支路数对热泵空调中冷凝和蒸发两用换热器性能的影响

黄东 1; 陈群 2; 袁秀玲 1

您当前的位置：

首页 >

文章列表页 >

支路数对热泵空调中冷凝和蒸发两用换热器性能的影响

专题研究 | 更新时间：2025-12-08

- 支路数对热泵空调中冷凝和蒸发两用换热器性能的影响
- Effect of Circuit Number on the Indoor Coil Serving as Both Condenser and Evaporator in Heat Pump
- 西安交通大学学报 2007年41卷第5期页码：543-548
- 作者机构：
  
  西安交通大学能源与动力工程学院,西安,710049
- 作者简介：
- 基金信息：
- DOI：
  中图分类号： TB657.5
- 网络首发：2007-05-10，
  
  纸质出版：2007
- 稿件说明：
移动端阅览
黄东 1, 陈群 2, 袁秀玲 1. 支路数对热泵空调中冷凝和蒸发两用换热器性能的影响[J]. 西安交通大学学报, 2007,41(5):543-548.

黄东 1, 陈群 2, 袁秀玲 1. Effect of Circuit Number on the Indoor Coil Serving as Both Condenser and Evaporator in Heat Pump[J]. 2007, 41(5): 543-548.
黄东 1, 陈群 2, 袁秀玲 1. 支路数对热泵空调中冷凝和蒸发两用换热器性能的影响[J]. 西安交通大学学报, 2007,41(5):543-548. DOI：

黄东 1, 陈群 2, 袁秀玲 1. Effect of Circuit Number on the Indoor Coil Serving as Both Condenser and Evaporator in Heat Pump[J]. 2007, 41(5): 543-548. DOI：

摘要

在空气的进口状态和流量、换热器的几何结构尺寸、管路排布方式等相同时

研究了支路数对蒸发和冷凝两用换热器流动与传热性能的影响规律.结果表明:随支路数增多

空气与制冷剂间的传热温差会增大

但总传热系数却会变小; 室内换热器作蒸发器时

换热量先升后降

最小值比最大值小23.2%

存在使换热量最大的最佳支路数

在支路数小于或大于最佳支路数时

换热量的主导因素分别为传热温差与总传热系数; 室内换热器作冷凝器时

换热量随支路数增多单调递减

最小值比最大值小40.55%

总传热系数始终是制约换热量的主导因素.因此

为协调并同时提高制冷、制热循环的效率

需要优化热泵系统中换热器的支路数.

Abstract

The effect of the circuit number on the indoor coil in a split-type air-source heat pump is investigated numerically by EVAP-COND 2.0 version simulation package of American NIST. The indoor coil serves as an evaporator in a cooling cycle and as a condenser in a heating cycle. The simulation demonstrates that the air-and-refrigerant temperature difference increases with the circuit number

but the overall heat transfer coefficient drops. The evaporator capacity rises firstly

and then drops with the circuit number and achieves the maximum in the optimum circuit number. The minimum evaporator capacity gets less than the maximum by 23.2%. The air-and-refrigerant temperature difference and the overall heat transfer coefficient become the dominant factor governing the evaporator capacity

respectively behind and beyond the optimum circuit number. The condenser capacity always decreases with the circuit number and the overall heat transfer coefficient acts as the dominant factor. The minimum condenser capacity is less than the maximum by 40.5%. These results demonstrate that the indoor coil in a heat pump is endowed with an optimal circuit number to heighten the efficiencies and capacity in heating and cooling cycles simultaneously.

关键词

Keywords

references

Domanski P A, Yashar D, Kim M S. Performance of a finned-tube evaporator optimized for different refrigerants and its effect on system efficiency[J]. International Journal of Refrigeration, 2005, 28(6): 820-827.

Liang S Y, Wong T N, Nathan G K. Numerical and experimental studies of refrigerant circuitry of evaporator coils [J]. International Journal of Refrigeration, 2001, 24(8): 823-833.

Liang S Y, Wong T N, Nathan G K. Study on refrigerant circuitry of condenser coils with exergy destruction analysis [J]. Applied Thermal Engineering, 2000, 20(6): 559-577.

Liu M S, Leu J S. Influence of circuitry arrangement on the pressure drops of two-row finned tube evaporators [J]. ASME Journal of Energy Resources Technology, 2001,123(1): 100-103.

Wang Chi Chuan, Jang J Y, Lai C C, et al. Effect of circuit arrangement on the performance of air-cooled condensers [J]. International Journal of Refrigeration,1999, 22(4): 275-282.

Domanski P A. Simulation models for finned-tube evaporator and condenser-EVAP-COND 2.1[CP/OL]. Gaithersburg, USA: National Institute of Standards and Technology[2006-08-12].http:∥www2.bfrl.nist.gov/software/evap-cond/.

Domanski P A. Simulation of an evaporator with non-uniform one-dimensional air distribution [J]. ASHRAE Transaction, 1991, 97(1): 793-802.

Domanski P A. Finned-tube evaporator model with a visual interface [C]∥ 20th International Congress of Refrigeration. Sydney,Australia: International Institute of Refrigeration, 1999: 1-7.

Wang Chi Chuan, Chi Kuan Yu, Chang Chun Jung. Heat transfer and friction characteristics of plain fin-and-tube heat exchangers, part II: correlation [J]. International Journal of Heat Mass Transfer, 2000, 43(15):2693-2700.

Thome J R. Update on advances in flow pattern based two-phase heat transfer models[J]. Experimental Thermal and Fluid Science, 2005, 29(3):341-349.

Shah M M. General correlation for heat transfer during film condensation inside pipes [J]. International Journal of Heat Mass Transfer, 1979, 22(4):547-556.

ASHRAE. ASHRAE handbook: fundamentals volume [M]. Atlanta,USA: American Society of Heating, Refrigerating and Air Conditioning Engineers, Inc.,2001: 3-14.

Müller-Steinhagen H, Heck H K. A simple friction pressure drop correlation for two-phase flow in pipes [J]. Chemical Engineering Process, 1986, 20(6):297-308.

Chisholm D. Two-phase flow in pipelines and heat exchangers[M]. London,UK: George Godwin, 1983:304-305.

Idelchik I E. Handbook of hydraulic resistance [M].2nd ed. New York,USA: Hemisphere, 1986: 640-641.

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

R22与R410A热泵中蒸发器性能随支路数变化的比较

电动汽车R290回热-补气耦合热泵性能实验研究

流路布置对热泵空调中冷凝和蒸发两用换热器性能的影响

一种新型变浓度热泵系统的实验研究

面向高海拔空冷发电机防晕性能演化规律的电热耦合研究