

浏览全部资源
扫码关注微信
长安大学工程机械学院,西安,710064
Online First:10 April 2023,
Published:2023
移动端阅览
ZUO Hao, XING Jiao, KANG Jingdong, et al. Guided Wave Multi-Mode Fusion Imaging Method for Damage Detection of Thin-Walled Structures[J]. 2023, 57(4): 88-96.
ZUO Hao, XING Jiao, KANG Jingdong, et al. Guided Wave Multi-Mode Fusion Imaging Method for Damage Detection of Thin-Walled Structures[J]. 2023, 57(4): 88-96. DOI: 10.7652/xjtuxb202304010.
针对稀疏阵列损伤定位精度低和分辨率不高的问题
基于超声导波频散和多模态效应
提出了一种适用于薄壁结构损伤识别的相控阵超声导波多模态融合成像方法。首先
利用频散预补偿机制构造超声导波频散预补偿激励信号
消除超声导波响应信号的频散效应
校正相位失真
实现超声导波合成波阵面动态聚焦; 其次
通过Chirp线性调频信号激励技术
提取A0模态和S0模态占优的窄带高频超声导波响应信号作为检测波形
利用相控阵全聚焦方法构造单模态超声导波全聚焦成像; 最后
利用不同模态超声导波频散特性差异显著的特点
融合A0模态和S0模态相控阵超声导波全聚焦成像结果
实现超声导波多模态融合成像。实验结果表明:所提超声导波多模态融合成像方法不需要基准信号
能够实现铝板结构单损伤、多损伤高精度定位和高分辨率成像
最大定位误差仅为7.2 mm; 相比于单模态聚焦成像
多模态融合成像结果可以有效提高损伤成像的分辨率和信噪比
抑制旁瓣
避免产生伪像。所提方法可为薄壁结构多损伤检测提供有效途径。
Aiming at the existing problems such as low positioning accuracy and poor imaging resolution for damage detection of sparse array
a guided wave multi-mode fusion imaging method was proposed for damage detection of thin-walled structures based on the dispersion and multi-mode effects of guided wave. Firstly
the dispersion pre-compensation mechanism was adopted to construct excitation signal with dispersion pre-compensation to eliminate dispersion effect of ultrasonic guided wave response signal and correct phase distortion. In this way
the synthesis wavefront of guided wave signal achieved dynamic focusing. Secondly
the narrowband high frequency guided wave response signal dominated by A0 mode and S0 mode was extracted as detection waveforms by Chirp linear frequency modulated excitation signal. And the total focusing method was employed to establish the single mode total focusing imaging of guided by those detection waveforms
respectively. Finally
the significant difference in dispersion characteristics of guided wave for different modes were utilized to achieve guided wave multi-mode fusion imaging by fusion of various total focusing imaging results from A0 mode and S0 mode guided wave. The results show that the proposed guided wave multi-mode fusion imaging method achieves high precision positioning and high resolution imaging for both single and multiple damage detection of aluminum plate without baseline signals. And the maximum positioning error is 7.2 mm for multiple damage detection. In conclusion
the proposed multi-mode fusion imaging method can effectively improve the resolution and signal-to-noise ratio of damage imaging
suppress side lobe and avoid artifacts compared with single-mode focusing imaging. The proposed method can provide an effective way for multiple damage detection of thin-walled structures.
孙侠生, 苏少普, 孙汉斌, 等. 国外航空疲劳研究现状及展望 [J]. 航空学报, 2021, 42(5): 40-65.
SUN Xiasheng, SU Shaopu, SUN Hanbin, et al. Current status and prospect of overseas research on aeronautical fatigue [J]. Acta Aeronautica et Astronautica Sinica, 2021, 42(5): 40-65.
OSTACHOWICZ W, GÜEMES J A. New trends in structural health monitoring [M]. Vienna: Springer Vienna, 2013.
MITRA M, GOPALAKRISHNAN S. Guided wave based structural health monitoring: a review [J]. Smart Materials and Structures, 2016, 25(5): 053001.
XU Kailiang, MINONZIO J G, TA D, et al. Sparse SVD method for high-resolution extraction of the dispersion curves of ultrasonic guided waves [J]. IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 2016, 63(10): 1514-1524.
XU Caibin, WANG Jishuo, YIN Shenxin, et al. A focusing MUSIC algorithm for baseline-free Lamb wave damage localization [J]. Mechanical Systems and Signal Processing, 2022, 164: 108242.
MICHAELS J E, LEE S J, CROXFORD A J, et al. Chirp excitation of ultrasonic guided waves [J]. Ultrasonics, 2013, 53(1): 265-270.
WANG C H, ROSE J T, CHANG F K. A synthetic time-reversal imaging method for structural health monitoring [J]. Smart Materials and Structures, 2004, 13(2): 415.
SHARIF-KHODAEI Z, ALIABADI M H. Assessment of delay-and-sum algorithms for damage detection in aluminium and composite plates [J]. Smart Materials and Structures, 2014, 23(7): 075007.
GAO H, SHI Y, ROSE J L. Guided wave tomography on an aircraft wing with leave in place sensors [C]//AIP Conference Proceedings. Melville, NY, USA: AIP, 2005: 1788-1794.
HUTHWAITE P. Improving accuracy through density correction in guided wave tomography [J]. Proceedings of the Royal Society: Mathematical, Physical and Engineering Sciences, 2016, 472(2186): 20150832.
LEVINE R M, MICHAELS J E. Model-based imaging of damage with Lamb waves via sparse reconstruction [J]. The Journal of the Acoustical Society of America, 2013, 133(3): 1525-1534.
HUA Jiadong, WANG Zili, GAO Fei, et al. Sparse reconstruction imaging of damage for Lamb wave simultaneous excitation system in composite laminates [J]. Measurement, 2019, 136: 201-211.
HETTLER J, TABATABAEIPOUR M, DELRUE S, et al. Linear and nonlinear guided wave imaging of impact damage in CFRP using a probabilistic approach [J]. Materials, 2016, 9(11): 901.
施克仁, 郭寓岷. 相控阵超声成像检测 [M]. 北京: 高等教育出版社, 2010.
HOLMES C, DRINKWATER B W, WILCOX P D. Post-processing of the full matrix of ultrasonic transmit-receive array data for non-destructive evaluation [J]. NDT E International, 2005, 38(8): 701-711.
胡宏伟, 杜剑, 李洋, 等. 基于稀疏矩阵的两层介质超声相控阵全聚焦成像 [J]. 机械工程学报, 2017, 53(14): 128-135.
HU Hongwei, DU Jian, LI Yang, et al. Two-layer medium ultrasonic phased array total focusing method imaging based on sparse matrix [J]. Journal of Mechanical Engineering, 2017, 53(14): 128-135.
周正干, 李洋, 周文彬. 相控阵超声后处理成像技术研究、应用和发展 [J]. 机械工程学报, 2016, 52(6): 1-11.
ZHOU Zhenggan, LI Yang, ZHOU Wenbin. Ultrasonic phased array post-processing imaging techniques [J]. Journal of Mechanical Engineering, 2016, 52(6): 1-11.
WILCOX P D. A rapid signal processing technique to remove the effect of dispersion from guided wave signals [J]. IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 2003, 50(4): 419-427.
牛祥祥, 曹徐伟, 曾亮. 离散解析互相关的Lamb波频散特性估计方法 [J]. 西安交通大学学报, 2019, 53(10): 159-166.
NIU Xiangxiang, CAO Xuwei, ZENG Liang. Estimation of Lamb wave dispersion characteristics by discrete analytic cross-correlation method [J]. Journal of Xi'an Jiaotong University, 2019, 53(10): 159-166.
PRADO V T, HIGUTI R T, KITANO C, et al. Lamb mode diversity imaging for non-destructive testing of plate-like structures [J]. NDT E International, 2013, 59: 86-95.
LIU Zenghua, SUN Kunming, SONG Guorong, et al. Damage localization in aluminum plate with compact rectangular phased piezoelectric transducer array [J]. Mechanical Systems and Signal Processing, 2016, 70: 625-636.
XU Caibin, DENG Mingxi. Waveform correlation factor weighted TFM imaging for Lamb wave phased array [J]. NDT E International, 2022, 129: 102647.
LIU L, YUAN F G. A linear mapping technique for dispersion removal of Lamb waves [J]. Structural Health Monitoring, 2010, 9(1): 75-86.
ZENG Liang, LIN Jing. Chirp-based dispersion pre-compensation for high resolution Lamb wave inspection [J]. NDT E International, 2014, 61: 35-44.
XU Buli, GIURGIUTIU V. Single mode tuning effects on lamb wave time reversal with piezoelectric wafer active sensors for structural health monitoring [J]. Journal of Nondestructive Evaluation, 2007, 26(2): 123-134.
徐冠基, 许才彬, 杨志勃, 等. 碳纤维层合板Lamb波损伤检测的加权块稀疏成像法 [J]. 西安交通大学学报, 2019, 53(6): 176-182.
XU Guanji, XU Caibin, YANG Zhibo, et al. Weighted group-sparse imaging method for Lamb wave damage detection of CFRP laminates [J]. Journal of Xi'an Jiaotong University, 2019, 53(6): 176-182.
0
Views
12
下载量
0
CSCD
Publicity Resources
Related Articles
Related Author
Related Institution
京公网安备11010802024621