旋转机械轴类间隙内风阻损失及流动特性研究

刘滨; 赵卓斌; 邓清华; 李军

doi:null

您当前的位置：

首页 >

文章列表页 >

旋转机械轴类间隙内风阻损失及流动特性研究

更新时间：2026-06-16

- 旋转机械轴类间隙内风阻损失及流动特性研究
- Windage Loss and Flow Characteristics in Shaft-type Gap of Rotating Machinery
- 西安交通大学学报 2026年
- 作者机构：
  
  西安交通大学能源与动力工程学院，710049，西安
- 作者简介：
- 基金信息：
  
  国家重点研发计划资助项目(2023YFB4102203);国家自然科学基金联合基金资助项目。(U20A20303)
- DOI：
  中图分类号： TK14
- 收稿：2026-01-07，
  
  修回：2026-03-19，
  
  录用：2026-03-23，
- 稿件说明：
移动端阅览
刘滨, 赵卓斌, 邓清华, 等. 旋转机械轴类间隙内风阻损失及流动特性研究[J/OL]. 西安交通大学学报, 2026.

LIU Bin, ZHAO Zhuobin, DENG Qinghua, et al. Windage Loss and Flow Characteristics in Shaft-type Gap of Rotating Machinery[J/OL]. JOURNAL OF XI’AN JIAOTONG UNIVERSITY, 2026.
刘滨, 赵卓斌, 邓清华, 等. 旋转机械轴类间隙内风阻损失及流动特性研究[J/OL]. 西安交通大学学报, 2026. DOI：

LIU Bin, ZHAO Zhuobin, DENG Qinghua, et al. Windage Loss and Flow Characteristics in Shaft-type Gap of Rotating Machinery[J/OL]. JOURNAL OF XI’AN JIAOTONG UNIVERSITY, 2026. DOI：

摘要

为厘清宽间隙半径条件下轴类转静间隙内风阻损失和流动特性的影响机制，基于数值方法系统分析了间隙半径比、转子半径、转子转速等关键参数对风阻损失系数的影响规律，揭示了间隙半径比在1.3范围内的流动机理，提出了最佳间隙半径比的预测方法，构建了宽间隙半径比范围的风阻损失系数模型。结果表明：间隙半径比对风阻损失系数的影响机制主要包括壁面剪切作用以及流体内部的耗散效应。当间隙半径比较小时剪切作用占主导，当间隙半径比较大时流体内部的耗散效应为主要因素。随间隙半径比增加，风阻损失系数先减小后增大，存在使得风阻损失系数最小的最佳间隙半径比。随着转子半径增大，最佳间隙半径比逐渐减小，当转子半径由20 mm增大至60 mm时，最佳间隙半径比由0.425降低至0.167。基于本文数值模拟结果，分别提出了轴类转静间隙的最佳间隙半径比预测方法及宽间隙半径比范围的风阻损失系数模型，其最大预测偏差分别为5.58%和11.81%。本文研究结果为宽间隙半径比条件下轴类转静间隙内的风阻损失研究以及间隙结构优化提供了技术支撑。

Abstract

To clarify the influence mechanism of windage loss and flow characteristics in shaft-type rotor and stator gap under the condition of wider gap-radius ratio

systematically analyzing the influence rules of key parameters

such as gap-radius ratio

rotor radius

and rotor rotational speed on the windage loss coefficient based on numerical methods. That reveals the flow mechanism with the range of gap-radius ratio less than 1.3

proposes a prediction method for the optimal gap-radius ratio

and develops a windage loss coefficient model for wider range of gap-radius ratio. The results show that

the influence mechanism of the gap-radius ratio on the windage loss coefficient mainly includes wall shear effects and dissipative effects inside the fluid. At smaller gap-radius ratio

the shear effect dominates

while at larger gap-radius ratio

the dissipative effects inside the fluid become the primary factor. The windage loss coefficient first decreases and then increases as the gap-radius ratio increases

with an optimal gap-radius ratio which minimizes the windage loss coefficient. As the rotor radius increases

the optimal gap-radius ratio gradually decreases. When the rotor radius increases from 20 mm to 60 mm

the optimal gap radius ratio decreases from 0.425 to 0.167. Based on the present numerical results

a method for predicting the optimal gap-radius ratio for shaft-type rotor and stator gap and a model for the windage loss coefficient in wide gap-radius ratio were proposed

with maximum prediction deviations of 5.58% and 11.81%

respectively. The research results provide technical support for the study of windage loss and gap structure optimization in shaft-type rotor and stator gap with wider gap-radius ratio.

关键词

Keywords

references

TAYLOR G . Stability of a Viscous liquid contained between two rotating cylinders [J ] . Philosophical Transactions of the Royal Society of London , 1923 , 223 ( 604 ): 289 - 343 .

CONBOY T , WRIGHT S , PASCH J , et al . Performance characteristics of an operating supercritical CO 2 Brayton cycle [J ] . ASME Journal of Engineering for Gas Turbines and Power , 2012 , 134 ( 11 ): 111703 .

梁腾和 , 黄宏立 , 马乐 , 等 . 涡轮机械转子在CO 2 工质中风摩损耗的数值分析 [J ] . 厦门大学学报(自然科学版) , 2020 , 59 ( 4 ): 547 - 522 .

LIANG T , HUANG H , MA L , et al . Numerical analysis of windage loss of turbomachinery rotor in CO 2 [J ] . Journal of Xiamen University (Natural Science) , 2020 , 59 ( 4 ): 547 - 522 .

ZHAO Z , SONG W , JIN Y , et al . Effect of rotational speed variation on the flow characteristics in the rotor-stator system cavity [J ] . Applied Sciences-Basel , 2021 , 11 ( 22 ): 11000 .

邓清华 , 胡乐豪 , 赵奕萌 , 等 . 轴类间隙内摩擦损失模型验证及流动特性分析 [J ] . 西安交通大学学报 , 2022 , 56 ( 05 ): 54 - 63 .

DENG Q , HU L , ZHAO Y , et al . Windage loss model verification and flow characteristic analysis in shaft-type gap [J ] . Journal of Xi'an Jiaotong University , 2022 , 56 ( 05 ): 54 - 63 .

胡乐豪 . 超紧凑动力装置内转静间隙风阻损失机理与预测模型研究 [D ] . 西安交通大学 , 2024 .

HU L . Mechanism and prediction model of windage loss in stator and rotor gap of ultra-compact power devices [D ] . Xi’an Jiaotong University , 2024 .

BILGEN E , BOULOS R . Functional dependence of torque coefficient of coaxial cylinders on gap width and Reynolds numbers [J ] . Journal of Fluid Engineering , 1973 , 95 ( 1 ): 122 - 126 .

SAARI J . Thermal analysis of high-speed induction machines [D ] . Helsinki : Helsinki University of Technology , 1998 .

BARCILON A , BRINDLEY J , LESSEN M , et al . Marginal instability in Taylor–Couette flows at a very high Taylor number [J ] . Journal of Fluid Mechanics , 2006 , 94 ( 3 ): 453 - 463 .

LIU M , SIXEL W , DING H , et al . Investigation of rotor structure influence on the windage loss and efficiency of FSPM machine [C ] // 2018 IEEE Energy Conversion Congress and Exposition (ECCE) . IEEE , 2018 .

WEI C , XU K , KAI Z , et al . Research on windage losses of smooth rotor supported by active magnetic bearings in a vacuum chamber [J ] . Vacuum , 2019 , 159 : 76 - 81 .

CHEN B , GUO C , JI Y , et al . Study on windage loss characteristics of supercritical CO 2 Taylor-Couette-Poiseuille flows [J ] . Thermal science and engineering progress , 2024 , 51 : 102611

MAMONOV V , MISKIV N , NAZAROV D , et al . Effect of ribbing of the internal rotating cylinder in the Couette–Taylor system on the value of rotational resistance moment [J ] . Thermophysics and Aeromechanics , 2023 , 30 : 637 - 647 .

HU W , YANG Y , ZUO S , et al . Numerical investigation of Taylor–Couette flow in a grooved configuration [J ] . Physics of Fluids , 2025 , 37 ( 3 ): 035207 .

AKONUR A , LUEPTOW M . Three-dimensional velocity field for wavy Taylor–Couette flow [J ] . Physics of Fluids , 2003 , 15 ( 4 ): 947 - 960 .

DOU H , KHOO B , YEO K . Energy loss distribution in the plane Couette flow and the Taylor–Couette flow between concentric rotating cylinders [J ] . International Journal of Thermal Sciences , 2007 , 46 ( 3 ): 262 - 275 .

OSTILLA R , VERZICCO R , GROSSMANN S , et al . The near-wall region of highly turbulent Taylor–Couette flow [J ] . Journal of Fluid Mechanics , 2015 , 788 : 95 - 117 .

FELDMANN D , BORRERO D , Michael J . Routes to turbulence in Taylor-Couette flow [J ] . Philosophical Transactions of the Royal Society , 2023 , 381 : 20220114 .

ADEBAYO D , AMERI J , TYUKIN I , et al . Linear stability analysis of the flow between rotating cylinders of wide gap [J ] . European Journal of Mechanics - B/Fluids , 2018 , 72 : 567 - 575 .

ZHU B , JI Z , LOU Z , et al . Torque scaling in small-gap Taylor-Couette flow with smooth or grooved wall [J ] . Physical Review E , 2018 , 97 ( 3 ): 033110 .

RAZZAK A . Numerical study on wide gap Taylor Couette flow with flow transition [J ] . Physics of Fluids , 2019 , 31 ( 11 ): 113606 .

HU L , DENG Q , LIU Z , et al . Effects of surface roughness on windage loss and flow characteristics in shaft-type gap with critical CO 2 [J ] . Applied Sciences-Basel , 2022 , 12 ( 24 ): 12631 .

ZHANG Y , XU R , SONG Y , et al . Numerical simulation of turbulent Taylor–Couette flow with high Taylor number and large radius ratio in high-speed canned motor pump internals [J ] . Physics of Fluids , 2024 , 36 ( 10 ): 105123 .

IKHLAQ M , ULLAH S , SMITH B , et al . Estimation of the windage loss and heat transfer characteristics inside the finite length of electrical machines' airgap based on CFD and MLA [J ] . Thermal Science and Engineering Progress , 2025 , 64 ( 1000 ).

WENDT V . Turbulente strmungen zwischen zwei rotierenden konaxialen zylinder [J ] . Ingenieur-Archiv , 1933 , 4 ( 6 ): 577 - 595 .

CELIK I , GHIA U , ROACHE P . Procedure for estimation and reporting of uncertainty due to discretization in CFD applications [J ] . ASME Journal of Fluids Engineering , 2008 , 130 ( 7 ): 078001 .

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

超临界二氧化碳向心透平轮背间隙内风阻损失及流动特性研究

轴类间隙内摩擦损失模型验证及流动特性分析

不同板叠材料热声热机能量转换过程数值模拟研究

扇贝仿生密封腔室内超临界二氧化碳泄漏流湍动能耗散机理研究

结构-语义-残差协同的图像压缩框架：面向隐私保护与高保真重建