Intelligent Simulation of Performance of Falling Film Evaporator Based on Distributed Parameter Model

QIAO Botao; DU Shen; LI Mingjia; SONG Xia

doi:10.7652/xjtuxb202409005

您当前的位置：

首页 >

文章列表页 >

Intelligent Simulation of Performance of Falling Film Evaporator Based on Distributed Parameter Model

更新时间：2025-07-28

- Intelligent Simulation of Performance of Falling Film Evaporator Based on Distributed Parameter Model
- Vol. 58, Issue 9, Pages: 38-47+82(2024)
- 作者机构：
  
  1. 西安交通大学能源与动力工程学院,西安,710049
  2. 北京理工大学机械与车辆学院,北京,100081
  3. 广东美的暖通设备有限公司,广东,佛山,528311
- 作者简介：
- 基金信息：
- DOI：10.7652/xjtuxb202409005
  CLC： TK124
- Published：2024
- 稿件说明：
移动端阅览
QIAO Botao, DU Shen, LI Mingjia, et al. Intelligent Simulation of Performance of Falling Film Evaporator Based on Distributed Parameter Model[J]. 2024, 58(9): 38-47+82.
DOI：

QIAO Botao, DU Shen, LI Mingjia, et al. Intelligent Simulation of Performance of Falling Film Evaporator Based on Distributed Parameter Model[J]. 2024, 58(9): 38-47+82. DOI： 10.7652/xjtuxb202409005.

摘要

为对大型水平管降膜式蒸发器进行高精度的设计计算和优化分析

建立了降膜式蒸发器的智能换热仿真模型

并分析研究了蒸发器的性能。首先

采用分布参数法建立了单出口水平管降膜式蒸发器的换热仿真模型; 其次

通过贝叶斯优化算法利用蒸发器实验数据对模型进行参数辨识

使得换热仿真模型的预测精度和适应性有所提高; 最后

探究了传热系数和热流密度沿管长方向的变化情况

以及满液区换热面积所占比例对蒸发器换热量的影响规律。仿真结果表明:结合分布参数法和贝叶斯优化算法的智能换热仿真模型对大型水平管降膜式蒸发器19个工况换热量的预测误差不超过±6%; 在较大的换热量范围内

单出口水平管降膜式蒸发器的最优池沸腾换热面积比例维持不变; 从管内对流换热和二次布液两个角度优化降膜式蒸发器能有效提升其换热性能。

Abstract

To carry out high-precision design calculations and optimization analyses for a large horizontal-tube falling film evaporator

an intelligent simulation model for heat exchange of the falling film evaporator is established

and performance analysis research is conducted on the evaporator. Firstly

a simulation model for heat exchange of a single-outlet horizontal-tube falling film evaporator is constructed based on a distributed parameter model. Secondly

the Bayesian optimization algorithm and experimental data from the evaporator are used to identify the parameters of the model. This approach improves the prediction accuracy and adaptability of the simulation model for heat exchange. Finally

the changes in heat transfer coefficient and heat flux along the axis of the tube are explored

and the influence of the proportion of heat transfer area in the flooded zone on the heat transfer of the evaporator is examined. The research findings show that the intelligent simulation model

integrating the distributed parameter method and Bayesian optimization algorithm

achieves a ±6% prediction error for heat transfer in the evaporator across 19 operating conditions. Within a wide range of heat exchange

the optimal proportion of heat transfer area in the flooded zone remains unchanged. Optimization from the perspectives of convective heat transfer inside the tube and secondary liquid distribution will effectively improve the performance of heat transfer of the falling film evaporator.

关键词

Keywords

references

王从飞, 曹锋, 李明佳, 等. 碳中和背景下新能源汽车热管理系统研究现状及发展趋势 [J]. 科学通报, 2021, 66(32): 4112-4128.

WANG Congfei, CAO Feng, LI Mingjia, et al. Research status and future development of thermal management system for new energy vehicles under the background of carbon neutrality [J]. Chinese Science Bulletin, 2021, 66(32): 4112-4128.

HE Yaling, TANG Songzhen, TAO Wenquan, et al. A general and rapid method for performance evaluation of enhanced heat transfer techniques [J]. International Journal of Heat and Mass Transfer, 2019, 145: 118780.

“中国学科及前沿领域发展战略研究(2021—2035)”项目组. 中国能源科学2035发展战略 [M]. 北京: 科学出版社, 2023.

WANG Qifan, LIU Xuetao, LI Minxia, et al. Numerical simulation of heat transfer characteristics of falling-film evaporation of R32/R134a non-azeotropic refrigerant outside a horizontal tube [J]. International Communications in Heat and Mass Transfer, 2023, 148: 107001.

XU Bo, JIANG Chun, CHEN Zhenqian. Numerical study on flow heat transfer characteristics of horizontal tube falling-film evaporator [J]. Journal of Thermal Science, 2021, 30(4): 1302-1317.

ZHAO Chuangyao, YAO Zhuoliang, QI Di, et al. Numerical investigation of tube bundle arrangement effect on falling film fluid flow and heat transfer [J]. Applied Thermal Engineering, 2022, 201(Part B): 117828.

GUO Yali, BAO Minle, GONG Luyuan, et al. Numerical investigation of the falling film thickness and heat transfer characteristics over horizontal round tube [J]. International Journal of Multiphase Flow, 2022, 149: 103977.

ZHAO Chuangyao, QI Di, JI Wentao, et al. A comprehensive review on computational studies of falling film hydrodynamics and heat transfer on the horizontal tube and tube bundle [J]. Applied Thermal Engineering, 2022, 202: 117869.

HOU Hao, BI Qincheng, ZHANG Xiaolan. Numerical simulation and performance analysis of horizontal-tube falling-film evaporators in seawater desalination [J]. International Communications in Heat and Mass Transfer, 2012, 39(1): 46-51.

SHEN Shengqiang, GONG Luyuan, LIU Hua, et al. Characteristic study of steam maldistribution in horizontal-tube falling film evaporators [J]. Applied Thermal Engineering, 2015, 75: 635-647.

GONG Luyuan, SHEN Shengqiang, LIU Hua, et al. Three-dimensional heat transfer coefficient distributions in a large horizontal-tube falling film evaporator [J]. Desalination, 2015, 357: 104-116.

GONG Luyuan, ZHOU Shihe, GUO Yali, et al. Distribution of brine temperature in a large-scale horizontal-tube falling film evaporator [J]. Applied Thermal Engineering, 2020, 164: 114437.

YANG Li, WANG Wen. The heat transfer performance of horizontal tube bundles in large falling film evaporators [J]. International Journal of Refrigeration, 2011, 34(1): 303-316.

翟玉燕, 黄兴华. 基于分布参数模型的水平管式降膜蒸发器模拟 [J]. 机械工程学报, 2009, 45(7): 284-290.

ZHAI Yuyan, HUANG Xinghua. Prediction of the performance of falling film evaporator with horizontal tube bundle based on a distributed parameter model [J]. Journal of Mechanical Engineering, 2009, 45(7): 284-290.

HU Bin, YAN Hongzhi, WANG R Z. Modeling and simulation of a falling film evaporator for a water vapor heat pump system [J]. Applied Energy, 2019, 255: 113851.

LI YingLin, WANG Ke, WU Wei, et al. Study on the effect of refrigerant distributing nonuniformity on the performance of falling-film evaporator with liquid recirculation system [J]. International Journal of Refrigeration, 2017, 82: 199-211.

ROQUES J F, THOME J R.Falling films on arrays of horizontal tubes with R-134a: part Ⅱ flow visualization, onset of dryout, and heat transfer predictions [J]. Heat Transfer Engineering, 2007, 28(5): 415-434.

杨世铭, 陶文铨. 传热学 [M]. 4版. 北京: 高等教育出版社, 2006.

HABERT M, THOME J R.Falling-film evaporation on tube bundle with plain and enhanced tubes: part Ⅱ

new prediction methods [J]. Experimental Heat Transfer, 2010, 23(4): 281-297.

GHAHRAMANI Z. Probabilistic machine learning and artificial intelligence [J]. Nature, 2015, 521(7553): 452-459.

SHIELDS B J, STEVENS J, LI Jun, et al. Bayesian reaction optimization as a tool for chemical synthesis [J]. Nature, 2021, 590(7844): 89-96.

ABRAHAM R, MANI A. Heat transfer characteristics in horizontal tube bundles for falling film evaporation in multi-effect desalination system [J]. Desalination, 2015, 375: 129-137.

NIU Runping, KUANG Daqing, WANG Shizheng, et al. Simulation and experimental studies on the liquid desiccant dehumidification of horizontal tubes having a staggered arrangement [J]. Journal of Building Engineering, 2020, 27: 100931.

LIN Haoyu, MUNEESHWARAN M, YANG Cheng-min, et al. On falling film evaporator: a review of mechanisms and critical assessment of correlation on a horizontal tube bundle with updated development [J]. International Communications in Heat and Mass Transfer, 2024, 150: 107165.

何茂刚, 王小飞, 张颖. 制冷用水平管降膜蒸发器的研究进展及新技术 [J]. 化工学报, 2008, 59(S2): 23-28.

HE Maogang, WANG Xiaofei, ZHANG Ying. Review of prior research and new technology for horizontal-tube falling-film evaporator used in refrigeration [J]. Journal of Chemical Industry and Engineering(China), 2008, 59(S2): 23-28.

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Numerical Simulation of Flow Inside Falling Film Evaporator with Horizontal Tubes Refrigeration System

Numerical Simulation of the Carbon Dioxide Microchannel Evaporator Using Distributed Parameter Model

Research on Construction of Distributed Parameter Model and Optimization of Cross-Flow Plate Fin Heat Exchanger

Numerical Simulation of Heat-Moisture Barrier Performance of a Horizontal Air Curtain in Cold Storage

Research on the Electrohydrodynamic Effects of Ionic Liquid-Modified Fuels

Related Author

阮并璐

刘广彬

赵远扬

李连生

张海清

郭蓓

LI Ke

WEN Jian

Related Institution

National Engineering Research Center of Fluid Machinery and Compressor, Xi'an Jiaotong University

School of Energy and Power Engineering, Xi'an Jiaotong University

⁰