Numerical Investigation and Optimization on Boiling Heat Exchange of Antenna Surface

doi:10.7652/xjtuxb201411011

您当前的位置：

首页 >

文章列表页 >

Numerical Investigation and Optimization on Boiling Heat Exchange of Antenna Surface

更新时间：2025-07-09

- Numerical Investigation and Optimization on Boiling Heat Exchange of Antenna Surface
- Vol. 48, Issue 11, Pages: 64-69(2014)
- 作者机构：
  
  西安交通大学能源与动力工程学院,西安,710049
- 作者简介：
- 基金信息：
- DOI：10.7652/xjtuxb201411011
  CLC： TM216.1
- Online First：10 November 2014，
  
  Published：2014
- 稿件说明：
移动端阅览
Numerical Investigation and Optimization on Boiling Heat Exchange of Antenna Surface[J]. 2014, 48(11): 64-69.
DOI：

Numerical Investigation and Optimization on Boiling Heat Exchange of Antenna Surface[J]. 2014, 48(11): 64-69. DOI： 10.7652/xjtuxb201411011.

摘要

为研究雷达天线阵面的冷却降温效果

建立了两相流蒸发冷却模型

并着重分析了沸腾换热在局部高热流密度条件下的换热能力

局部热流高达800 kW/m

。采用VOF模型结合用户自定义控制方程

数值计算三维流道内的沸腾传热现象

从气液流动趋势上寻找阻碍换热的因素。结果表明:VOF模型能较好地用于分析气液两相流动中的层状流、泡状流以及气液流动趋势; 通过减小弯道处过流面积提高局部流速的方法可以缓解气相在弯道处的汇聚

消除了0.9 K的局部过热; 对于单侧高热流蒸发的数值分析

蒸发控制方程的调节系数在500左右为宜。温度计算结果与实验结果趋势一致

总体偏差5 K左右

数值分析可以用于研究冷板的沸腾换热。

Abstract

The evaporative cooling of two-phase model was established to cool the antenna surface with partial high heat flux. The analysis was focused on the ability of cooling under the local high heat flux of 800 kw/m

. Using VOF model

as well as the governing equation defined by the user

the computation of the boiling heat exchange in the three-dimensional pipe was performed to study the reason of hindering the heat exchange from the flow of the vapor and liquid. Results show that

the model could be well used in the analysis of stratified flow

bubble flow and the flow trend of vapor and liquid in the two-phase flow. Decreasing the flow area of the curved tube and increasing the local velocity could reduce the converging of the vapor. And the local superheat of 0.9 K was dismissed. The coefficien

t in the evaporation control equation should be increased to about 500 to ensure the accuracy of simulation in the partial high flux model. The overall error of the numerical result was about 5 K but the tendency of the temperature was similar with the experiment. So

numerical analysis could be used in the study of the boiling heat exchange for the cold plate.

关键词

Keywords

references

姚涛, 候哲, 顾国彪. 蒸发冷却技术应用于大型汽轮发电机的技术可行性[J]. 电工技术学报, 2008, 23(2): 1-5.

YAO Tao, HOU Zhe, GU Guobiao. Application of evaporative cooling technique to large turbo generator[J]. Transactions of China Electrotechnical Society, 2008, 23(2): 1-5.

熊楠. 蒸发冷却技术面对的几个重要问题[J]. 电工电能新技术, 2001, 3(1): 36-40.

XIONG Nan. Main tasks for research and practice of evaporation-cooling technology[J]. Advanced Technology of Electrical Engineering and Energy, 2001, 3(1): 36-40.

郭雷. 微细通道流动沸腾换热机理及实验研究[D]. 济南: 山东大学, 2011.

曾阳. 蒸发冷却换热器的数值模拟与实验研究[D]. 长沙: 湖南大学, 2011.

姜澎, 黄洪雁, 冯国泰, 等. 水雾/蒸汽相变冲击冷却的数值模拟[J]. 哈尔滨工程大学学报, 2009, 30(10): 1097-1101.

JIANG Peng, HUANG Hongyan, FENG Guotai, et al. Numerically simulating mist/steam impingement cooling with phase change[J]. Journal of Harbin Engineering University, 2009, 30(10): 1097-1101.

ZHUAN Rui, WANG Wen. Simulation of subcooled flow boiling in a micro-channel[J]. Refrigeration International Journal of Refrigeration, 2010, 34(3): 781-795.

ZHUAN Rui, WANG Wen. Simulation on nucleate boiling in micro-channel[J]. Heat Mass Transfer, 2010, 53(1): 502-512.

THOME J R, DUPONT V, JACOBI A M. Heat transfer model for evaporation in micro channels[J]. Heat Mass Transfer, 2004, 47(14): 3375-3385.

LEE W, SON G. Numerical simulation of boiling enhancement on a micro-structured surface[J]. Heat Mass Transfer, 2011, 38(2): 168-173.

ZHANG N L, CHAO D F. Models for enhanced boiling heat transfer by unusual Marangoni effects under microgravity conditions[J]. Heat Mass Transfer, 1999, 26(8): 1081-1090.

RICARDO J, LIMA D S, THOME J R, et al. Two-phase flow boiling in horizontal smooth tubes: new heat transfer results for R134a at three saturation temperatures[J]. Applied Thermal Engineering, 2009, 29(7): 1289-1298.

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Research on the Electrohydrodynamic Effects of Ionic Liquid-Modified Fuels

Sensitivity Analysis of Foil Geometrical Parameters for the Third-Generation CO2 Gas Foil Bearings Based on Design of Experiments Method

A Fast Calculation Method for Thermal Flow Fields in Transformer Windings Based on PI-DeepONet

Bi-Level Multi-Obj ective Optimization of a Wind-Solar Coupled Hydrogen Production System Based on the Synergy of Hybrid Electrolyzer Arrays

Review of the Application of EBSILON Software in Combined Heat and Power System Optimization

Related Author

No data

Related Institution

No data

⁰