金属氢化物反应器吸氢过程的热质传递特性分析

鲍泽威 1; 杨福胜 1; 吴震 1; 张早校 1; 2

您当前的位置：

首页 >

文章列表页 >

金属氢化物反应器吸氢过程的热质传递特性分析

更新时间：2025-07-09

- 金属氢化物反应器吸氢过程的热质传递特性分析
- Analysis on Heat and Mass Transfer Characteristics of Metal Hydride Reactors During Adsorption
- 西安交通大学学报 2012年46卷第9期页码：49-54
- 作者机构：
  
  西安交通大学动力工程多相流国家重点实验室,西安,710049
- 作者简介：
- 基金信息：
  
  : 2012-03-27. 作者简介: 鲍泽威(1985-),男,博士生;张早校(通信作者),男,教授,博士生导师. 基金项目: 国家自然科学基金资助项目(51106118);高等学校博士学科点专项科研基金资助项目(20100201110007);苏州市应用基础研究计划资助项目(SYG201019)
- DOI：
  中图分类号： TQ052.5
- 网络首发：2012-09-10，
  
  纸质出版：2012
- 稿件说明：
移动端阅览
鲍泽威 1, 杨福胜 1, 吴震 1, 等. 金属氢化物反应器吸氢过程的热质传递特性分析[J]. 西安交通大学学报, 2012,46(9):49-54.

Analysis on Heat and Mass Transfer Characteristics of Metal Hydride Reactors During Adsorption[J]. 2012, 46(9): 49-54.
鲍泽威 1, 杨福胜 1, 吴震 1, 等. 金属氢化物反应器吸氢过程的热质传递特性分析[J]. 西安交通大学学报, 2012,46(9):49-54. DOI：

Analysis on Heat and Mass Transfer Characteristics of Metal Hydride Reactors During Adsorption[J]. 2012, 46(9): 49-54. DOI：

摘要

为了研究金属氢化物反应器内吸氢过程的热质传递特性

建立了圆柱形反应器的二维多物理场模型.新建立的模型考虑了换热流体流速与温度变化对反应器吸氢过程的影响

采用COMSOL Multiphysics V3.5a软件来求解

并探讨了一些重要参数变化对反应器性能的影响.结果表明:接近换热管壁处的氢化物床的温度较低

吸氢反应更快

换热流体入口附近床层的吸氢反应比出口附近的快; 减小氢化物床层与换热管壁面之间的接触热阻和增加氢化物床层有效导热系数都可以增强换热效果

从而加快吸氢反应

当接触热阻从0.002 m

·K/W减小到0.000 5 m

·K/W时

吸氢反应时间大约缩短了15.5%; 采用强化换热措施可以减少吸氢反应时间

提高反应器平均功率.

Abstract

The two-dimensional multi-physics model of a cylindrical metal hydride reactor during adsorption was presented to study heat and mass transfer characteristics of metal hydride reactors. In this model

the effects of velocity and temperature changes of heat transfer fluid on the hydrogen adsorption process were considered. The model was numerically solved using the COMSOL Multiphysics V3.5a

and the effects of some important parameters on the reactor performance were discussed. The results show that the hydrogen adsorption reaction is faster near the heat exchanger tube wall where the bed temperature is lower. Moreover

the reacted fraction of the bed near the heat transfer fluid inlet is higher than that near the outlet. Both reducing the thermal contact resistance between the hydride bed and the heat exchanger tube wall and

increasing the effective thermal conductivity of the hydride bed can improve the heat transfer performance and accelerate the adsorption process. When the thermal contact resistance decreases from 0.002 m

·K/W to 0.000 5 m

·K/W

the hydriding time drops by about 15.5%. For metal hydride reactors

adopting heat transfer enhancement measures can reduce the hydriding time and increase the average power.

关键词

Keywords

references

梁博,张早校,王玉琪.升温型金属氢化物热泵性能分析[J].西安交通大学学报,2004,38(1):89-92.

LIANG Bo,ZHANG Zaoxiao,WANG Yuqi.Performance analysis to metal hydride heat pumps for temperature upgrading [J].Journal of Xi'an Jiaotong University,2004,38(1):89-92.

MUTHUKUMAR P,GROLL M.Metal hydride based heating and cooling systems: a review [J].International Journal of Hydrogen Energy,2010,35(8):3817-3831.

CAO D L,CHEN D M,LIU Y,et al. Structure and hydrogen storage performance of LaNi4.25Al0.75 alloy [J].Transactions of Nonferrous Metals Society of China,2011,21(3):517-522.

阳明,覃峰,陈江平,等.新型金属氢化物板式反应床的传热特性[J].上海交通大学学报,2009,43(9):1456-1460.

YANG Ming,QIN Feng,CHEN Jiangping, et al. Heat transfer characteristic for a new plate metal hydride reactor [J].Journal of Shanghai Jiaotong University, 2009,43(9):1456-1460.

YANG F S,WANG G X,ZHANG Z X,et al.Design of the metal hydride reactors: a review on the key technical issues [J].International Journal of Hydrogen Energy,2010,35(8): 3832-3840.

El-OSERY I A.Theory of the computer code RET1 for the calculation of space-time dependent temperature and composition properties of metal hydride hydrogen storage beds [J].International Journal of Hydrogen Energy,1983,8(3):191-198.

JEMNI A,NASRALLAH S B.Study of two-dimensional heat and mass transfer during absorption in a metal-hydrogen reactor [J].International Journal of Hydrogen Energy,1995,20(1):43-52.

JEMNI A,NASRALLAH S B,LAMLOUMI J.Experimental and theoretical study of a metal-hydrogen reactor [J].International Journal of Hydrogen Energy,1999,24(7):631-644.

ALDA K,MAT M D,KAPLAN Y.A three-dimensional mathematical model for absorption in a metal hydride bed [J].International Journal of Hydrogen Energy,1999, 27(10):1049-1056.

王玉琪,杨福胜,张早校,等.金属氢化物反应器的设计与过程模拟[J].西安交通大学学报,2006,40(7):831-835.

WANG Yuqi,YANG Fusheng,ZHANG Zaoxiao,et al.Design and process simulation of metal hydride reactors [J].Journal of Xi'an Jiaotong University,2006,40(7):831-835.

MACDONALD B D,ROWE A M.A thermally coupled metal hydride hydrogen storage and fuel cell system [J].Journal of Power Sources,2006,161(1):346-355.

YE J H,JIANG L J,LI Z N,et al.Numerical analysis of heat and mass transfer during absorption of hydrogen in metal hydride based hydrogen storage tanks [J].International Journal of Hydrogen Energy,2010,35(15):8216-8224.

YANG F S,MENG X Y,DENG J Q,et al.Identifying heat and mass transfer characteristics of metal hydride reactor during adsorption: improved formulation and further discussion about parameter analysis [J].International Journal of Hydrogen Energy,2009,34(4):1852-1861.

JOSEPHY Y, BERSHADSKY E, RON M.Investigation of LaNi5 after prolonged cycling [J].Journal of the Less-Common Metals,1991,172/173/174(3):997-1008.

MACDONALD B D, ROWE A M.Impacts of external heat transfer enhancements on metal hydride storage tanks [J].International Journal of Hydrogen Energy,2006,31(12):1721-1731.

WANG Y Q,YANG F S,MENG X Y,et al.Simulation study on the reaction process based single stage metal hydride thermal compressor [J].International Journal of Hydrogen Energy,2010,35(1):321-328.

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

金属氢化物热泵反应器吸氢过程的温度变化特性

月壤水冰原位开采过程中热质传递特性数值研究

多端口进料微型管式重整制氢反应器性能研究

面向高海拔空冷发电机防晕性能演化规律的电热耦合研究

水蒸气掺混对氨裂解气旋流燃烧与排放特性的影响研究