Circuit Model and Output Characteristics of Traveling Voltage Adder

REN Shuyi; HE Xu; SUN Fengju; WANG Zhiguo; QIU Aici

doi:10.7652/xjtuxb202212008

您当前的位置：

首页 >

文章列表页 >

Circuit Model and Output Characteristics of Traveling Voltage Adder

更新时间：2025-07-09

- Circuit Model and Output Characteristics of Traveling Voltage Adder
- Vol. 56, Issue 12, Pages: 78-85(2022)
- 作者机构：
  
  1. 西安交通大学电力设备与电气绝缘国家重点实验室,西安,710049
  2. 西北核技术研究所强脉冲辐射环境模拟与效应国家重点实验室,西安,710024
- 作者简介：
- 基金信息：
- DOI：10.7652/xjtuxb202212008
  CLC： TM83
- Online First：10 December 2022，
  
  Published：2022
- 稿件说明：
移动端阅览
REN Shuyi, HE Xu, SUN Fengju, et al. Circuit Model and Output Characteristics of Traveling Voltage Adder[J]. 2022, 56(12): 78-85.
DOI：

REN Shuyi, HE Xu, SUN Fengju, et al. Circuit Model and Output Characteristics of Traveling Voltage Adder[J]. 2022, 56(12): 78-85. DOI： 10.7652/xjtuxb202212008.

摘要

为了研究行波电压叠加器(TVA)的输出特性以及影响输出特性的因素

将传输线和放电支路进行简化

给出了传输线、放电支路、屏蔽电极与外筒体间的分布电感与分布电容等参数的计算方法

建立了8级串联TVA电路模型。通过仿真得到了8级串联TVA驱动匹配负载时的输出特性

研究了开关闭合时序与分散性以及传输线阻抗等对输出特性的影响。仿真结果表明:当每级开关触发闭合时序为理想感应电压叠加器(IVA)时序时

传输线输出电压峰值随串联级数n的增长近似线性增长

电压脉冲前沿逐级陡化

在匹配负载上的输出电压为899 kV

脉冲前沿与第一级相比缩短10 ns; 屏蔽电极上的电压峰值逐级减小

电压波形存在高频振荡; 开关闭合时序对TVA传输叠加与输出特性有显著影响

TVA按理想IVA时序触发时的匹配负载电压前沿比同时触发时要陡

相差约50 ns

随着触发时序系数增大(>1)

脉冲前沿逐渐陡化; 当开关触发闭合分散性增大时

输出脉冲重复性变差; 随着传输线阻抗从匹配阻尼增大至3倍阻尼

匹配负载电压峰值增大

前沿缩短约30 ns

波尾时间增大约200 ns。研究结果可为TVA型脉冲功率源装置的结构优化和研制提供一定的参考。

Abstract

In order to study the output characteristics of the traveling voltage adder(TVA)

and the factors that influenced the output characteristics

with the transmission line and the discharge bricks simplified equivalently

the methods are developed to calculate the parameters of the distributed inductances and the distributed capacitances between the transmission line

the discharge bricks

the shielding electrodes and the outer ground cylinder. And then the circuit model of an 8-stage series TVA is established. The output characteristics of the 8-stage series TVA and the effects of switch closure timing sequence and its dispersion

and transmission line impedance on the output characteristics are obtained

when the 8-stage series TVA is driven to a matched load. The results show that when the triggering sequence is an ideal induction voltage adder(IVA)sequence

the peak output voltages of the transmission line increases approximately linearly with the increase of series n

the leading edge of the voltage pulses are gradually steepened. The generator can deliver 899 kV fast pulse into a matched load. The leading edge is shortened by 10 ns compared with the first stage. The peak voltage on the shielding electrodes decreases with the increase of the series number of stages

and the voltage waveforms have a high frequency oscillation. Switch closure timing sequences have a significant impact on TVA transmission superposition and output characteristics. The load voltage leading edge when the TVA is triggered with an ideal IVA timing sequence is about 50 ns steeper than that with triggering simultaneously. As the trigger timing sequence coefficient increases(>1)

the leading edge of the pulse gradually becomes steeper. With the augmentation of switch closure time dispersion

the repeatability of output pulse becomes worse. As the impedance of the transmission line of TVA increases from matching damping to 3 times damping

the peak voltage on the matched load increases

the pulse leading edge is shortened by about 30 ns

and the pulse tail time is increased by about 200 ns. This work can provide valuable reference for the structure optimization and development of TVA pulse power source device.

关键词

Keywords

references

孙凤举, 邱爱慈, 魏浩, 等. 闪光照相快放电直线型变压器脉冲源新进展 [J]. 现代应用物理, 2015, 6(4): 233-243.

SUN Fengju, QIU Aici, WEI Hao, et al. Development of fast linear transformer drivers for radiography [J]. Modern Applied Physics, 2015, 6(4): 233-243.

孙凤举, 邱爱慈, 魏浩, 等. 快Z箍缩百太瓦级脉冲驱动源概念设计的发展 [J]. 现代应用物理, 2017, 8(2): 13-24.

SUN Fengju, QIU Aici, WEI Hao, et al. Development of conceptual design on fast Z-pinch pulsed power driver with hundreds of terawatt [J]. Modern Applied Physics, 2017, 8(2): 13-24.

SPORER B J, SHAH A P, DOWHAN G V, et al. Multicavity linear transformer driver facility for Z-pinch and high-power microwave research [J]. Physical Review: Accelerators and Beams, 2021, 24(10): 100402.

SLUTZ S A, STYGAR W A, GOMEZ M R, et al. Scaling magnetized liner inertial fusion on Z and future pulsed-power accelerators [J]. Physics of Plasmas, 2016, 23(2): 022702.

BASTRIKOV A N, VIZIR V A, VOLKOV S N, et al. Primary energy storages based on linear transformer stages [J]. Laser and Particle Beams, 2003, 21(2): 295-299.

KIM A A, MAZARAKIS M G. The story of the LTD development [J]. IEEE Transactions on Plasma Science, 2020, 48(4): 749-756.

STYGAR W A, AWE T J, BAILEY J E, et al. Conceptual designs of two petawatt-class pulsed-power accelerators for high-energy-density-physics experiments [J]. Physical Review Special Topics: Accelerators and Beams, 2015, 18(11): 110401.

邓建军, 王勐, 谢卫平, 等. 面向Z箍缩驱动聚变能源需求的超高功率重复频率驱动器技术 [J]. 强激光与粒子束, 2014, 26(10): 100201.

DENG Jianjun, WANG Meng, XIE Weiping, et al. Super-power repetitive Z-pinch driver for fusion-fission reactor [J]. High Power Laser and Particle Beams, 2014, 26(10): 100201.

MAZARAKIS M G, FOWLER W E, LECHIEN K L, et al. High-current linear transformer driver development at Sandia national laboratories [J]. IEEE Transactions on Plasma Science, 2010, 38(4): 704-713.

HE Xu, SUN Fengju, QIU Aici, et al. Four-stage linear transformer driver with sharing shell: EM model, simulation, and performance [J]. IEEE Transactions on Plasma Science, 2021, 49(1): 358-364.

STYGAR W A, LECHIEN K R, MAZARAKIS M G, et al. Impedance-matched Marx generators [J]. Physical Review: Accelerators and Beams, 2017, 20(4): 040402.

STYGAR W, AUSTIN K, AWE T, et al. Conceptual design of a 960-TW accelerator powered by impedance-matched Marx generators [C]∥2017 IEEE 21st International Conference on Pulsed Power. Piscataway, NJ, USA: IEEE, 2017: 1-8.

HUISKAMP T, VAN OORSCHOT J J. Fast pulsed power generation with a solid-state impedance-matched Marx generator: concept, design, and first implementation [J]. IEEE Transactions on Plasma Science, 2019, 47(9): 4350-4360.

JIANG Xiaofeng, SUN Fengju, WANG Zhiguo, et al. A gas-insulated mega-ampere-class linear transformer driver with pluggable bricks [J]. Review of Scientific Instruments, 2020, 91(12): 123303.

WANG Zhiguo, SUN Fengju, QIU Aici, et al. A 80 kV gas switch triggered by a 17 μJ fiber-optic laser [J]. Review of Scientific Instruments, 2020, 91(5): 056104.

孙凤举, 姜晓峰, 王志国, 等. 四级串联共用腔体MA级FLTD的设计与仿真 [J]. 强激光与粒子束, 2018, 30(3): 84-91.

SUN Fengju, JIANG Xiaofeng, WANG Zhiguo, et al. Design and simulation of fast linear transformer driver with four stages in series sharing common cavity shell and mega-ampere current [J]. High Power Laser and Particle Beams, 2018, 30(3): 84-91.

刘鹏. 开关闭合时序及分散性对多级感应腔串联FLTD性能影响的研究 [D]. 西安: 西安交通大学, 2012.

LIU Peng, SUN Fengju, YIN Jiahui, et al. Effect of cavity-triggering sequences on output parameters of LTD-based drivers [J]. IEEE Transactions on Plasma Science, 2011, 39(5): 1247-1253.

LIU Peng, SUN Fengju, WEI Hao, et al. Influences of switching jitter on the operational performances of linear transformer drivers-based drivers [J]. Plasma Science and Technology, 2012, 14(4): 347-352.

刘鹏, 孙凤举, 尹佳辉, 等. 触发时序对直线型脉冲变压器输出参数的影响 [J]. 强激光与粒子束, 2011, 23(5): 1397-1401.

LIU Peng, SUN Fengju, YIN Jiahui, et al. Effect of triggering sequences on output parameters of linear transformer driver [J]. High Power Laser and Particle Beams, 2011, 23(5): 1397-1401.

DOUGLASS J D, HUTSEL B T, LECKBEE J J, et al. 100 GW linear transformer driver cavity: design, simulations, and performance [J]. Physical Review: Accelerators and Beams, 2018, 21(12): 120401.

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Effects of Expansion Angle Crater Film Hole on the Film Cooling Characteristics of a Double-Wall Structure

Knowledge Graph Representation Learning Driven by Semantic Discrimination and Subgraph Integration

Integrated and Joint Design Optimization of Centrifugal Compressor Impeller and Casing Treatment at Multiple Working Points

Bi-Level Multi-Obj ective Optimization of a Wind-Solar Coupled Hydrogen Production System Based on the Synergy of Hybrid Electrolyzer Arrays

Research on the Electrohydrodynamic Effects of Ionic Liquid-Modified Fuels

Related Author

No data

Related Institution

No data

⁰