Leakage Characteristics of Wear Ring Clearance in Liquid Oxygen Turbo Pump under Thermodynamic Effect

ZHENG Xu; BU Xuebing; SUN Zhongguo; XI Guang

doi:10.7652/xjtuxb202207016

您当前的位置：

首页 >

文章列表页 >

Leakage Characteristics of Wear Ring Clearance in Liquid Oxygen Turbo Pump under Thermodynamic Effect

更新时间：2025-07-09

- Leakage Characteristics of Wear Ring Clearance in Liquid Oxygen Turbo Pump under Thermodynamic Effect
- Vol. 56, Issue 7, Pages: 145-155(2022)
- 作者机构：
  
  西安交通大学能源与动力工程学院,西安,710049
- 作者简介：
- 基金信息：
- DOI：10.7652/xjtuxb202207016
  CLC： V434
- Online First：10 July 2022，
  
  Published：2022
- 稿件说明：
移动端阅览
ZHENG Xu, BU Xuebing, SUN Zhongguo, et al. Leakage Characteristics of Wear Ring Clearance in Liquid Oxygen Turbo Pump under Thermodynamic Effect[J]. 2022, 56(7): 145-155.
DOI：

ZHENG Xu, BU Xuebing, SUN Zhongguo, et al. Leakage Characteristics of Wear Ring Clearance in Liquid Oxygen Turbo Pump under Thermodynamic Effect[J]. 2022, 56(7): 145-155. DOI： 10.7652/xjtuxb202207016.

摘要

为精确分析口环间隙泄漏特性及泄漏流动对液氧泵内流场的影响

本文基于SST k-ω湍流模型与High Resolution算法

对某涡轮氧泵进行了全尺寸整场数值模拟

研究了不同流量工况下热力学效应对液氧泵外特性、口环间隙泄漏量及空化特性的影响。研究结果表明

在额定工况点附近

Б.B.奥夫相尼科夫公式预测口环间隙泄漏特性相对准确

偏流量工况下各经验公式预测精度下降; 等体积流量下

工质为液氧时泵效率较常温水介质高4%

口环间隙泄漏量大于水介质下

且泄漏量差值与流量相关; 等温条件下

介质温度对口环间隙泄漏量影响较小

额定工况下高温液氧泄漏损失较大; 考虑热力学效应后

泵腔口环间隙内的温升随流量减小而增大

120%～40%工况下温升约为1～3 K。液氧泵扬程与效率较等温条件结果略有升高

口环间隙进出口涡量增大、泄漏量明显减小

泄漏量减小数值与流量成反比

最大减小量为3%

同时口环间隙内空化加剧。

Abstract

To accurately analyze the leakage characteristics of the wear ring clearance and the influence of the leakage flow on the internal flow field of the liquid oxygen turbo pump

SST k-ω turbulence model and high resolution algorithm are used for numerical simulation of the pump based on full size and the whole flow field to investigate how thermodynamic effects affect under different flow rates

the external characteristics of the pump

the leakage flow rate of the wear ring clearance

and the cavitation characteristics. The results show that each empirical formula from Ovsyannikov can predict the leakage characteristics accurately near the rated operational conditions while it cannot be so accurate in the case of deviation from the rated conditions. The pump efficiency is higher and the leakage is larger for liquid oxygen compared with normal temperature water at the same volume flow rate

and the leakage difference is related to the flow rate of the pump. In the isothermal condition

the leakage flow rate is little affected by the temperature of the working fluid

and the leakage loss is larger when high temperature liquid oxygen is adopted as the working fluid under the rated operational condition. For thermodynamic effects

the temperature rise in the pump cavity and the wear ring clearance increases with the decrease of the flow rate of the pump and is about 1-3 K with the flow rate of the pump growing from 120% to 40%. Compared to the results in the isothermal condition

the pump head and efficiency slightly increase

and the vortex at the inlet and outlet of the wear ring clearance increases

but the leakage significantly decreases. The reduction in the leakage is inversely related to the flow rate of the pump

with a maximum reduction of 3%. Moreover

the cavitation in the wear ring clearance is aggravated.

关键词

Keywords

references

CHILDS D W. Centrifugal-acceleration modes for incompressible fluid in the leakage annulus between a shrouded pump impeller and its housing [J]. Journal of Vibration and Acoustics, 1991, 113(2): 209-218.

YANG Congxin, WANG Xiuyong, CHENG Xiaorui, et al. Hydrodynamically numerical computation and efficiency correction on a supercritical pump with complex double-cases [C]∥2011 Asia-Pacific Power and Energy Engineering Conference. Piscataway, NJ, USA: IEEE, 2011: 1-4.

LI Wenguang. An experimental study on the effect of oil viscosity and wear-ring clearance on the performance of an industrial centrifugal pump [J]. Journal of Fluids Engineering, 2012, 134(1): 014501.

LIU Houlin, DING Jian, DAI Hanwei, et al. Investigation into transient flow in a centrifugal pump with wear ring clearance variation [J]. Advances in Mechanical Engineering, 2014, 6: 693097.

WU Yang, CHEN Xiaoping, DOU Huashu, et al. Numerical simulation and analysis of flow characteristics in the front chamber of a centrifugal pump [J]. Journal of Mechanical Science and Technology, 2017, 31(11): 5131-5140.

DAQIQSHIRAZI M, TORABI R, RIASI A, et al. The effect of wear ring clearance on flow field in the impeller sidewall gap and efficiency of a low specific speed centrifugal pump [J]. Proceedings of the Institution of Mechanical Engineers: Part C Journal of Mechanical Engineering Science, 2018, 232(17): 3062-3073.

ZHANG Sen, LI Huaxing, XI Deke. Investigation of the integrated model of side chamber, wear-rings clearance, and balancing holes for centrifugal pumps [J]. Journal of Fluids Engineering, 2019, 141(10): 101101.

YAN Jianru, ZUO Zhitao, GUO Wenbin, et al. Influences of wear-ring clearance leakage on performance of a small-scale pump-turbine [J]. Proceedings of the Institution of Mechanical Engineers: Part A Journal of Power and Energy, 2020, 234(4): 454-469.

ZHENG Lulu, CHEN Xiaoping, ZHANG Wei, et al. Investigation on characteristics of pressure fluctuation in a centrifugal pump with clearance flow [J]. Journal of Mechanical Science and Technology, 2020, 34(9): 3657-3666.

YAN Chaoshou, LIU Jianfei, ZHENG Shuihua, et al. Study on the effects of the wear-rings clearance on the solid-liquid two-phase flow characteristics of centrifugal pumps [J]. Symmetry, 2020, 12(12): 2003.

吴大转, 许斌杰, 武鹏, 等. 多级离心泵内部间隙流动与泄漏损失 [J]. 浙江大学学报(工学版), 2011, 45(8): 1393-1398.

WU Dazhuan, XU Binjie, WU Peng, et al. Internal clearance flow and leakage loss in multi-stage centrifugal pump [J]. Journal of Zhejiang University(Engineering Science), 2011, 45(8): 1393-1398.

徐立群, 王志恒, 席光. 迷宫密封泄漏对小流量离心叶轮气动性能影响的研究 [J]. 西安交通大学学报, 2010, 44(11): 23-27.

XU Liqun, WANG Zhiheng, XI Guang. Numerical study on effect of seal leakage on performance of centrifugal impeller with low flow coefficient [J]. Journal of Xi'an Jiaotong University, 2010, 44(11): 23-27.

赵万勇, 赵爽, 王磊, 等. 离心油泵口环间隙对泵腔内流动的影响 [J]. 兰州理工大学学报, 2013, 39(1): 33-36.

ZHAO Wanyong, ZHAO Shuang, WANG Lei, et al. Influence of seal ring clearance of centrifugal oil pump on flow characteristics of pump chamber [J]. Journal of Lanzhou University of Technology, 2013, 39(1): 33-36.

牟介刚, 代东顺, 谷云庆, 等. 叶轮口环结构对离心泵性能及流场的影响 [J]. 中南大学学报(自然科学版), 2017, 48(6): 1522-1529.

MOU Jiegang, DAI Dongshun, GU Yunqing, et al. Influences of impeller ring structure on performance and flow field of centrifugal pump [J]. Journal of Central South University(Science and Technology), 2017, 48(6): 1522-1529.

杨从新, 强盼, 安莎, 等. 口环间隙变化对高转速离心泵性能的影响 [J]. 排灌机械工程学报, 2017, 35(1): 18-24.

YANG Congxin, QIANG Pan, AN Sha, et al. Effects of wear-ring clearance on performance of high-speed centrifugal pump [J]. Journal of Drainage and Irrigation Machinery Engineering, 2017, 35(1): 18-24.

贺晓希, 宫武旗, 邓俊杰, 等. 叶轮叶顶间隙对离心制冷压缩机性能的影响 [J]. 西安交通大学学报, 2019, 53(7): 30-37.

HE Xiaoxi, GONG Wuqi, DENG Junjie, et al. Influence of impeller tip clearance on the performance of centrifugal refrigeration compressor [J]. Journal of Xi'an Jiaotong University, 2019, 53(7): 30-37.

赵存生, 韩小溪, 崔哲. 离心泵口环间隙流动特性的数值模拟 [J]. 中国舰船研究, 2020, 15(4): 159-167.

ZHAO Cunsheng, HAN Xiaoxi, CUI Zhe. Numerical simulations of flow characteristics of wear-ring clearance in the centrifugal pump [J]. Chinese Journal of Ship Research, 2020, 15(4): 159-167.

陈鱼, 费振桃, 蔡永雄, 等. 输送清水时口环间隙对离心油泵性能的影响 [J]. 流体机械, 2006, 34(1): 1-5.

CHEN Yu, FEI Zhentao, CAI Yongxiong, et al. Effect of the clearance of wear-rings on the performance of centrifugal oil pump while handling water [J]. Fluid Machinery, 2006, 34(1): 1-5.

李文广, 费振桃, 蔡永雄. 离心油泵叶轮口环间隙对性能的影响 [J]. 水泵技术, 2004(5): 7-13.

LI Wenguang, FEI Zhentao, CAI Yongxiong. Effect of clearance of impeller wear rings upon performance of a centrifugal oil pump [J]. Pump Technology, 2004(5): 7-13.

关醒凡. 泵的理论与设计 [M]. 北京: 机械工业出版社, 1987.

GÜLICH J F. Centrifugal pumps [M]. 4th ed. Cham: Springer, 2020.

ОВСЯННИКОВ Б В, БОРОВСКИЙ Б И. Теория и расчет агрегатов питания жидкостных ракетных двигателей [M]. Москва: Машиностроение, 1986.

黄永华, 陈国邦. 低温流体热物理性质 [M]. 2版. 北京: 国防工业出版社, 2014.

郑路路. 离心泵口环间隙非定常流动机理研究 [D]. 杭州: 浙江理工大学, 2018.

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Sensitivity Analysis of Foil Geometrical Parameters for the Third-Generation CO2 Gas Foil Bearings Based on Design of Experiments Method

Knowledge Graph Representation Learning Driven by Semantic Discrimination and Subgraph Integration

Bi-Level Multi-Obj ective Optimization of a Wind-Solar Coupled Hydrogen Production System Based on the Synergy of Hybrid Electrolyzer Arrays

Review of the Application of EBSILON Software in Combined Heat and Power System Optimization

Numerical Simulation of Heat-Moisture Barrier Performance of a Horizontal Air Curtain in Cold Storage

Related Author

No data

Related Institution

No data

⁰