Study on the Thermal Characteristics of a Two-Phase Single-Screw Expander forTotal-Flow Geothermal Power Generation

NIE Tao; ZHOU Hongyang; SHAO Hua; WANG Zengli

doi:10.7652/xjtuxb202405018

您当前的位置：

首页 >

文章列表页 >

Study on the Thermal Characteristics of a Two-Phase Single-Screw Expander forTotal-Flow Geothermal Power Generation

更新时间：2025-07-28

- Study on the Thermal Characteristics of a Two-Phase Single-Screw Expander forTotal-Flow Geothermal Power Generation
- Vol. 58, Issue 5, Pages: 190-199(2024)
- 作者机构：
  
  中国石油大学(华东)新能源学院, , ),山东,青岛,266580
- 作者简介：
- 基金信息：
- DOI：10.7652/xjtuxb202405018
  CLC： TB653
- Online First：10 May 2024，
  
  Published：2024
- 稿件说明：
移动端阅览
NIE Tao, ZHOU Hongyang, SHAO Hua, et al. Study on the Thermal Characteristics of a Two-Phase Single-Screw Expander forTotal-Flow Geothermal Power Generation[J]. 2024, 58(5): 190-199.
DOI：

NIE Tao, ZHOU Hongyang, SHAO Hua, et al. Study on the Thermal Characteristics of a Two-Phase Single-Screw Expander forTotal-Flow Geothermal Power Generation[J]. 2024, 58(5): 190-199. DOI： 10.7652/xjtuxb202405018.

摘要

针对地热能发电技术存在的系统效率与热源利用率低的问题

对全流循环发电系统中替代传统汽轮机使用的单螺杆膨胀机进行了热力特性分析。基于质量守恒方程、能量守恒方程与湿蒸汽维里状态方程

建立了考虑液体闪蒸与气液平衡的单螺杆膨胀机理论全流膨胀过程的热力学模型

探索了进气温度与干度对气液两相工质状态及膨胀机热力特性的影响机理。结果表明:当进气温度由140 ℃升高至170 ℃时

湿蒸汽工质的质量、压力和温度均得到提升

单螺杆膨胀机的输出功率也由210 kW提升至约260 kW

等熵效率在进气温度为160 ℃时取得77%的最佳值; 进气干度的提高会减少进入工作腔湿蒸汽工质质量

进而导致膨胀结束后介质压力与温度的降低

但显著促进了膨胀机的性能参数包括输出功率和等熵效率的提高

当进气干度为0.3时

单螺杆膨胀机的输出功率超过了500 kW

等熵效率也可达76.5%。上述研究结果对应用于地热能全流发电的两相单螺杆膨胀机的热力特性分析与改善以及全流发电技术的优化有一定的参考意义。

Abstract

In response to the low system efficiency and heat source utilization in geothermal power generation technology

the thermal characteristics of a single-screw expander used in a total-flow cycle power generation system as an alternative to the traditional steam turbine are analyzed. Based on the mass and energy conservation equations and wet-steam virial equation of state

a thermodynamic model is formulated for the total-flow expansion involving liquid flash and vapor-liquid equilibrium. The influence of inlet temperature and dryness on the state of vapor-liquid two-phase working medium and the thermal characteristics of the expander is examined. The results show that elevating the inlet temperature from 140 ℃ to 170 ℃ enhances the mass

pressure

and temperature of the wet steam working medium

and the output power of the single-screw expander rises from 210 kW to about 260 kW

with the isentropic efficiency becoming optimal at 77% at the inlet temperature of 160 ℃. Improving the inlet steam dryness diminishes the quality of the working medium of the wet steam entering the working chamber

causing a subsequent reduction in medium pressure and temperature after the expansion. However

this significantly boosts expander performance parameters

including output power and isentropic efficiency. With an inlet steam dryness of 0.3

the output power of the single screw expander exceeds 500 kW

and the isentropic efficiency reaches 76.5%. The study outcomes provide reference for the analysis and improvement of thermal characteristics of a two-phase single-screw expander used for geothermal energy total-flow power generation

as well as the optimization of total-flow power generation technology.

关键词

Keywords

references

王贵玲, 刘彦广, 朱喜, 等. 中国地热资源现状及发展趋势 [J]. 地学前缘, 2020, 27(1): 1-9.

WANG Guiling, LIU Yanguang, ZHU Xi, et al. The status and development trend of geothermal resources in China [J]. Earth Science Frontiers, 2020, 27(1): 1-9.

杨晓宇. 地热能的开发与利用 [C]//2019供热工程建设与高效运行研讨会论文集(上). 天津: 《煤气与热力》杂志社有限公司, 2019: 4.

LUND J W, TOTH A N. Direct utilization of geothermal energy 2020 worldwide review [J]. Geothermics, 2021, 90: 101915.

赵军. 中低温热源汽液两相螺杆膨胀机发电系统性能研究 [D]. 上海: 上海交通大学, 2016.

郭志宇. 提升有机朗肯循环单螺杆膨胀机工作温度的关键问题研究 [D]. 北京: 北京工业大学, 2021.

王彬. 烧结余热发电闪蒸系统动态特性研究 [D]. 唐山: 华北理工大学, 2018.

蔡正敏, 姜天生, 李刚, 等. 螺杆膨胀机发电技术在印尼地热开发中的应用 [J]. 能源与节能, 2019(6): 66-67.

CAI Zhengmin, JIANG Tiansheng, LI Gang, et al. Application of screw expander power generation technology in geothermal development in Indonesia [J]. Energy and Energy Conservation, 2019(6): 66-67.

刘凤钢, 任舒平, 张小强. 西藏羊易地热电站超大型螺杆膨胀发电机组应用研究 [J]. 能源研究与管理, 2016(1): 58-61.

LIU Fenggang, REN Shuping, ZHANG Xiaoqiang. Application of very large screw expansion generator units of geothermal power plant in Yangyi, Tibet [J]. Energy Research and Management, 2016(1): 58-61.

WANG Wei, WU Yuting, MA Chongfang, et al. Experimental study on the performance of single screw expanders by gap adjustment [J]. Energy, 2013, 62: 379-384.

李国强, 吴玉庭, 赵英昆, 等. 高压单螺杆膨胀机性能试验研究 [J]. 工程热物理学报, 2020, 41(6): 1318-1324.

LI Guoqiang, WU Yuting, ZHAO Yingkun, et al. Performance study on high pressure single screw expander [J]. Journal of Engineering Thermophysics, 2020, 41(6): 1318-1324.

何为, 吴玉庭, 马重芳, 等. 单螺杆发动机空气动力系统能效分析 [J]. 机械工程学报, 2011, 47(6): 150-155.

HE Wei, WU Yuting, MA Chongfang, et al. Energy efficiency analysis for air-powered vehicle system based on single-screw engine [J]. Journal of Mechanical Engineering, 2011, 47(6): 150-155.

张永志. 中低温地热发电系统分析及单螺杆膨胀机试验研究 [D]. 北京: 北京工业大学, 2013.

宋晓锋. 单螺杆膨胀机关键件模态仿真分析与实验研究 [D]. 北京: 北京工业大学, 2020.

余岳峰, 胡达, 邓金云, 等. 螺杆膨胀动力机技术及在低温余热发电中的应用 [J]. 上海节能, 2011(7): 22-25.

YU Yuefeng, HU Da, DENG Jinyun, et al. Screw expansion power machine technology and its application in low temperature waste heat power generation [J]. Shanghai Energy Conservation, 2011(7): 22-25.

何嘉诚. 带两相膨胀机的KCS34的热力学分析 [D]. 重庆: 重庆大学, 2013.

李驰, 余岳峰. 螺杆膨胀机余热发电系统变工况优化计算与设计 [EB/OL].(2012-11-13)[2023-11-01]. https://kns.cnki.net/kcms2/article/abstract?v=w1Je9LIFm5DmiJ33YbxEnL5pZUrDuFcNqp86-r6FqAwOBum_9AtnBNAOTivRkYRQarU46jujMQtz5bjWUf8gZbuMiJFpIQm8q_am09JNx1GLBuzXSPKurTE78WdI2-htfLO05GWw1l2QujIimtenMg==uniplatform=NZKPTlanguage=CHS.

王心悦. 全流式螺杆膨胀机气液两相热力特性研究 [D]. 上海: 上海交通大学, 2014.

付洁. 基于转子型线分析的双螺杆膨胀机热力性能研究 [D]. 哈尔滨: 哈尔滨工业大学, 2018.

刘一荻. 单螺杆膨胀机输出扭距的理论分析及其性能评价指标的研究探索 [D]. 北京: 北京工业大学, 2015.

沈丽丽, 王伟, 吴玉庭, 等. 单螺杆膨胀机内有机工质泄漏特性的数值研究 [J]. 北京工业大学学报, 2018, 44(10): 1340-1346.

SHEN Lili, WANG Wei, WU Yuting, et al. Numerical study of leakage characteristics of organic fluids in single screw expander [J]. Journal of Beijing University of Technology, 2018, 44(10): 1340-1346.

齐元渠. 湿饱和蒸汽螺杆膨胀机几何模型与热力过程仿真研究 [D]. 上海: 上海交通大学, 2016.

CHEN Kang, ZHENG Shaoxiong, DU Yang, et al. Thermodynamic and economic comparison of novel parallel and serial combined cooling and power systems based on sCO2cycle [J]. Energy, 2021, 215(Part A): 119008.

YOUNG J B. An equation of state for steam for turbomachinery and other flow calculations [J]. Journal of Engineering for Gas Turbines and Power, 1988, 110(1): 1-7.

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Thermo-Hydro-Mechanical Coupling Analysis of Fracture Networks During Heat Extraction from Hot Dry Rock Using Supercritical Carbon Dioxide

Analysis of THM Coupling Process in Fracture Networks During Heat Extraction from Hot Dry Rock Using SC-CO2

Sensitivity Analysis of Foil Geometrical Parameters for the Third-Generation CO2 Gas Foil Bearings Based on Design of Experiments Method

Energy Efficiency Optimization of the Cryogenic Air Separation Process for Electronic-Grade Ultra Pure Nitrogen

Effects of Steam Addition on the Swirl Combustion and Emission Characteristics of Cracked Ammonia

Related Author

QIAO Mingzheng

JING Zefeng

ZHOU Yujuan

ZHENG Long

WANG Lichao

QIAO Mingheng

JING Zefeng

ZHOU Yujuan

Related Institution

School of Energy and Power Engineering, Xi'an Jiaotong University

School of Energy and Power Engineering, Xi’an Jiaotong University

⁰