不同导叶预旋角下离心压缩机的时序效应

姜华 1; 2; 席光 1; 宫武旗 1

您当前的位置：

首页 >

文章列表页 >

不同导叶预旋角下离心压缩机的时序效应

更新时间：2025-07-09

- 不同导叶预旋角下离心压缩机的时序效应
- Clocking Effect under Different Inlet Guide Vanes Prewhirl Angles in a Centrifugal Compressor
- 西安交通大学学报 2010年44卷第7期页码：120-124
- 作者机构：
  
  1. 西安交通大学能源与动力工程学院,西安,710049
  2. 西安科技大学能源学院,西安,710054
- 作者简介：
- 基金信息：
  
  : 2010-02-17. 作者简介: 姜华(1973-),女,博士生;席光(联系人),男,教授,博士生导师. 基金项目: 国家自然科学基金资助项目(50676072,50725621)
- DOI：
  中图分类号： V211.73
- 网络首发：2010-07-10，
  
  纸质出版：2010
- 稿件说明：
移动端阅览
姜华 1, 2, 席光 1, 等. 不同导叶预旋角下离心压缩机的时序效应[J]. 西安交通大学学报, 2010,44(7):120-124.

Clocking Effect under Different Inlet Guide Vanes Prewhirl Angles in a Centrifugal Compressor[J]. 2010, 44(7): 120-124.
姜华 1, 2, 席光 1, 等. 不同导叶预旋角下离心压缩机的时序效应[J]. 西安交通大学学报, 2010,44(7):120-124. DOI：

Clocking Effect under Different Inlet Guide Vanes Prewhirl Angles in a Centrifugal Compressor[J]. 2010, 44(7): 120-124. DOI：

摘要

使用X热线热膜技术

在设计流量下研究了3个不同进口导叶预旋角的时序效应对离心压缩机非定常流场的影响.结果表明:时序效应会影响离心压缩机叶轮出口和扩压器进口的流场

该影响将随着叶轮出口的距离增加而减弱.对应不同的进口导叶预旋角

时序效应对离心压缩机非定常流场的影响有所不同.对于不同的导叶时序位置

进口导叶0°预旋角下集平均径向速度发生变化的流动区域范围最大

-20°预旋角下的其次

20°预旋角下的最小.不同的导叶时序位置的集平均绝对气流角在较大范围内存在差别

其中0°预旋角下集平均绝对气流最大变化角为1.6°

20°预旋角下的最大变化角为0.9°

-20°预旋角下的最大变化角为1.2°.不同导叶时序位置的扩压器进口时均绝对气流角在0°预旋角下相差1.3°

在20°预旋角下相差不足0.5°

在-20°预旋角下相差0.84°.

Abstract

The stator clocking effect on the flow filed at three inlet guide vanes(IGV)prewhirl angles are experimentally investigated under design condition in a centrifugal compressor by X-type hot-wire/hot-film anemometry. The results show that stator clocking enables to changes the rotor discharge and the downstream stator inlet flow. The influence weakens when the distance from the rotor outlet increases. The magnitude of the clocking effect is different for different inlet guide vanes prewhirl angles. The flow range where the ensemble-averaged radial velocity changes at different stator clocking positions gets the widest under 0° prewhirl angle

next under -20°

then under 20°. The absolute flow angle changes evidently at different clocking positions. At different clocking positions

the maximum variations of unsteady absolute flow angles are respectively 1.6

0.9 and 1.2 degree under 0°

20° and -20° prewhirl angles. The variations of time-average absolute flow angle at different clocking positions are respectively 1.3

less than 0.5 and 0.84 degree under 0°

20° and -20° prewhirl angles.

关键词

Keywords

references

JOUINI D B M, LITTLE D, BANCALARI E, et al. Experimental investigation of airfoil wake clocking impacts on aerodynamic performance in a two stage turbine test rig [C]∥Proceedings of the ASME Turbo Expo 2003. Atlanta, GA, USA: American Society of Mechanical Engineers, 2003:351-358.

BILLIARD N, PANIAGUA G, DENOS R. Impact of clocking on the aero-thermodynamics of a second stator tested in a one and a half stage HP turbine [J]. Journal of Thermal Science, 2008,17(2):97-110.

BEHR T, KALFAS A I, ABHARI R S. Stator-clocking effects on the unsteady interaction of secondary flows in a 1.5-stage unshrouded turbine [J]. Journal of Power and Energy, 2007,221(6):779-792.

JIA Huixia, XI Guang, MULLER L, et al. Effect of clocking on the unsteady rotor blade loading in a low-speed axial compressor at design and off-design operating conditions [J]. Journal of Aerospace Engineering, 2008,222(6):895-906.

贾会霞.低速轴流压缩机内静叶叶列时序效应的非定常影响研究 [D].西安:西安交通大学能源与动力工程学院, 2007.

姜华,席光,张炜,等. 离心压缩机静叶间时序效应的实验研究 [J].工程热物理学报, 2009,30(6):964-966.

JIANG Hua, XI Guang, ZHANG Wei, et al. Experimental investigation of stator clocking in a centrifugal compressor [J]. Journal of Engineering Thermophysics, 2009,30(6):964-966.

ZHOU Li, XI Guang, CAI Y H. Experimental study on the influence of diffuser and inlet guide vane for the performance of centrifugal compressor [J]. Experimental Techniques, 2008,32(5):26-33.

席光,周莉,王志恒,等. 进口导叶与叶片扩压器匹配的实验研究 [J]. 西安交通大学学报, 2006,40(9):993-995.

XI Guang, ZHOU Li, WANG Zhiheng, et al. Experimental investigation to combination of simultaneous adjustment to inlet guide vanes and diffuser [J]. Journal of Xi' an Jiaotong University, 2006,40(9):993-995.

INOUE M, CUMPSTY N A. Experimental study of centrifugal impeller discharge flow in vaneless and vaned diffusers[J]. Journal of Engineering for Gas Turbines and Power, 1984,106(4):455-467.

JIANG Hua, XI Guang, ZHANG Wei, et al. An experimental investigation on the clocking effect between

inlet guide vanes and vaned diffuser in a centrifugal compressor [C]∥2008 Proceedings of ASME International Mechanical Engineering Congress and Exposition. Atlanta, GA, USA: American Society of Mechanical Engineers, 2008:67-74.

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

燃气透平双肩壁凹槽叶顶流动传热性能优化研究

离心压缩机性能预测中雷诺平均湍流模型的不确定度量化与分析

R1234ze（E）替代R134a对二级压缩循环离心压缩机及制冷性能的影响

离心压缩机级间加气的出口流场特性

结构-语义-残差协同的图像压缩框架：面向隐私保护与高保真重建