西安交通大学电气工程学院,西安,710049
网络首发:2009-06-10,
纸质出版:2009
移动端阅览
王润新, 刘进军, 侯丹. 用于实现互联系统仿真的电源模块大信号模型[J]. 西安交通大学学报, 2009,43(6):76-81.
Large-Signal Model of Power Supply Modules for Implementing Inter-Connected System Simulations[J]. 2009, 43(6): 76-81.
提出一种新的针对双环控制结构电源模块(含连续导通模式功率因数校正器模块和电流模式控制DC-DC模块)的大信号建模方法
目的在于克服互联系统单纯采用开关模型实现仿真时遇到的困难.该方法利用双环控制系统中内环响应速度快、外环控制器所给出的指令信号变化缓慢这一特点
将内环闭环传输特性用比例环节等效实现; 利用平均意义下的瞬时功率平衡关系
用模拟主电路功率流动规律的代数运算单元替代含有复杂开关过程的主电路.以上方法简化了控制电路
避开了耗时的开关过程
最终使双环控制的开关系统转化成为单环控制的以连续平均量为变量的非线性系统.仿真结果表明
在保证准确反映电源模块端口特性的同时
采用本文模型仿真
较之采用开关模型
仿真速度显著加快.
Pursuing rapid simulation speed and requiring reflection of more circuit details are always contradictory in computer simulations
especially for those of complex circuits such as a distributed power system. Simplified models of power supply modules are expected to establish a balance between above two requirements in implementing inter-connected system simulations. After discussing the difficulties in attempting to simulate inter-connected systems with switching models
the features of double-loop controlled power supply modules are investigated
in which cover a range of modules including continuous conduction mode(CCM)power factor correction(PFC)rectifiers and current mode controlled dc-dc converters. A new modeling approach is proposed
which the main idea is to simplify the double-loop controlling structure to a single-loop oneby equating the inner current loop with a proportional gain block and furthermore treating the power stage as a power conservation unit that only externally represents the averaged voltage-ampere relations at both input and output ports through arithmetic calculation. A double-loop controlled switching system is transformed to a single-loop controlled non-linear system with continuous averaged variables in the proposed approach. The validity of the proposed model is verified by comparing the simulation speed and waveforms obtained respectively from switching models and the proposed model.
LIU Jinjun, WILSON T G, ZHAO Q, et al. Large-signal model of a downstream DC/DC converter foranalysis and design of front-end PFC rectifier using computer simulation[C]∥Proceedings of the 18th Annual Applied Power Electronics Conference and Exposition. Piscataway, NJ, USA: IEEE, 2003: 1002-1007.
ALTOWATI A, SUNTIO T, ZENGER K. Input filter interactions in multi-module parallel switching-mode power supplies[C]∥Proceedings of International Conference on Industrial Technology. Piscataway,N J, USA: IEEE, 2005: 851-856.
郭立芝, 赵录怀. 计及动作时间的开关模型及其应用[J]. 西安交通大学学报, 2003, 37(12): 1284-1287.
GUO Lizhi,ZHAO Luhuai. New model of switches taking account of switching interval and its application[J]. Journal of Xi'an Jiaotong University,2003,37(12):1284-1287.
THOTTUVELL V J, CHIN D, VERGHESE G C. Hierarchical approaches to modeling high-power-factor AC-DC converters[J]. IEEE Transactions on Power Electronics, 1991, 6(2): 179-187.
WANG Runxin, LIU Jinjun, WANG Hao, et al. Multi-level modeling of PFC rectifier and dc-dc converter modules in inter-connected switching power supply systems[C]∥Proceedings of the 22nd Annual Applied Power Electronics Conference and Exposition. Piscataway, NJ, USA: IEEE, 2007: 1475-1479.
胡寿松. 自动控制原理[M]. 4版. 北京: 科学出版社, 2001:118-133.
Simplis Technologies Inc. SIMPLIS reference manual[M]. Thatcham, UK: Cantena Software Ltd., 2008: 117-169.
WONG S C, TSE C K, ORABI M, et al. The method of double averaging: an approach for modeling power-factor-correction power converters[J]. IEEE Transactions on Circuits and Systems: I, 2006, 53(2): 454-462.
WANG Runxin, LIU Jinjun, WANG Hao, et al. Small-signal analysis of the lower-frequency power transfer model[C]∥Proceedings of the 7th International Conference on Power Electronics. Piscataway, NJ, USA: IEEE, 2008: 102-106.
电流型单端初级电感变换器的不稳定性与分岔控制.2007,41(12):1465-1469.
Boost变换器的输出纹波电压分析与最小电感设计.2007,41(6):707-711.
Buck-Boost DC/DC变换器中边界碰撞分岔现象的实验研究. 2006,40(4):454-458.
0
浏览量
4
下载量
6
CSCD
关联资源
相关文章
相关作者
相关机构
京公网安备11010802024621