Numerical Predictions of Flow and Heat Transfer for Rotating Internal Cooling Channels with Rib Turbulators

doi:10.7652/xjtuxb201402021

您当前的位置：

首页 >

文章列表页 >

Numerical Predictions of Flow and Heat Transfer for Rotating Internal Cooling Channels with Rib Turbulators

更新时间：2025-07-09

- Numerical Predictions of Flow and Heat Transfer for Rotating Internal Cooling Channels with Rib Turbulators
- Vol. 48, Issue 2, Pages: 125-130(2014)
- 作者机构：
  
  西北工业大学动力与能源学院,西安,710072
- 作者简介：
- 基金信息：
- DOI：10.7652/xjtuxb201402021
  CLC： V231.1
- Online First：10 February 2014，
  
  Published：2014
- 稿件说明：
移动端阅览
Numerical Predictions of Flow and Heat Transfer for Rotating Internal Cooling Channels with Rib Turbulators[J]. 2014, 48(2): 125-130.
DOI：

Numerical Predictions of Flow and Heat Transfer for Rotating Internal Cooling Channels with Rib Turbulators[J]. 2014, 48(2): 125-130. DOI： 10.7652/xjtuxb201402021.

摘要

为进一步了解涡轮动叶旋转内冷通道的流动换热规律

选取动叶内通道的相似放大模型进行实验和数值模拟研究。通道进口雷诺数为17 000

3个出口的流量分配比为1:2:1

旋转半径与水力直径比为46.4

旋转数分别为0和0.09。静止实验测量了沿程静压系数和努赛尔数(Nu)分布

三维数值模拟了旋转通道内部涡结构对流动换热的影响。结果表明:旋转造成通道涡偏移

改变了速度场分布

使哥氏力指向的壁面附近流速增加; 旋转离心力使径向出流沿程静压系数逐渐增加

径向入流沿程静压系数迅速降低; 肋扰流涡使沿程展向平均Nu呈多波峰状分布; 转弯回流涡使得转弯下游通道的Nu不对称分布; 旋转促使内通道的流体偏向哥氏力指向的壁面

增加了径向出流压力面和径向入流吸力面的Nu。

Abstract

To investigate flow and heat transfer in a rotating internal channel of the moving blade

experiments and numerical simulations for a similarly amplified channel model with 90°ribs are conducted. The inlet Reynolds number

flow rate distribution ratio and geometric dimensionless ratio are taken as 17 000

1:2:1 and 46.4 respectively

the rotating number is considered as 0 and 0.09. The heat transfer coefficient distribution and static pressure coefficient are examined by experiments. The effects of vortex on flow and heat transfer in rotating internal cooling passage are achieved with 3-D numerical simulation. The results show that vortex shift in rotating channel changes velocity field

and the static pressure coefficient increases along radial outflow and decreases along radial inflow due to centrifugal force. The laterally averaged Nu distributes in multiple-peak form as the result of secondary flow induced by rib turbulators. The Nu distribution down stream of turning area gets asymmetric due to turning eddy. The fluid shift tends toward the wall that the Coriolis force points to. Consequently

the Nu on the radial outflow pressure surface and radial inflow suction surface increases.

关键词

Keywords

references

JANG Yongjun, CHEN Hamnching, HAN Jechin. Flow and heat transfer in a rotating square channel with 45-deg angled ribs by Reynolds stress turbulence model[J]. ASME Journal of Turbomachinery, 2001, 123(1): 124-132.

SU Guoguang, CHEN Hamnching, HAN Jechin. Computation of flow and heat transfer in two-pass rotating rectangular channels(AR=1:1, AR=1:2, AR=1:4)with 45-deg angled ribs by a Reynolds stress turbulence model[C]∥Proceedings of the ASME Turbo Expo 2004. Norcross, GA, USA: American Society of Mechanical Engineers, 2004: 603-612.

FU Wenlong, WRIGHT L M, HAN Jechen. Heat transfer in two-pass rotating rectangular channels(AR=1:2 and AR=1:4)with 45° angled rib turbulators[C]∥Proceedings of the ASME Turbo Expo 2004. Norcross, GA, USA: American Society of Mechanical Engineers, 2004: 305-315.

ACHARYA S, AGARWAL P. Heat/mass transfer in a 4:1 AR smooth and ribbed coolant passage with rotation in 90-degree and 45-degree orientations[C]∥Proceedings of the ASME Turbo Expo 2004. Norcross, GA, USA: American Society of Mechanical Engineers, 2004: 813-824.

CHO H H, KIM Y Y, RHEE D H. The effects of gap position in discrete ribs on local heat/mass transfer in a square duct[J]. Journal of Enhanced Heat Transfer, 2003, 10(7/9): 287-300.

LIU Yaohsien, HUH M, HAN Jechin. High rotation number effect on heat transfer in a triangular channel with 45°, inverted 45°, and 90° ribs[J]. ASME Journal of Heat Transfer, 2010, 132(7): 1-10.

MAURER M, VON WOLFERSDORF J, GRITSCH M. An experimental and numerical study of heat transfer and pressure losses of V- and W-shaped ribs at high Reynolds numbers[C]∥Proceedings of the ASME Turbo Expo 2007. Norcross, GA, USA: American Society of Mechanical Engineers, 2007: 219-228.

ABDEL W S, TAFTI D K. Large eddy simulation of flow and heat transfer in a 90° ribbed duct with rotation effect of Coriolis and centrifugal buoyancy forces[C]∥Proceedings of the ASME Turbo Expo 2004. Norcross, GA, USA: American Society of Mechanical Engineers, 2004: 711-721.

AHN J, LEE J S. Large eddy simulation of flow and heat transfer in a channel with a detached rib array[J]. International Journal of Heat and Mass Transfer, 2010, 53(1): 445-452.

SCHROLL M, LANGE L, WLDWER M. Investigation of the effect of rotation on the flow in a two-pass cooling system with smooth and ribbed walls using PIV[C]∥Proceedings of the ASME Turbo Expo 2011. Norcross, GA, USA: American Society of Mechanical Engineers, 2011: 1653-1664.

POSER R, WOLFERSDORF J V, LUTUM E, et al. Performing heat transfer experiments in blade cooling circuits using a transient technique with thermochromic liquid crystals[C]∥Proceedings of the ASME Turbo Expo 2008. Norcross, GA, USA: American Society of Mechanical Engineers, 2008: 331-340.

郑杰, 朱惠人, 赵曙, 等. 湍流模型对旋转状态下S型带肋回转通道内部换热特性的影响[J]. 科学技术与工程, 2012, 12(3): 2090-2095.

ZHENG Jie, ZHU Huiren, ZHAO Shu, et al. Influences of turbulence models on heat transfer of rotating ribber S-bend passage[J]. Science Technology and Engineering, 2012, 12(3): 2090-2095.

苏福斌, 朱惠人, 郭涛, 等. 内冷通道带肋和出流孔壁面的换热研究[J]. 航空动力学报, 2009, 24(7): 1500-1506.

SU Fubin, ZHU Huiren, GUO Tao, et al. Heat transfer enhancement within an internal passage by combinations of ribs and suction holes[J]. Journal of Aerospace Power, 2009, 24(7): 1500-1506.

刘传凯, 丁水汀, 陶智. 旋转附加力对方通道内流动与换热的影响机理[J]. 北京航空航天大学学报, 2009, 35(3): 276-280.

LIU Chuankai, DING Shuiting, TAO Zhi. Effect of rotating induced forces on fluid flow and heat transfer in square channel[J]. Journal of Beijing University of Aeronautics and Astronautics, 2009, 35(3): 276-280.

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Heat Transfer and Pressure Drop on Multi-Turn Connected Internal Cooling Channels

Experimental Study on the Cooling Performance of Thick-Wall Ribbed Channels in Turbine Blade

Numerical Investigation on the Flow and Heat Transfer Characteristics of the Flow-Around Rib Channel

Effects of Expansion Angle Crater Film Hole on the Film Cooling Characteristics of a Double-Wall Structure

Multi-Objective Optimization of Flow and Heat Transfer in Matrix Cooling Channels with Tapered Holes

Related Author

付猛 2

李云龙 1

赵振 1

高建民 1

徐亮 1

席雷 1

梁钊

Related Institution

School of Power and Energy, Northwestern Polytechnical University

State Key Laboratory for Manufacturing Systems Engineering, Xi'an Jiaotong University

School of Energy and Power Engineering, Xi'an Jiaotong University

School of Mechanical Engineering，Xi'an Jiaotong University

School of Energy and Power Engineering，Xi'an Jiaotong University

⁰