Dynamic Analysis on Deployable Mechanisms with Scissor-Like Elements Using Absolute Nodal Coordinate Formulation

PENG Qi'an; LI Bo; RONG Kai; QIAO Zheye; WANG Sanmin

doi:10.7652/xjtuxb202308017

您当前的位置：

首页 >

文章列表页 >

Dynamic Analysis on Deployable Mechanisms with Scissor-Like Elements Using Absolute Nodal Coordinate Formulation

更新时间：2025-05-08

- Dynamic Analysis on Deployable Mechanisms with Scissor-Like Elements Using Absolute Nodal Coordinate Formulation
- Vol. 57, Issue 8, Pages: 172-181(2023)
- 作者机构：
  
  1. 中国工程物理研究院电子工程研究所,四川,绵阳,621900
  2. 西北工业大学机电学院,西安,710072
- 作者简介：
- 基金信息：
- DOI：10.7652/xjtuxb202308017
  CLC： TH164
- Online First：10 August 2023，
  
  Published：2023
- 稿件说明：
移动端阅览
PENG Qi'an, LI Bo, RONG Kai, et al. Dynamic Analysis on Deployable Mechanisms with Scissor-Like Elements Using Absolute Nodal Coordinate Formulation[J]. 2023, 57(8): 172-181.
DOI：

PENG Qi'an, LI Bo, RONG Kai, et al. Dynamic Analysis on Deployable Mechanisms with Scissor-Like Elements Using Absolute Nodal Coordinate Formulation[J]. 2023, 57(8): 172-181. DOI： 10.7652/xjtuxb202308017.

摘要

针对可展机构在工程实践中由于质量轻、柔度大、尺寸大等特点而暴露出展开精度低、控制复杂和运动失稳等问题

采用绝对节点坐标法(ANCF)从多柔体角度分析了构件柔性对剪式单元可展机构动态特性的影响。首先

基于绝对节点坐标法

提出了一种新型无闭锁平面梁单元; 然后

考虑服役于太阳能帆板、伸展臂等空间机构的剪式单元可展机构的构型特点与运动条件

基于第一类拉格朗日方程建立了三单元可展机构动力学模型; 最后

采用动力学模型分析了杆件柔性对可展机构动力学行为的影响。研究结果表明:所提出的新型单元在解决单元闭锁问题的同时

将计算效率提升了18.2%; 构件柔性会导致不同构件间产生共振和谐振现象

影响可展机构的展开精度。该研究可为大型、超大型伸展臂的在轨展开提供理论参考。

Abstract

For problems of low deployment accuracy

complex control

and motion instability of deployable mechanisms exposed in engineering due to the characteristics of light weight

large flexibility

and large size of components

the absolute nodal coordinate formulation(ANCF)is used to analyze the impact of component flexibility on the dynamic characteristics of deployable mechanisms with scissor-like elements from the perspective of multiple flexible bodies. Firstly

based on ANCF

a new non-locking planar beam element is proposed. Secondly

considering the configuration characteristics and motion conditions of deployable mechanisms with scissor-like elements serving in spatial mechanisms such as solar panels and extension arms

a dynamic model for deployable mechanisms with three scissor-like elements is established using the first type Lagrange equation. Finally

the influence of rod flexibility on dynamic behaviors of deployable mechanisms is analyzed by this model. The research results show that the proposed new element improves the computational efficiency by 18.2% via solving the element locking problem

and the flexibility of components can lead to resonance of different components

affecting the deployment accuracy of deployable mechanisms. The research can provide theoretical reference for the deployment of large/ultra large extension arms in orbit.

关键词

Keywords

references

余德文, 赵强强, 陈飞飞, 等. 利用结构等效转换的空间可展机构装配误差建模与灵敏度分析 [J]. 西安交通大学学报, 2019, 53(4): 15-23.

YU Dewen, ZHAO Qiangqiang, CHEN Feifei, et al. Assembly error modeling and sensitivity analysis for spatial deployable mechanisms with structural equivalent transformation [J]. Journal of Xi'an Jiaotong University, 2019, 53(4): 15-23.

WANG Chunlong, GUO Hongwei, LIU Rongqiang, et al. A programmable origami-inspired space deployable structure with curved surfaces [J]. Engineering Structures, 2022, 256: 113934.

ZHAO Ningxiner, HARNE R L. Reconfigurable acoustic arrays with deployable structure based on a Hoberman-Miura system synthesis [J]. Journal of Mechanical Design, 2021, 143(6): 063301.

ZHANG Liyuan, ZHENG Yang, YIN Xu, et al. A tensegrity-based morphing module for assembling various deployable structures [J]. Mechanism and Machine Theory, 2022, 173: 104870.

LI Bo, WANG Sanmin, TAN Uxuan. Buckling analysis of planar linear uniform deployable structures consisting of scissor-like element in space under compression [J]. Science China Technological Sciences, 2021, 64(3): 493-507.

TANG Yaqiong, SHI Zhiyang, LI Tuanjie, et al. Double-layer cable-net structures for deployable umbrella reflectors [J]. Journal of Aerospace Engineering, 2019, 32(5): 04019068.

张霄, 李明, 崔琦峰, 等. 基于正六边形折纸的单自由度可展结构 [J]. 机械工程学报, 2021, 57(11): 153-164.

ZHANG Xiao, LI Ming, CUI Qifeng, et al. Regularly hexagonal origami pattern inspired deployable structure with single degree of freedom [J]. Journal of Mechanical Engineering, 2021, 57(11): 153-164.

VALAYIL T P, VELAPPAN S, PANDIAN P L. Analysing the kinematic characteristics of Bennett mechanisms and its networks for usage in forming deployable structures [J]. Mechanika, 2019, 25(4): 269-275.

LI Bo, WANG Sanmin, GANTES C J, et al. Nonlinear dynamic characteristics and control of planar linear array deployable structures consisting of scissor-like elements with revolute clearance joint [J]. Advances in Structural Engineering, 2021, 24(7): 1439-1455.

WANG Z X, WANG Y Q, SOJEONG J, et al. Experimental investigation and parametric analysis on overall buckling behavior of large-section aluminum alloy columns under axial compression [J]. Thin-Walled Structures, 2018, 122: 585-596.

KIDAMBI N, WANG K W. Dynamics of Kresling origami deployment [J]. Physical Review E, 2020, 101(6): 063003.

MA Xiaofei, LI Tuanjie, MA Jingya, et al. Recent advances in space-deployable structures in China [J]. Engineering, 2022, 17: 207-219.

祝恒佳, 杨丽昆, 祝世兴, 等. 考虑机翼柔性的磁流变减振起落架落振动力学分析 [J]. 西安交通大学学报, 2022, 56(12): 56-67.

ZHU Hengjia, YANG Likun, ZHU Shixing, et al. Analysis of impacts of magnetorheological landing gear on aircraft dynamics considering wing flexibility [J]. Journal of Xi'an Jiaotong University, 2022, 56(12): 56-67.

白发刚, 薛钢, 黄健堃, 等. 仿生机器鱼水动力学与机构动力学耦合建模研究 [J]. 西安交通大学学报, 2022, 56(9): 46-56.

BAI Fagang, XUE Gang, HUANG Jiankun, et al. Coupling modeling of hydrodynamics and mechanism dynamics of bionic robot fish [J]. Journal of Xi'an Jiaotong University, 2022, 56(9): 46-56.

FOTLANG G, HAUGEN B. Numerical integration algorithms and constraint formulations for an ALE-ANCF cable element [J]. Mechanism and Machine Theory, 2022, 170: 104659.

PENG Qi'an, WANG Sanmin, LI Bo, et al. Dynamics analysis of deployable structures considering a two-dimensional coupled thermo-structural effect [J]. International Journal of Aerospace Engineering, 2018, 2018: 1752815.

OTSUKA K, MAKIHARA K. Absolute nodal coordinate beam element for modeling flexible and deployable

aerospace structures [J]. AIAA Journal, 2019, 57(3): 1343-1346.[18] YOU Bindi, LIANG Dong, YU Xiangjie, et al. Deployment dynamics for flexible deployable primary mirror of space telescope with paraboloidal and laminated structure by using absolute node coordinate method [J]. Chinese Journal of Aeronautics, 2021, 34(4): 306-319.

GARCÍA-VALLEJO D, MIKKOLA A M, ESCALONA J L. A new locking-free shear deformable finite element based on absolute nodal coordinates [J]. Nonlinear Dynamics, 2007, 50(1): 249-264.

刘铖, 胡海岩. 基于李群局部标架的多柔体系统动力学建模与计算 [J]. 力学学报, 2021, 53(1): 213-233.

LIU Cheng, HU Haiyan. Dynamic modeling and computation for flexible multibody systems based on the local frame of LIE group [J]. Chinese Journal of Theoretical and Applied Mechanics, 2021, 53(1): 213-233.

OTSUKA K, MAKIHARA K, SUGIYAMA H. Recent advances in the absolute nodal coordinate formulation: literature review from 2012 to 2020 [J]. Journal of Computational and Nonlinear Dynamics, 2022, 17(8): 080803.

SHABANA A A, XU Lingmin. Rotation-based finite elements: reference-configuration geometry and motion description [J]. Acta Mechanica Sinica, 2021, 37(1): 105-126.

LI Tuanjie, WANG Yao. Deployment dynamic analysis of deployable antennas considering thermal effect [J]. Aerospace Science and Technology, 2009, 13(4/5): 210-215.

OMAR M A, SHABANA A A. A two-dimensional shear deformable beam for large rotation and deformation problems [J]. Journal of Sound and Vibration, 2001, 243(3): 565-576.

SHABANA A A, YAKOUB R Y. Three dimensional absolute nodal coordinate formulation for beam elements: theory [J]. Journal of Mechanical Design, 2001, 123(4): 606-613.

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

I/O Performance Modeling and Prediction Method for Large-Scale Parallel Applications Using Machine Learning

Effects of Steam Addition on the Swirl Combustion and Emission Characteristics of Cracked Ammonia

A Fast Calculation Method for Thermal Flow Fields in Transformer Windings Based on PI-DeepONet

Numerical Simulation of the Energy Conversion Process in Thermoacoustic Engines with Different Stack Materials

Review of the Application of EBSILON Software in Combined Heat and Power System Optimization

Related Author

No data

Related Institution

No data

⁰