Experimental Study on Loop Heat Pipe with Flat Evaporator at Different Tilt Angles

doi:10.7652/xjtuxb201305007

您当前的位置：

首页 >

文章列表页 >

Experimental Study on Loop Heat Pipe with Flat Evaporator at Different Tilt Angles

更新时间：2025-07-09

- Experimental Study on Loop Heat Pipe with Flat Evaporator at Different Tilt Angles
- Vol. 47, Issue 5, Pages: 38-43(2013)
- 作者机构：
  
  西安交通大学动力工程多相流国家重点实验室,西安,710049
- 作者简介：
- 基金信息：
- DOI：10.7652/xjtuxb201305007
  CLC： TK124
- Online First：10 May 2013，
  
  Published：2013
- 稿件说明：
移动端阅览
Experimental Study on Loop Heat Pipe with Flat Evaporator at Different Tilt Angles[J]. 2013, 47(5): 38-43.
DOI：

Experimental Study on Loop Heat Pipe with Flat Evaporator at Different Tilt Angles[J]. 2013, 47(5): 38-43. DOI： 10.7652/xjtuxb201305007.

摘要

为了解决电子元器件的高效散热问题

自行设计了一套平板型环路热管

从减小平板型环路热管背向漏热及改善系统内部流动性能方面

对蒸发器结构及管线布局进行改善

重点讨论了0°、30°、45°、60°、90°倾角时平板型环路热管的启动性能、运行特性及传热特性。结果发现:与0°倾角相比

有倾角存在时系统有更低的启动功率

在相同功率范围内

蒸发器运行温度更低

运行过程更加稳定

但对于倾角之间的各种情况

系统的运行特性差距很小; 在传热性能方面

系统热阻都随功率的增加而减小

最后趋于平稳; 在相同功率范围内

0°倾角时系统热阻略高于有倾角时的情况

而对于各倾角之间的情况

仅在功率很低(20 W以内)时系统热阻差较大

但随着功率的增大

系统热阻变化基本一致。

Abstract

To realize highly efficient heat dissipation of electronics

a loop heat pipe(LHP)with a flat evaporator was designed to study its operation characteristics at the tilt angles of 0°

30°

45°

60°

90° with an improved evaporator structure and a well arranged pipes which can reduce heat loss due to back conduction and improve inner flow performance. The results show that the LHP with inclination has a lower power to start up than the horizontal one

and at the same heat load

the operation temperature of the evaporator is much lower and the system is easier to reach a steady state with less temperature oscillations. However

there is slight difference in operating performance for the LHP at different title angles. The thermal resistance decreases with an increase in the heat load and a steady state occurs at last. The thermal resistance is larger for the horizontal case than that for the inclination case at the same heat load. The thermal resistances are very different at different tilt angles at low heat load

but the difference is small at high heat load.

关键词

Keywords

references

MCGLEN R J, JACHUCK R, LIN Song. Integrated thermal management techniques for high power electronic devices [J]. Applied Thermal Engineering, 2004, 24(8/9): 1143-1156.

KU J. Operating characteristics of loop heat pipes [C]∥29th International Conference on Environmental System. Washington, DC, USA: SAE, 1999: 1999-01-2007.

MAYDANIK Y F. Loop heat pipes [J]. Applied Thermal Engineering, 2005, 25(5): 635-657.

LIU Z C, LIU W, NAKAYAMA A. Flow and heat transfer analysis in porous wick of CPL evaporator based on field synergy principle [J]. Heat and Mass Transfer, 2007, 43(12): 1273-1281.

GAI Dongxing, LIU Zhichun, LIU Wei, et al. Operational characteristics of miniature loop heat pipe with flat evaporator [J]. Heat and Mass Transfer, 2009, 46(2): 267-275.

BECKER S, VERSHININ S, SARTRE V, et al. Steady state operation of a copper-water LHP with a flat-oval evaporator [J]. Applied Thermal Engineering, 2011, 31(5): 686-695.

CHEN B B, LIU Z C, LIU W, et al. Operational characteristics of two biporous wicks used in loop heat pipe with flat evaporator [J]. International Journal of Heat and Mass Transfer, 2012, 55(7/8): 2204-2207.

KU J, OTTENSTEIN L, KOBEL M, et al. Temperature oscillations in loop heat pipe operation [J]. AIP Conference Proceedings, 2001, 52(1): 255-265.

韩晓红,闵旭伟,李鹏,等.一种利用气泡泵效应重力辅助回路热管的实验研究.2012,46(3):9-14.

张海清,郭蓓.采用分布参数模型的CO2微通道蒸发器数值模拟.2012,46(1):42-47.

郭宪民,王善云,汪伟华,等.环境参数对空气源热泵蒸发器表面霜层影响研究.2011,45(3):30-34.

白涛,晏刚,张倩.R41跨临界单级压缩带回热器热泵系统研究.2011,45(3):35-39.

王永涛,吴裕远,禹志强,等.NH3-H2O-LiBr吸收式制冷机吸收和蒸发性能的实验研究.2011,45(3):40-43.

黄东,吴蓓.风速非均匀分布对蒸发器性能的影响.2010,44(9):6-10.

邱晟华,何永清,毕勤成.充灌磁性液体的脉动热管试验研究.2010,44(7):6-8.

黄东,贾杰楠.室外换热器流路布置对热泵空调器的性能影响分析.2010,44(7):33-37.

李权旭,孙敏超,黄东.风速分布对双排管两流路蒸发器性能影响的模拟研究.2010,44(5):50-55.

盖东兴,刘伟,刘志春,等.环路热管系统温度波动的机理研究.2010,44(3):26-31.

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Numerical Investigations on Flow and Heat Transfer Characteristics of Transonic Turbine Blade Tips

Integrated and Joint Design Optimization of Centrifugal Compressor Impeller and Casing Treatment at Multiple Working Points

Research on the Electrohydrodynamic Effects of Ionic Liquid-Modified Fuels

Energy Efficiency Optimization of the Cryogenic Air Separation Process for Electronic-Grade Ultra Pure Nitrogen

Mechanism and Optimal Control Strategy for Hysteresis in Rapid Dehumidification Response of Indirect Thermal Systems in Electric Vehicles

Related Author

杜昆 1

李军 1

Related Institution

School of Energy and Power Engineering, Xi'an Jiaotong University

⁰