To optimize the working opening degree range of flue gas damper to improve boiler’s thermal efficiency and the ability to adapt to peak load regulation
the flow fields of a flue gas damper with opening degrees of 10°
20°
30°
40°
50°
60°
70°
80° and 90° are simulated under the condition that the flue gas velocity is 18 m/s. The flow characteristics of the flue gas damper is evaluated according to the flow resistance coefficients
flow coefficients
and the distributions of velocity and pressure of different opening degrees of the flue gas damper. The results show that the uniformity of velocity field and pressure field of downstream flue gas gradually becomes better with the increase of damper opening degree. Along with the increase of damper opening degree
the flow resistance coefficient first decreases rapidly and then decreases slowly and the flow coefficient first increases slowly and then increases rapidly. The resistance of the damper is less than 100 Pa and the flow resistance coefficient of the damper is less than 1.08 when the damper is fully opened. If the total pressure of induced draft fan in the waste heat utilization device is 1 000 Pa
the variation characteristics of flue gas flow is well with the damper opening degree when the damper opens in the range of 17°- 80°. Considering the flow resistance coefficient characteristics of the damper
it is suggested that its opening degree range in common operation is from 40° to 80°.
WANG Yueming, MU Chunhua, YAO Mingyu, et al. Review of the development and application of double-reheat power generation technology [J]. Thermal Power Generation, 2017, 46(8): 1-10.
XU Wei, ZHANG Jian, FAN Haojie, et al. Study on the steam temperature characteristic of a 660 MW flexible double-reheat boiler based on response surface analysis [J]. Journal of Engineering for Thermal Energy and Power, 2020, 35(2): 110-115.
LI Yuan, ZHANG Huibing, DAI Ye, et al. Flow characteristics analysis and numerical simulation in safety valve cavity [J]. Journal of Harbin University of Science and Technology, 2020, 25(1): 15-21.
BU Huanxian, TAN Huijun, HE Xiaoming, et al. Flow field characteristics in an axisymmetric bend duct with struts [J]. Journal of Aerospace Power, 2016, 31(5): 1252-1259.
QIAN Jinyuan, WEI Lin, JIN Zhijiang, et al. CFD analysis on the dynamic flow characteristics of the pilot-control globe valve [J]. Energy Conversion and Management, 2014, 87: 220-226.
JIANG Linsong, LIU Hongsheng, SUO Shaoyi, et al. Pore-scale simulation of flow and turbulence characteristics in three-dimensional randomly packed beds [J]. Powder Technology, 2018, 338: 197-210.
LI Yanhui, LIAO Zhifang, JIANG Jin, et al. Flow characteristics analysis of large-diameter flow and pressure regulating valve with piston sleeve [J]. Journal of Hydraulic Engineering, 2019, 50(4): 516-523.
LISOWSKI E, FILO G. CFD analysis of the characteristics of a proportional flow control valve with an innovative opening shape [J]. Energy Conversion and Management, 2016, 123: 15-28.
WANG Haimin, ZHAO Yue, WANG Jianxing, et al. Numerical simulation of flow characteristics for a labyrinth passage in a pressure valve [J]. Journal of Hydrodynamics, 2016, 28(4): 629-636.
XIANG Xiaowei, MAO Jingru, SUN Bi, et al. Numerical investigation of flow characteristic of control valve of steam turbine in the entire range of operating mode [J]. Journal of Xi’an Jiaotong University, 2006, 40(3): 289-293.
CUI Baoling, LIN Zhe, ZHU Zuchao, et al. Influence of opening and closing process of ball valve on external performance and internal flow characteristics [J]. Experimental Thermal and Fluid Science, 2017, 80: 193-202.
KANG Yuan, SHEN Pingchen, CHANG Yeonpun, et al. Modified predictions of restriction coefficient and flow resistance for membrane-type restrictors in hydrostatic bearing by using regression [J]. Tribology International, 2007, 40(9): 1369-1380.
NI Linsen, LI Yixing, ZHANG Kunyu. Flow characteristics analysis of lubricating oil control valve [J]. Ship Science and Technology, 2019, 41(5): 105-109.
HE Huimin, ZHANG Xiaoyi. Numerical simulation of two-phase flow characteristics of control valve in AP1000 nuclear power steam turbine [J]. Turbine Technology, 2017, 59(1): 43-45, 46.
LIAO Zhifang, WANG Ronghui, TAN Huipan, et al. Numerical simulation of the flow field in DN1000 super-capped hemispherical valve [J]. Hydropower and New Energy, 2019, 33(3): 16-19.
SUN Xiao, XIE Zhihang. Flow characteristics of check valves and optimal design of valve cores [J]. Journal of Hunan University of Technology, 2018, 32(6): 39-44.
DENG Bin, TAO Wenquan. Numerical simulation and experimental study on turbulent flow in shell side of shell-and-tube heat exchangers [J]. Journal of Xi’an Jiaotong University, 2003, 37(9): 889-893, 924.
WANG Chao, LI Guoxiu, SUN Zuoyu, et al. Effects of structure parameters on flow and cavitation characteristics within control valve of fuel injector for modern diesel engine [J]. Energy Conversion and Management, 2016, 124: 104-115.
WU Dazhuan, LI Shiyang, WU Peng. CFD simulation of flow-pressure characteristics of a pressure control valve for automotive fuel supply system [J]. Energy Conversion and Management, 2015, 101: 658-665.
MA Guangfei, JI Jiankang, YAO Dan, et al. Effects of valve body clearance on valve performance and internal flow field distribution [J]. Journal of Drainage and Irrigation Machinery Engineering, 2019, 37(11): 960-966.
Flow Field Analysis for a New Type of Steam Pulsed Acoustic Dust Cleaning Device
Study of the Mechanism of Electrostatic Accumulation and Current Density Distribution Characteristics During Liquid Hydrogen Pipeline Transportation
Numerical Simulation of Space Charge Distribution Characteristics of Polyimide Materials under X-Ray Irradiation
Numerical Simulation Study on Geothermal Extraction Characteristics of Supercritical CO2 in Heterogeneous Fractures
Action Mechanism of Heat Transfer between the Working Medium and the Impeller on Aerodynamic Performance and Flow Characteristics of Radial Inflow Turbines with Supercritical Carbon Dioxide
Related Author
鲁敬妮 1
屠珊 1
卓敏鹏 2
王红娟 1
洪振瀚 1
SUN Wenhao
LIU Hongbao
WANG Lei
Related Institution
School of Energy and Power Engineering, Xi'an Jiaotong University
School of Energy and Power Engineering,Xi’an Jiaotong University
Aerospace System Engineering Shanghai
School of Electrical Engineering,Xi’an Jiaotong University