气动性能评价方法的可靠性和准确性。以透平叶栅总压恢复系数最大化为优化目标

在出口气流角和质量流量的约束及叶栅非轴对称端壁三维参数化控制点共20个设计变量下

完成了透平叶栅非轴对称端壁造型优化设计。研究结果表明

优化后得到的非轴对称端壁造型可有效减少透平叶栅的二次流损失

使叶栅总压恢复系数提高0.25%

证明所提出的设计体系是有效的

可为透平叶栅非轴对称端壁优化提供设计工具。

Abstract

Coupled with the two control curves parameterization method of turbine cascade nonaxisymmetrical end wall profiling

the global optimization method adaptive range differential evolution(ARDE)algorithm

and the Reynolds-Averaged Navier-Stokes(RANS)equation solver technique for evaluation of turbine cascade aerodynamic performance

an aerodynamic optimization design system for turbine cascade nonaxisymmetrical end wall profiling was developed to reduce its secondary flow loss and increase the aerodynamic efficiency. The feasibility and accuracy of the ARDE method and the RANS evaluation of turbine cascade were verified. The maximization of the total pressure coefficient of turbine cascade was selected as the design objective under the constraint condition of the outflow angle and mass flow rate. The design variables were the nonaxisymmetrical end wall profile parameterization variables of turbine cascade

and 20 design variables in total for optimum nonaxisymmetrical end wall profile was specified in this work. The aerodynamic design of turbine cascade with optimum nonaxisymmetrical end wall profile was conducted. The results show that

with the optimization design

the total pressure coefficient increases by 0.25% and the secondary flow loss is lower. The optimization design system developed for the turbine cascade with nonaxisymmetrical end wall profile was also validated.

关键词

Keywords

references

ROSE M G. Non-axisymmetric Endwall profiling in the HP NGVs of an axial flow gas turbine [C]∥Proceedings of ASME Turbo Expo 1994 Power for Land, Sea & Air. New York, USA: ASME, 1994: 249.

HARVEY N, ROSE M, SEAMAN P, et al. Nonaxisymmetric turbine end wall design: part Ⅰ Three-dimensional linear design system [J]. ASME Journal of Turbomachinery, 2000, 122(2): 278-285.

HARTLAND J C, SMITH D G, HARVEY N, et al. Nonaxisymmetric turbine end wall design: part Ⅱ Experimental validation [J]. ASME Journal of Turbomachinery, 2000, 122(2): 286-293.

GERMAIN T, NAGEL M G. Improving efficiency of a high work turbine using nonaxisymmetric endwalls: partⅠ Endwall design and performance [J]. ASME Journal of Turbomachinery, 2010, 132(2): 1008-1018.

李国君, 马晓永, 李军. 非轴对称端壁造型及其对叶栅损失影响的数值研究 [J]. 西安交通大学学报, 2005, 39(11): 1169-1172.

LI Guojun, MA Xiaoyong, LI Jun. Non-axisymmetric turbine end wall profiling and numerical investigation of its effect on the turbine cascade loss [J]. Journal of Xi'an Jiaotong University, 2005, 39(11): 1169-1172.

孙皓, 宋立明, 李军, 等. 小展弦比叶栅非轴对称端壁造型机及气动性能的数值研究 [J]. 西安交通大学学报, 2012, 46(11): 6-11.

SUN Hao, SONG Liming, LI Jun, et al. Numerical investigation on nonaxisymmetrical end wall profiling and aerodynamic performance of a low aspect ratio cascade [J]. Journal of Xi'an Jiaotong University, 2012, 46(11): 6-11.

高增珣, 高学林, 袁新. 透平叶栅非轴对称端壁的气动最优化设计 [J]. 工程热物理学报, 2007, 28(4): 589-591.

GAO Zengxun, Gao Xuelin, YUAN Xin. Aerodynamic optimal design of non-axisymmetric endwall for a turbine cascade [J]. Journal of Engineering Thermophysics, 2007, 28(4): 589-591.

NA Zhenzhe, LIU Bo. Application and optimization of non-axisymmetric end wall in a high pressure turbine [C]∥2012 Proceedings of 4th International Symposium on Jet Propulsion and Power Engineering. Xi'an, China: Northwest Polytechnical University Press, 2012: A0135.

SONG Liming, LUO Chang, LI Jun, et al. Aerodynamic optimization of axial turbomachinery blades using parallel adaptive range differential evolution and Reynolds-averaged Navier-Stokes solutions [J]. International Journal for Numerical Methods in Biomedical Engineering, 2011, 27(3): 283-303.

TAKEISHI K, MATSUURA M, AOKI S, et al. An experimental study of heat transfer and film cooling on low aspect ratio turbine nozzles [J] ASME Journal of Turbomachinery, 1990, 112(2): 488-496.

孙皓,宋立明,李军,等.非轴对称端壁透平级气动性能的数值研究.2013,47(7):29-35.[doi:10.7652/xjtuxb201307006]

孙皖,马斌,牛璐,等.低温透平膨胀机内平衡凝结两相流动的数值模拟.2013,47(7):36-39.[doi:10.7652/xjtuxb 201307007]

高庆,陶加银,宋立明,等.涡轮轮缘密封封严效率的数值研究.2013,47(5):12-17.[doi:10.7652/xjtuxb201305003]

蔡君伟,孙皖,李斌,等.-150 ℃逆布雷顿空气制冷机动态温降特性研究.2013,47(3):60-63.[doi:10.7652/xjtuxb201303 011]

卢娟,张朝磊,丰镇平.离散伴随气动优化设计方法的紊流扩展.2013,47(1):37-42.[doi:10.7652/xjtuxb201301008]

刘小民,周海洋.低压透平叶片流动分离主动控制的数值研究.2010,44(9):21-26.[doi:10.7652/xjtuxb201009005]

孙皓,薛志恒,李军,等.低雷诺数对透平叶片间隙泄漏流动影响的研究.2010,44(3):11-15.[doi:10.7652/xjtuxb 201003003]

王顺森,毛靖儒,刘观伟,等.透平叶栅二次流瞬态特性试验及动力学分析.2009,43(1):10-14.[doi:10.7652/xjtuxb 200901003]

王顺森,毛靖儒,刘观伟,等.透平叶栅二次流瞬态特性的新测试方法.2008,42(11):1361-1366.[doi:10.7652/xjtuxb 200811010]

吴晓明,李国君,丰镇平,等.SST k-ω-kp两相湍流模型及其在湿蒸汽凝结流动数值模拟中的应用.2007,41(5):526-529.[doi:10.7652/xjtuxb200705005]

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

燃气透平双肩壁凹槽叶顶流动传热性能优化研究

基于分层遗传算法的电力变压器优化设计

一种船用超声液位传感器的优化设计模型

离散伴随气动优化设计方法的紊流扩展

多工况下离心压气机叶轮-机匣一体联合设计优化