Experimental Research on Heat Transfer Performance of Novel Radial Flat Heat Pipe

张亚平 1; 2; 余小玲 1; 周恩民 1; 冯全科 1

您当前的位置：

首页 >

文章列表页 >

Experimental Research on Heat Transfer Performance of Novel Radial Flat Heat Pipe

更新时间：2025-12-08

- Experimental Research on Heat Transfer Performance of Novel Radial Flat Heat Pipe
- Vol. 41, Issue 7, Pages: 780-783(2007)
- 作者机构：
  
  1. 西安交通大学能源与动力工程学院,西安,710049
  2. 西安科技大学能源学院,西安,710054
- 作者简介：
- 基金信息：
- DOI：
  CLC： TK124
- Online First：10 July 2007，
  
  Published：2007
- 稿件说明：
移动端阅览
张亚平 1, 2, 余小玲 1, et al. Experimental Research on Heat Transfer Performance of Novel Radial Flat Heat Pipe[J]. 2007, 41(7): 780-783.
DOI：

张亚平 1, 2, 余小玲 1, et al. Experimental Research on Heat Transfer Performance of Novel Radial Flat Heat Pipe[J]. 2007, 41(7): 780-783. DOI：

摘要

提出了一种能够代替金属基板

并能与大功率模块一体化设计的新型径向平板热管结构.相对于金属基板

该热管基板的优势在于利用两相沸腾换热对功率模块内的集中热源进行扩散

因此其热扩散能力大大高于以导热热扩散的金属基板

从而能够提高模块的功率密度.对径向平板热管进行了稳态和瞬态传热性能实验

并与铜基板的实验结果进行了对比.结果表明:与铜基板相比

径向平板热管具有更高的热扩散能力

可降低模块的结壳热阻; 热管冷凝面具有良好的等温性

当芯片功率密度为176 W/cm

时

热管冷凝面的温差在3 ℃以内; 热管模块启动过程中芯片达到相同温度需要的时间长

有利于克服功率“飙升”和提高功率器件抗热冲击的性能.

Abstract

A novel radial flat heat pipe(RFHP)integrated with high power module instead of metal substrate was developed. Compared with metal substrate

the RFHP uses two-phase boiling heat transfer to diffuse heat in power module

and thus improve the thermal performance of the power module. The transient and steady heat transfer performance of the RFHP was experimentally measured and compared with that of copper substrate. Experiment result indicates that the RFHP has greater thermal diffusivity

and can reduce junction-to-case thermal resistance of the module. When power density is 176 W/cm

the temperature difference on the condensation section is within 3 ℃. The longer time period for the chip to reach the same temperature during RFHP module start-up can avoid power uprush a

nd raise the ability of resisting thermal impact.

关键词

Keywords

references

岂兴明.小型平板热管的研究[D].长春:吉林大学机械工程学院,2004.

Cao Yang, Gao Ming. High heat flux network heat pipes employing boiling mechanisms in a narrow space[M].Atlanta, GA:McGraw-Hill,1997:23-25.

程德威,胡幼明,王惠龄.新型平板热管流动与传热特性的理论分析[J].低温工程,1998,6(2):42-48.

Cheng Dewei,Hu Youming, Wang Huiling.Analysis of flow and heat transfer characteristics of a new flat plate heat pipe[J].Cryogenics Engineering,1998,6(2):42-48.

Hopkins R, Faghri A, Krustalev D. Flat miniature heat pipes with micro capillary grooves[J].ASME Journal of Heat Transfer,1999,121(1):102-109.

Dunn A, Yitner A.Analyses of flat heat pipe with capillary grooves [C]∥International Heat Pipe and Transfer Conference. Seoul: Boca Raton,1994:87-93.

余小玲,曾翔君,杨旭,等.混合封装电力电子集成模块内的传热研究[J].西安交通大学学报,2004,38(3):258-261.

Yu Xiaoling,Zeng Xiangjun,Yang Xu,et al. Heat transfer in a hybrid integrated power electronic module[J].Journal of Xi'an Jiaotong University,2004,38(3):258-261.

庄骏,张红.热管技术及其工程应用[M].北京:化学工业出版社,2000:118-122.

余小玲. 电力电子集成模块及新型翅柱复合型散热器的传热性能研究[D].西安:西安交通大学能源与动力工程学院,2005.

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Optimization of Flow and Heat Transfer Performance for Double-Rim Squealer Tip in Gas Turbines

Development of a Fouling Model for Rotary Air Preheaters and Study on Heat Transfer Performance under Fouling Conditions

Experimental Investigation on Heat Transfer and Flow Friction Characteristics in Three Types of Plate Fin-and-Tube Heat Exchangers

Fast Algorithm for Prediction of Fluid Flow and Heat Transfer

A Fast Calculation Method for Thermal Flow Fields in Transformer Windings Based on PI-DeepONet

Related Author

LI Haoyu

HE Kun

YAN Xin

LI Haoyu

HE Kun

YAN Xin

GAO Rongze

YANG Yun

Related Institution

School of Energy and Power Engineering，Xi’an Jiaotong University

School of Energy and Power Engineering, Xi’an Jiaotong University

Xi'an Thermal Power Research Institute Co., Ltd.

Huaneng Lanzhou Thermal Power Co., Ltd.

State Key Laboratory of Multiphase Flow in Power Engineering, Xi'an Jiaotong University

⁰