不同导叶预旋角下离心压缩机径向间隙区雷诺应力的测量

姜华 1; 席光 2

您当前的位置：

首页 >

文章列表页 >

不同导叶预旋角下离心压缩机径向间隙区雷诺应力的测量

更新时间：2025-07-09

- 不同导叶预旋角下离心压缩机径向间隙区雷诺应力的测量
- Measurements for Reynolds Stresses under Different Inlet Prewhirl in Centrifugal Compressor
- 西安交通大学学报 2012年46卷第4期页码：125-131
- 作者机构：
  
  西安科技大学能源学院,西安,710054
- 作者简介：
- 基金信息：
  
  : 2011-09-01. 作者简介: 姜华(1973-),女,副教授;席光(通信作者),男,教授,博士生导师. 基金项目: 国家自然科学基金资助项目(50725621);西安科技大学培育基金资助项目(2010048)
- DOI：
  中图分类号： V211.73
- 网络首发：2012-04-10，
  
  纸质出版：2012
- 稿件说明：
移动端阅览
姜华 1, 席光 2. 不同导叶预旋角下离心压缩机径向间隙区雷诺应力的测量[J]. 西安交通大学学报, 2012,46(4):125-131.

Measurements for Reynolds Stresses under Different Inlet Prewhirl in Centrifugal Compressor[J]. 2012, 46(4): 125-131.
姜华 1, 席光 2. 不同导叶预旋角下离心压缩机径向间隙区雷诺应力的测量[J]. 西安交通大学学报, 2012,46(4):125-131. DOI：

Measurements for Reynolds Stresses under Different Inlet Prewhirl in Centrifugal Compressor[J]. 2012, 46(4): 125-131. DOI：

摘要

使用X热膜技术

研究了离心压缩机设计流量下3个不同进口导叶预旋角对径向间隙区雷诺应力的影响.结果表明:进口导叶为-20°时

径向间隙区的湍流强度和雷诺应力最大

0°预旋角其次

20°预旋角最小; 湍动能大的区域

相应的雷诺剪应力也较大.在3个预旋角下

10%和50%叶高处的时间平均径向雷诺应力均明显大于切向雷诺应力

显示出明显的流动各向异性

叶轮出口处的时间平均径向雷诺应力为切向雷诺应力的1.5倍以上

但在扩压器进口处减少到1.25倍左右; 90%叶高处的时间平均径向雷诺应力和切向雷诺应力值相差不到10%

流动更接近各向同性.0°预旋角下流动的各向异性最强.研究显示

需要更好的湍流模型来预测流动中复杂的混合过程.

Abstract

The effects of inlet guide vanes(IGV)prewhirl angles on Reynolds stresses in radial gap between impeller and vane diffuser in a centrifugal compressor are experimentally investigated under design condition by X-type hot-film anemometry. The results show that the levels of the turbulence intensity and the Reynolds stresses in the radial gap get the highest under -20°of prewhirl angle

while they are moderate at 0°and the lowest at 20°of prewhirl angles. High levels of Reynolds shear stresses look to be related with high levels of turbulence kinetic energy

or vice versa. In the lengths of 10% and 50% spanwise

at three prewhirl angles

the time-average Reynolds stresses in the radial direction are obviously larger than that in the tangential direction to indicate the significant anisotropy of turbulence. At the impeller outlet

the time-average Reynolds stresses in the radial direction are above 1.5 times larger than those in the tangential direction

and this ratio decreases to 1.25 at the diffuser inlet. However

in the length of 90% spanwise

the turbulence is close to isotropy since the difference of the Reynolds stresses in two directions is less than 10%. The degree of turbulence anisotropy at 0°of prewhirl angle is higher than those under other two prewhirl angles.

关键词

Keywords

references

徐忠. 离心压缩机原理[M]. 北京: 机械工业出版社, 1990:15-35.

WELCH G E. Determination of critical sector angle of inlet swirl distortion using actuator-duct model [C]∥43rd AIAA/ASME/SAE/ASEE Joint Propulsion Conference. Cincinnati, OH, USA: American Institute of Aeronautics and Astronautics Inc., 2007:595-615.

TOYOTAKA S, HEINZ-ADOLF S. Aerodynamic characteristics of supercritical outlet guide vanes at low Reynolds number conditions [J]. Journal of Turbomachinery, 2007, 129(4): 694-704.

席光,周莉,王志恒,等. 进口导叶与叶片扩压器匹配的实验研究[J]. 西安交通大学学报,2006,40(9): 993-995.

XI Guang, ZHOU Li, WANG Zhiheng,et al. Experimental investigation to combination of simultaneous adjustment to inlet guide vanes and diffuser[J]. Journal of Xi'an Jiaotong University, 2006,40(9): 993-995.

KASSENS I, RAUTENBERG M. Flow measurements behind the inlet guide vane of a centrifugal compressor[C]∥Proceedings of the 1998 International Gas Turbine Aeroengine Congress Exhibition. Stockholm, Sweden: ASME Fairfield NJ United States, 1998: 1-8.

周莉,蔡元虎.离心压缩机内进口导叶后面流场的实验研究[J].实验流体力学,2008,22(1): 17-20.

ZHOU Li, CAI Yuanhu. Experimental investigation of the flow field behind the inlet guide vane of the centrifugal compressor[J]. Journal of Experiments in Fluid Mechanics, 2008, 22(1): 17-20.

MARCONCINI M, PACCIANI R. Numerical investigation of wake-shock interactions and clocking in a transonic HP turbine [C]∥American Society of Mechanical Engineers, International Gas Turbine Institute. Atlanta, GA, USA: American Society of Mechanical Engineers, 2003: 235-243.

GAO Limin, XI Guang, ZHOU Li, et al. Experimental and computational investigation of a centrifugal compressor stage[J]. Journal of Power and Energy,2005,219(1):25-33.

ZHOU Li, XI Guang, CAI Yuanhu. Unsteady numerical simulation in a centrifugal compressor using the time-inclined operator[J]. Journal of Aerospace Engineering, 2007,221(5):795-804.

JIANG Hua, XI Guang, ZHANG Wei, et al. An experimental investigation on the clocking effect between inlet guide vanes and vaned diffuser in a centrifugal compressor[C]∥2008 Proceedings of ASME International Mechanical Engineering Congress and Exposition. Boston, Massachusetts, USA: American Society of Mechanical Engineers, 2009: 67-74.

MAILACH R, VOQELER K. Aerodynamic blade row interactions in an axial compressor: Part Ⅰ unsteady boundary layer development [J]. Journal of Turbomachinery, 2004, 126(1): 35-44.

ALI P, GULEREN K M, OZTURK A. Measurements of Reynolds stresses in centrifugal compressor vaned diffusers[J]. Journal of Mechanical Engineering Science, 2008, 222(8):1487-1503.

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

添加CO2对密闭空间氢气-空气湍流混合气爆炸燃烧特性的影响

离心压缩机性能预测中雷诺平均湍流模型的不确定度量化与分析

R1234ze（E）替代R134a对二级压缩循环离心压缩机及制冷性能的影响

离心压缩机级间加气的出口流场特性

采用试验设计方法的第三代CO2气体箔轴承箔片几何参数敏感性分析