Parametric Investigation on the Effects of Slotted Diffuser on a Highly Loaded Centrifugal Compressor

doi:10.7652/xjtuxb201909005

您当前的位置：

首页 >

文章列表页 >

Parametric Investigation on the Effects of Slotted Diffuser on a Highly Loaded Centrifugal Compressor

更新时间：2025-07-09

- Parametric Investigation on the Effects of Slotted Diffuser on a Highly Loaded Centrifugal Compressor
- Vol. 53, Issue 9, Pages: 34-41(2019)
- 作者机构：
  
  1. 中国科学院工程热物理研究所,北京,100190
  2. 中国科学院大学,北京,100049
- 作者简介：
- 基金信息：
- DOI：10.7652/xjtuxb201909005
  CLC： V231.3
- Online First：10 September 2019，
  
  Published：2019
- 稿件说明：
移动端阅览
Parametric Investigation on the Effects of Slotted Diffuser on a Highly Loaded Centrifugal Compressor[J]. 2019, 53(9): 34-41.
DOI：

Parametric Investigation on the Effects of Slotted Diffuser on a Highly Loaded Centrifugal Compressor[J]. 2019, 53(9): 34-41. DOI： 10.7652/xjtuxb201909005.

摘要

针对离心压气机在近失速工况点运行时

扩压器进口气流角为正攻角

造成其吸力面发生流动分离

从而导致压气机发生失速甚至喘振等问题

为进一步扩大离心压气机的稳定工作范围

需对扩压器近失速工况点的流动分离进行抑制。以某高负荷离心压气机为研究对象

利用经过校核的数值模拟方法开展了扩压器叶片前缘开槽的参数化研究

详细探讨了开槽长度、深度对离心压气机性能、稳定裕度的影响规律

归纳总结了离心压气机扩压器的最佳开槽参数。研究结果表明:随着开槽深度、长度的增加

失速裕度有所提高但压气机性能有所下降; 实际设计中开槽深度不应超过叶片高度的9%

最佳开槽长度不应超过叶片弦长的6%～12%; 当扩压器开槽深度为叶片高度的3%、开槽长度为叶片弦长的6%～12%时

压气机性能最佳。扩压器开槽可有效抑制其通道内的流动分离

并提高压气机的失速裕度。

Abstract

When a centrifugal compressor operates near the stall point

the positive incidence angle at the diffuser inlet makes flow separation appear near the diffuser suction side

leading to compressor stall and surge.The leading edge structure of diffuser has an important effect on the compressor's performance and flow field.To extend stable operating range of centrifugal compressors

the flow separations within the diffuser passage near stall point need to be suppressed.In this research

numerical simulations were performed for a highly loaded centrifugal compressor to investigate the design method of slotted diffuser and discuss the influences of slot length and depth on the stage performance and stall margin.The results indicate that the compressor performance is deteriorated with the increase of slot length and depth

although the stall margin is expanded.In conclusion

the slot depth should not exceed 9% of the diffuser vane height

and the optimal slot length should not be more than 6%

关键词

Keywords

references

崔伟伟, 杜建一, 徐建中.离心压气机的叶片扩压器设计及流场分析 [J].工程热物理学报, 2010, 31(2): 259-262.

CUI Weiwei, DU Jianyi, XU Jianzhong.Design and flow field analysis on vaned diffuser in centrifugal compressor [J].Journal of Engineering Thermophysics, 2010, 31(2): 259-262.

西安交通大学透平压缩机教研室.离心式压缩机原理 [M].北京: 机械工业出版社, 1980: 114-120.

FUJISAWA N, INUI T, OHTA Y.Evolution process of diffuser stall in a centrifugal compressor with vaned diffuser [J].ASME Journal of Turbomachinery, 2019, 141(4): 041009.

ERICKSON D W, TAN C S, MACRORIE M.Characterization and impact of secondary flows in a discrete passage centrifugal compressor diffuser [J].ASME Journal of Turbomachinery, 2019, 141(7): 071009.

郭爽, 陈绍文, 陆华伟, 等.组合抽吸对大转角扩压叶栅性能的影响 [J].航空动力学报, 2010, 25(12): 2697-2703.

GUO Shuang, CHEN Shaowen, LU Huawei, et al.Effect of compound boundary layer suction on the performance of a high-load diffusion compressor cascade with a large camber angle [J].Journal of Aerospace Power, 2010, 25(12): 2697-2703.

陈萍萍, 乔渭阳, LIESNER K, 等.边界层吸气对压气机叶栅角区分离损失的控制 [J].航空学报, 2014, 35(11): 3000-3011.

CHEN Pingping, QIAO Weiyang, LIESNER K, et al.Boundary layer suction on hub-corner separation loss in a linear compressor cascade [J].Acta Aeronautica and Astronautica Sinica, 2014, 35(11): 3000-3011.

吴云, 李应红.等离子体流动控制研究进展与展望 [J].航空学报, 2015, 36(2): 381-405.

WU Yun, LI Yinghong.Progress and outlook of plasma flow control [J].Acta Aeronautica and Astronautica Sinica, 2015, 36(2): 381-405.

UBBEN S, NIEHUIS R.Experimental investigation of the diffuser vane clearance effect in a centrifugal compressor stage with adjustable diffuser geometry: part I Compressor performance analysis [J].ASME Journal of Turbomachinery, 2015, 137(3): 031003.

ISHIDA M, MURAKAMI T, SAKAGUCHI D, et al.Analysis of secondary flow behavior in low solidity cascade diffuser of a centrifugal blower [C]∥ASME Turbo Expo 2010: Power for Land, Sea, and Air.New York, USA: ASME, 2010: 1973-1982.

SAKAGUCHI D, MURAKAMI T, UEKI H, et al.Unsteady flow analysis of interaction between jet-wake flow and blades of low solidity cascade diffuser in a centrifugal blower [C]∥ASME 2011 Turbo Expo: Turbine Technical Conference and Exposition, New York, USA: ASME, 2011: 405-413.

王毅, 卢新根, 赵胜丰, 等.高负荷离心压气机扩压器叶片前缘结构分析 [J].推进技术, 2011, 32(2): 175-181.

WANG Yi, LU Xingen, ZHAO Shengfeng, et al.Effects of diffuser blade geometry at leading edge on a highly-loaded centrifugal compressor [J].Journal of Propulsion Technology, 2011, 32(2): 175-181.

OHTA Y, GOTO T, OUTA E.Effects of tapered diffuser vane on the flow field and noise of a centrifugal compressor [J].Journal of Thermal Science, 2007, 16(4): 301-308.

OHTA Y, GOTO T, OUTA E.Unsteady behavior and control of diffuser leading-edge vortex in a centrifugal compressor [C]∥ASME Turbo Expo 2010: Power for Land, Sea, and Air.New York, USA: ASME, 2010: 1805-1813.

MARSAN A, TRÉBINJAC I, MOREAU S, et al.Active flow control in a radial vaned diffuser for surge margin improvement: a multislot suction strategy [J].International Journal of Rotating Machinery, 2017(4): 1-12.

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Conjugate Heat Transfer on the Performance of Rotating Components in Ultra-Micro Gas Turbines

Integrated and Joint Design Optimization of Centrifugal Compressor Impeller and Casing Treatment at Multiple Working Points

Study of the Mechanism of Electrostatic Accumulation and Current Density Distribution Characteristics During Liquid Hydrogen Pipeline Transportation

Numerical Simulation of Space Charge Distribution Characteristics of Polyimide Materials under X-Ray Irradiation

Numerical Simulation Study on Geothermal Extraction Characteristics of Supercritical CO2 in Heterogeneous Fractures

Related Author

YAO Xuerui

XU Mengjuan

LIU Zhao

FENG Zhenping

LU Yifan

ZHANG Xiawen

LI Zhen

JU Yaping

Related Institution

School of Energy and Power Engineering, Xi’an Jiaotong University

School of Mechanical Engineering, Xi’an Jiaotong University

School of Energy and Power Engineering，Xi'an Jiaotong University

School of Energy and Power Engineering，Xi’an Jiaotong University

Aerospace System Engineering Shanghai

⁰