静叶斜置对高参数汽轮机再热后第一级叶栅冲蚀的影响

蔡柳溪 1; 王顺森 1; 毛靖儒 1; 丰镇平 1; 张俊杰 2; 徐亚涛 2

您当前的位置：

首页 >

文章列表页 >

静叶斜置对高参数汽轮机再热后第一级叶栅冲蚀的影响

更新时间：2025-07-09

- 静叶斜置对高参数汽轮机再热后第一级叶栅冲蚀的影响
- Influence of Oblique Stator on Erosion Characteristics of Solid Particles in the First Reheat Stage Blades of a Supercritical Steam Turbine
- 西安交通大学学报 2012年46卷第7期页码：12-15+107
- 作者机构：
  
  西安交通大学叶轮机械研究所,西安,710049
- 作者简介：
- 基金信息：
- DOI：
  中图分类号： TK262
- 网络首发：2012-07-10，
  
  纸质出版：2012
- 稿件说明：
移动端阅览
蔡柳溪 1, 王顺森 1, 毛靖儒 1, 等. 静叶斜置对高参数汽轮机再热后第一级叶栅冲蚀的影响[J]. 西安交通大学学报, 2012,46(7):12-15+107.

Influence of Oblique Stator on Erosion Characteristics of Solid Particles in the First Reheat Stage Blades of a Supercritical Steam Turbine[J]. 2012, 46(7): 12-15+107.
蔡柳溪 1, 王顺森 1, 毛靖儒 1, 等. 静叶斜置对高参数汽轮机再热后第一级叶栅冲蚀的影响[J]. 西安交通大学学报, 2012,46(7):12-15+107. DOI：

Influence of Oblique Stator on Erosion Characteristics of Solid Particles in the First Reheat Stage Blades of a Supercritical Steam Turbine[J]. 2012, 46(7): 12-15+107. DOI：

摘要

在高温、高速加速冲蚀试验结果所建立的叶栅材料冲蚀率模型和粒子反弹模型的基础上

利用三维数值计算法模拟、分析了静叶斜置对超临界及超超临界汽轮机再热后第一级叶栅冲蚀特性的影响.结果表明:再热后第一级静叶斜置角度为30°时

静叶压力面最大冲蚀失重减小了约30%

吸力面尾缘的冲蚀破坏明显减轻

级效率仅下降0.1%; 进一步增大斜置角度

再热后第一级叶栅抗磨性能提升并不明显

级效率下降了1%; 减小斜置角度会使静叶压力面最大冲蚀失重增加23%

叶栅抗磨性能显著降低.该研究结果可为减轻再热后第一级叶栅的冲蚀破坏提供技术依据.

Abstract

From the blade material erosion models and the particle rebound models produced by the high temperature and high speed accelerated erosion test results

the simulations and analyses were performed on the influence of the oblique stator on the erosion characteristics of solid particles in the first reheat stage of an ultra-supercritical steam turbine by the 3D numerical computing method. The results show that when the oblique angle of the oblique stator in first reheat stage is 30 degrees

the maximum weight loss on the vane pressure surface drops by about 30% and the erosion damage to the trailing edge on the vane suction surface also decreases obviously

and the stage efficiency decreases by only 0.1%. The further increase in the oblique angle may enhance the blade anti-wear property slightly but reduce stage efficiency by 1%. However

the decrease in the oblique angle will increase the maximum weight loss on the vane pressure surface by 23%

leading to a significant reduction in the blade anti-wear property. The results of this study will provide a technical basis for reducing the erosion on first reheat stages.

关键词

Keywords

references

KAWAGISHI H, KAWASSAKI S. Protective design and boride coating against solid particle erosion of first-stage turbine nozzles [C]∥International Joint Power Generation Conference. New York, USA: ASME, 1990: 23-29.

OKA Y I, OHNOGI H. The impact angle dependence of erosion damage caused by solid particle impact [J]. Wear, 1997, 203/204: 573-579.

KHAIMOV V A, KACHURINER Y Y. Erosion wear caused by coarse particles in the flow-through part of the medium-pressure stage of T-250/300-240 turbines [J]. Power Technology and Engineering, 2004,38(5):14-20.

刘响江. 超超临界汽轮机固粒侵蚀和汽流激振分析[J]. 华北电力技术, 2006(4):35-37.

LIU Xiangjiang. Analysis on SPE and steam flow excited vibration of ultra supercritical steam turbine [J]. North China Electric Power, 2006(4): 35-36.

戴丽萍,俞茂铮. 超临界汽轮机再热第一级叶片固粒冲蚀特性的数值分析[J]. 热能动力工程, 2004, 19(4): 347-350.

DAI Liping, YU Maozheng. Numerical analysis of the erosion characteristics of solid particles in the first reheat stage blades of a supercritical steam turbine [J]. Journal of Engineering for Thermal Energy and Power, 2004, 19(4): 347-350.

何阿平,彭泽瑛. 上汽-西门子型百万千瓦超超临界汽轮 [J]. 热力透平, 2006, 35(1): 1-7.

HE Aping, PENG Zeying. Ultra supercritical 1 000 MW steam turbine designed by STC and Siemens [J]. Thermal Turbine, 2006, 35(1): 1-7.

李成勤,阳虹. 1 000 MW超超临界汽轮机中压缸第一级斜置静叶的数值模拟研究 [J]. 汽轮机技术, 2009, 5(1): 42-44.

LI Chengqin, YANG Hong. Numerical simulation on the first stage oblique stator in the intermediate press-ure cylinder of 1 000 MW ultra super-critical steam turbine [J]. Turbine Technology, 2009, 51(1): 42-44.

杨建. 汽轮机中高压缸进口斜置导叶流场的数值研究[D]. 上海:上海交通大学, 2010: 16-40.

FORDER A, THEW M, HARRISON D. A numerical investigation of solid particle erosion experienced within oilfield control valves [J]. Wear, 1998, 216(2): 184-193.

GRANT G, TABAKOFF W. Erosion prediction in turbomachinery resulting from environmental solid particles [J]. Journal of Aircraft, 1975, 12(5): 471-478.

BEACHER B, TABAKOFF W, HAMED A. Improved particle trajectory calculations through turbomachinery affected by coal ash particles [J].Journal of Engineering for Power, 1982, 104(1): 64-68.

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

液氢管路输运中静电积聚机理与电流密度分布特征研究

X射线辐照下聚酰亚胺材料空间电荷分布特性的数值模拟

异质裂隙内超临界CO2地热提取特性数值模拟研究

工质与叶轮传热对超临界二氧化碳向心透平气动性能与流动特性的作用机制

机翼近场尾流流动特性的附着涡模型分析