Experimental Study on Flow and Heat Transfer Characteristics of U-Type Cooling Channels with Different Rib Turbulators within a Wide Reynolds Number Range

WAN Hongniu; DING Yuzhong; CHENG Xiang; CHEN Li; WANG Jin; JI Wentao; TAO Wenquan

doi:10.7652/xjtuxb202406010

您当前的位置：

首页 >

文章列表页 >

Experimental Study on Flow and Heat Transfer Characteristics of U-Type Cooling Channels with Different Rib Turbulators within a Wide Reynolds Number Range

更新时间：2025-07-28

- Experimental Study on Flow and Heat Transfer Characteristics of U-Type Cooling Channels with Different Rib Turbulators within a Wide Reynolds Number Range
- Vol. 58, Issue 6, Pages: 103-113(2024)
- 作者机构：
  
  1. 西安交通大学热流科学与工程教育部重点实验室,西安,710049
  2. 河北工业大学能源与环境工程学院,天津,300401
- 作者简介：
- 基金信息：
- DOI：10.7652/xjtuxb202406010
  CLC： TK47
- Online First：10 June 2024，
  
  Published：2024
- 稿件说明：
移动端阅览
WAN Hongniu, DING Yuzhong, CHENG Xiang, et al. Experimental Study on Flow and Heat Transfer Characteristics of U-Type Cooling Channels with Different Rib Turbulators within a Wide Reynolds Number Range[J]. 2024, 58(6): 103-113.
DOI：

WAN Hongniu, DING Yuzhong, CHENG Xiang, et al. Experimental Study on Flow and Heat Transfer Characteristics of U-Type Cooling Channels with Different Rib Turbulators within a Wide Reynolds Number Range[J]. 2024, 58(6): 103-113. DOI： 10.7652/xjtuxb202406010.

摘要

为了研究肋高和通道高的比值(e/H)、肋间距与肋高的比值(P/e)以及肋角度(α)对U型带肋通道流动与换热特性的影响

采用铜板法结合热电偶测量壁面温度分布

对6个不同肋参数U型带肋通道的表面换热特性进行了实验研究。带肋通道截面为正方形

实验的Re为5.0×10

～1.0×10

。研究结果表明

随着e/H和Re的增大

带肋通道的对流换热系数逐渐增大

但相应的流动损失增幅明显

e/H从0.08增大到0.12时

通道的阻力系数增大了近一倍。对于e/H=0.08的通道

P/e分别为6、8、10时

P/e为8时的对流换热系数和阻力损失均高于其他两种情况。相较于90°正交肋

带角度的斜肋能够进一步增强带肋通道的对流换热

75°肋的强化效果略强于60°肋。在实验参数范围内

对于几种不同的带肋U型通道

对流换热系数为光滑通道的1.9～3.0倍

阻力系数为光滑通道的4～16倍。综合考虑换热与流阻

e/H=0.08、P/e=8、α=45°的通道性能最好。

Abstract

In order to study the influence of rib height to channel height ratio(e/H)

rib spacing to rib height ratio(P/e)and rib angle(α)on the flow and heat transfer characteristics of ribbed U-type channels

the channel wall surface temperature distribution is measured using copper plate method combining thermocouple. Experimental study of the heat transfer characteristics on the surface of ribbed U-type channel with 6 different rib parameters is carried out. The ribbed channel has

a square cross section

and the Reynolds number in this experiment is from 5.0×10

to 1.0×10

. The experimental results show that with the increase of the e/H and Reynolds number

the convective heat transfer coefficient of the ribbed channel gradually increases

but the corresponding pressure loss increases significantly. As the e/H increases from 0.08 to 0.12

the friction factor of the channel almost doubles. For channel with e/H=0.08

among the three cases with the P/e being 6

and 10

the convective heat transfer coefficient and pressure loss are highest when the ratio is 8. The angled rib can further enhance the convective heat transfer in ribbed channels compared to the 90° orthogonal rib. Additionally

the 75° rib is slightly more effective than the 60° rib. Within the experimental parameter range

the convective heat transfer coefficient is 1.9—3.0 times that of the smooth channel

and the drag coefficient is about 4—6 times that of the smooth channel. Considering heat transfer and flow resistance comprehensively

under the conditions of e/H=0.08

P/e=8

and α=45°

the thermal performance is the best.

关键词

Keywords

references

UNNIKRISHNAN U, YANG V. A review of cooling technologies for high temperature rotating components in gas turbine [J]. Propulsion and Power Research, 2022, 11(3): 293-310.

BOYCE M P. Gas turbine engineering handbook [M]. 4th ed. Oxford, UK: Butterworth-Heinemann, 2011.

翁史烈, 王永泓, 宋华芬, 等. 现代燃气轮机装置 [M]. 上海: 上海交通大学出版社, 2015.

HAN J C. Advanced cooling in gas turbines 2016 Max Jakob memorial award paper [J]. Journal of Heat Transfer, 2018, 140(11): 113001.

HAN J C, OU S, PARK J S, et al. Augmented heat transfer in rectangular channels of narrow aspect ratios with rib turbulators [J]. International Journal of Heat and Mass Transfer, 1989, 32(9): 1619-1630.

HAN J C. Turbine blade cooling studies at Texas AM University: 1980-2004 [J]. Journal of Thermophysics and Heat Transfer, 2006, 20(2): 161-187.

SEWALL E A, TAFTI D K, GRAHAM A B, et al. Experimental validation of large eddy simulations of flow and heat transfer in a stationary ribbed duct [J]. International Journal of Heat and Fluid Flow, 2006, 27(2): 243-258.

席雷, 徐亮, 高建民, 等. 涡轮叶片厚壁带肋通道冷却性能的实验研究 [J]. 西安交通大学学报, 2021, 55(3): 29-36.

XI Lei, XU Liang, GAO Jianmin, et al. Experimental study on the cooling performance ofthick-wall ribbed channels in turbine blade [J]. Journal of Xi'an Jiaotong University, 2021, 55(3): 29-36.

GAO Tieyu, ZENG Junxiong, ZHU Jiangnan, et al. Effects of rib angle and rib orientation on flow and heat transfer in two-pass ribbed channels [J]. Journal of Mechanical Science and Technology, 2018, 32(1): 513-526.

TASLIM M E, SPRING S D. Experimental heat transfer and friction factors in turbulated cooling passages of different aspect ratios, where turbulators are staggered [C]//24th Joint Propulsion Conference. Reston, VA, USA: AIAA, 1988: AIAA 1988-3014.

周明轩, 薛树林, 贺宜红, 等. 高阻塞比肋化通道对流换热特性实验研究 [J]. 推进技术, 2018, 39(2): 335-341.

ZHOU Mingxuan, XUE Shulin, HE Yihong, et al. Experimental investigation on convective heat transfer characteristics of high blockageribs channel [J]. Journal of Propulsion Technology, 2018, 39(2): 335-341.

YANG Weihua, XUE Shulin, HE Yihong, et al. Experimental study on the heat transfer characteristics of high blockage ribs channel [J]. Experimental Thermal and Fluid Science, 2017, 83: 248-259.

RAVI B V, SINGH P, EKKAD S V. Numerical investigation of turbulent flow and heat transfer in two-pass ribbed channels [J]. International Journal of Thermal Sciences, 2017, 112: 31-43.

RALLABANDI A P, YANG Huitao, HAN J C. Heat transfer and pressure drop correlations for square channels with 45 deg ribs at high Reynolds numbers [J]. Journal of Heat Transfer, 2009, 131(7): 071703.

KRISHNASWAMY K, SIVAN S. Improvement in thermal hydraulic performance by using continuous V and W-shaped rib turbulators in gas turbine blade cooling application [J]. Case Studies in Thermal Engineering, 2021, 24: 100857.

邓贺方, 姜玉廷, 张建, 等. 狭缝斜肋内冷通道流动和换热特性的数值研究 [J]. 推进技术, 2020, 41(9): 2070-2076.

DENG Hefang, JIANG Yuting, ZHANG Jian, et al. Numerical study on flow and heat transfer characteristics of internal cooling channel with slit inclined ribs [J]. Journal of Propulsion Technology, 2020, 41(9): 2070-2076.

CHANG S W, WU P S, LU Yongen, et al. Aerothermal performances improvement by novel stepped zebra-ribs in two-pass channel [J]. International Communications in Heat and Mass Transfer, 2023, 142: 106632.

SCHABACKER J, BÖLCS A, JOHNSON B V. PIV investigation of the flow characteristics in an internal coolant passage with two ducts connected by a sharp 180° bend [C]//ASME 1998 International Gas Turbine and Aeroengine Congress and Exhibition. New York, NY, USA: ASME, 2014: V004T09A094.

SCHABACKER J, BOELCS A, JOHNSON B V. PIV investigation of the flow characteristics in an internal coolant passage with 45 deg rib arrangement [C]//ASME 1999 International Gas Turbine and Aeroengine Congress and Exhibition. New York, NY, USA: ASME, 2014: V003T01A024.

YOU Ruquan, LIU Zexuan, LI Haiwang, et al. Experimental and numerical study of flow field structure in U-shaped channels with different bend sections [J]. Physics of Fluids, 2023, 35(4): 045115.

GAO Tieyu, ZHU Jiangnan, LI Jun, et al. Improving heat transfer performance in two-pass ribbed channel by the optimized secondary flow via bend shape modification [J]. International Communications in Heat and Mass Transfer, 2019, 103: 43-53.

ROHSENOW W M, CHOI H Y. Heat, mass and momentum transfer [M]. Englewood Cliffs, NJ, USA: Prentice-Hall, 1961: 192-193.

KAYS W M, CRAWFORD M E.Convective heat and mass transfer [M]. 3rd ed. New York, USA: McGraw-Hill, 1993: 249.[24] JI Wentao, FAN Jufang, ZHAO Chuangyao, et al. A revised performance evaluation method for energy saving effectiveness of heat transfer enhancement techniques [J]. International Journal of Heat and Mass Transfer, 2019, 138: 1142-1153.

COLEMAN H W, STEELE W G.Engineering application of experimental uncertainty analysis [J]. AIAA Journal, 1995, 33(10): 1888-1896.

FU W L, WRIGHT L M, HAN J C. Rotational buoyancy effects on heat transfer in five different aspect-ratio rectangular channels with smooth walls and 45 degree ribbed walls [J]. Journal of Heat Transfer, 2006, 128(11): 1130-1141.

LIOU T M, CHANGS W, LAN Y A, et al. Heat transfer and flow characteristics of two-pass parallelogram channels with attached and detached transverse ribs [J]. Journal of Heat Transfer, 2017, 139(4): 042001.

SON S Y, KIHM K D, HAN J C. PIV flow measurements for heat transfer characterization in two-pass square channels with smooth and 90° ribbed walls [J]. International Journal of Heat and Mass Transfer, 2002, 45(24): 4809-4822.

SINGH P, RAVI B V, EKKAD S V. Experimental and numerical study of heat transfer due to developing flow in a two-pass rib roughened square duct [J]. International Journal of Heat and Mass Transfer, 2016, 102: 1245-1256.

HAN J C, ZHANG Y M, LEE C P. Augmented heat transfer in square channels with parallel, crossed, and V-shaped angled ribs [J]. Journal of Heat Transfer, 1991, 113(3): 590-596.

HAN J C, ZHANG Y M. High performance heat transfer ducts with parallel broken and V-shaped broken ribs [J]. International Journal of Heat and Mass Transfer, 1992, 35(2): 513-523.

RALLABANDI A P, ALKHAMIS N, HAN J C. Heat transfer and pressure drop measurements for a square channel with 45 deg round-edged ribs at high Reynolds numbers [J]. Journal of Turbomachinery, 2011, 133(3): 031019.

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Modeling and Analysis of Temperature Rise in Ball Screw Pairs Considering Thermal Contact Resistance and Convective Heat Transfer Coefficient Corrections

Effect of Plug Structure on the Flow and Heat Transfer Characteristics of Swirl Cooling

Progress in Visualization Experimental Studies on Heat Transfer of Supercritical Fluids

Convection Heat Transfer Characteristics of High-Pressure Gas in Parallel Channel Heat Exchanger with Membrane Serpentine Tubes

Heat Transfer Characteristics of Different Heat Transfer Structures in Gasification Convective Syngas Cooler

Related Author

MEI Xuesong

WANG Haitao

JING Yabin

YANG Hanbo

JIANG Gedong

WANG Hao

HE Wei

XIAO Junfeng

Related Institution

School of Mechanical Engineering, Xi'an Jiaotong University

Shaanxi Provincial Key Laboratory of Intelligent Robots

Xi'an Thermal Power Research Institute Co, Ltd

School of Mechanical Engineering, Beijing Institute of Technology

Chongqing Innovation Center, Beijing Institute of Technology

⁰