多悬臂梁压电振子频率分析及发电实验研究

谢涛; 袁江波; 单小彪; 陈维山

您当前的位置：

首页 >

文章列表页 >

多悬臂梁压电振子频率分析及发电实验研究

更新时间：2025-07-09

- 多悬臂梁压电振子频率分析及发电实验研究
- Frequency Analysis and Electricity Generated by Multiple Piezoelectric Cantilevers in Energy Harvesting
- 西安交通大学学报 2010年44卷第2期页码：98-101+107
- 作者机构：
  
  哈尔滨工业大学机电工程学院,哈尔滨,150001
- 作者简介：
- 基金信息：
  
  : 2009-09-08. 作者简介: 谢涛(1965-),男,教授,博士生导师. 基金项目: 国家自然科学基金资助项目(50875057);哈尔滨工业大学科研创新基金资助项目(HIT.NSRIF 2008.50)
- DOI：
  中图分类号： TM619
- 网络首发：2010-02-10，
  
  纸质出版：2010
- 稿件说明：
移动端阅览
谢涛, 袁江波, 单小彪, 等. 多悬臂梁压电振子频率分析及发电实验研究[J]. 西安交通大学学报, 2010,44(2):98-101+107.

Frequency Analysis and Electricity Generated by Multiple Piezoelectric Cantilevers in Energy Harvesting[J]. 2010, 44(2): 98-101+107.
谢涛, 袁江波, 单小彪, 等. 多悬臂梁压电振子频率分析及发电实验研究[J]. 西安交通大学学报, 2010,44(2):98-101+107. DOI：

Frequency Analysis and Electricity Generated by Multiple Piezoelectric Cantilevers in Energy Harvesting[J]. 2010, 44(2): 98-101+107. DOI：

摘要

为了提高悬臂梁压电振子的发电能力

设计并制作了多悬臂梁压电振子

采用有限元方法对多悬臂梁压电振子的有效工作频率进行了仿真分析

并且进行了实验验证.在此基础上

对多悬臂梁压电发电装置进行了压电发电实验测试.研究结果表明

多悬臂梁压电振子工作的谐振频率范围为56～65 Hz

与实验结果基本吻合.相比于单悬臂梁压电振子

多悬臂梁压电振子能有效地拓宽其谐振频带并提高压电发电能力.当多悬臂梁压电振子外接负载为820 Ω、工作频率为60 Hz时

多悬臂梁压电发电装置的最大输出功率达到4.9 mW

产生的能量能够满足网络传感器等低耗能电子产品的供能需求.

Abstract

To improve the performance of the piezoelectric cantilever in energy harvesting

multiple piezoelectric cantilevers(PECS)were manufactured. The resonance frequency of PECS was analyzed by FEM and tested by experiments. It is found that the calculated results are in good agreement with the experimental results. Compared with a single piezoelectric cantilever

the PECS can effectively increase the band of resonance frequency. A maximal output power of 4.9 mW can be obtained from the PECS at 60 Hz across a resistive load of 820 Ω

which is enough for some wireless communication systems.

关键词

Keywords

references

JIANG Shunong, LI Xianfang, GUO, Shaohua, et al. Performance of a piezoelectricbimorph for scavenging vibration energy [J]. Smart Mater Struct, 2005,14: 769-774.

JIANG Shunong, HU Yuantai. Analysis of a piezoelectric bimorph plate with a central-attached mass as an energy harvester [J]. IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 2007, 54(7): 1463-1469.

HU Yuantai, XUE Huan,HU Hongping, et al. A piezoelectric power harvester with adjustable frequency through axial preloads[J]. Smart Mater Struct, 2007,16:1961-1966.

HU Yuantai, XUE Huan, HU Ting, et al. Nonlinear interface between the piezoelectric harvesting structure and the modulating circuit of an energy harvester with a real storage battery [J]. IEEE Transactions on Ultrasonics, Ferroelectr, and Frequency Control, 2008, 55(1):148-160.

NG T H, LIAO W H. Sensitivity analysis and energy harvesting for self-powered piezoelectric sensor[J]. Journal of Intelligent Material Systems and Structures, 2005, 16(10):785-797.

阚君武,唐可洪,任玉,等.Energy efficiency of piezoelectric monomorph cantilever generator[J].光学精密工程,2008,16(12):2389-2405.

HAN Junwu, TANG Kehong, REN Yu, et al. Energy efficiency of piezoelectric monomorph cantilever generator [J]. Optics and Precision Engineering, 2008, 16(12): 2389-2405.

袁江波, 单小彪, 谢涛, 等. 悬臂梁单晶压电发电机的实验[J]. 光学精密工程, 2009, 17(5): 72-76.

YUAN Jiangbo, SHAN Xiaobiao, XIE Tao, et al. Experiment of monocrystal piezoelectric generator with cantilever beam structure [J]. Optics and Precision Engineering, 2009, 17(5): 72-76.

程光明,庞建志,唐可洪,等. 压电陶瓷发电能力测试系统的研制[J].吉林大学学报:工学版, 2007, 37(2):367-371.

CHENG Guangming, PANG Jianzhi, TANG Kehong, et al. Development of measuring system for electricity generating capacity of piezoelectric ceramics[J].Journal of Jilin University: Engineering and Technology Edition, 2007,37(2):367-371.

阚君武, 唐可洪, 王淑云, 等. 压电悬臂梁发电装置的建模与仿真分析[J]. 光学精密工程, 2008, 16(1): 71-75.

HAN Junwu, TANG Kehong, WANG Shuyun, et al. Modeling and simulation of piezoelectric cantilever generators[J]. Optics and Precision Engineering, 2008, 16(1): 71-75.

曲远方. 功能陶瓷的物理性能[M]. 北京:化学工业出社,2007: 183-185.

胡洪平. 低频压电俘能器研究[D].湖北:华中科技大学电气工程学院,2006.

石胜君,陈维山,刘军考,等. 一种基于纵弯夹心式换能器的直线超声电机[J]. 中国电机工程学报, 2007,27(18):30-35.

SHI Shengjun, CHEN Weishan, LIU Junkao, et al.Ultrasonic linear motor using longitudinal and bending multimode bolt-clamped Langevin type transducer[J].Proceedings of the CSEE, 2007, 27(18):30-35.

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

考虑接触热阻与对流换热系数修正的滚珠丝杠副温升建模与分析

涡轮叶片裂纹方位角的三维叶尖间隙动态响应特性研究

圆柱壳高频弯曲振动的能量有限元分析

越江隧道泥水盾构施工引起地层移动的有限元分析

螺栓被连接件刚度理论的计算方法