The options of cooling raw syngas when retrofitting PG9351FA natural gas combined cycle(NGCC)to an integrated gasification combined cycle(IGCC)power plant were discussed. The ways of adopting the by-product steam resulting from raw syngas cooling process were analyzed. A transport gasifier was applied to the retrofitted power plant as the source of syngas. The surge margin
maximum power output
and NO
x
emission constraint were considered in modeling the off-design behavior of PG9351FA gas turbine. Four retrofitting cases were discussed on the basis of options of cooling raw syngas and ways of adopting by-product steam. The results show that the gas turbine could consume the syngas with a lower heating value of 6.5 MJ/m
3
while the compressor surge margin could decrease by only less than 10% when T
3
decreased by 100 ℃. Moreover
applying the total heat rec
overy method to cool syngas and a saturated steam turbine to adopt the by -product steam could lead to a net efficiency of 42.3%
the highest in four retrofitting cases.
关键词
Keywords
references
PINKSTON T, MORTON F. Orlando gasification project: demonstration of a 285 MW coal-based transport gasifier [C]∥Proceedings of the 31st International Technical Conference on Coal Utilization and Fuel Systems. Florida, USA: Department of Energy & Coal Technology Association of the United States, 2006:261-270.
GUTIERREZ J P, SULLIVAN T B, FELLER G J. Turning NGCC into IGCC: cycle retrofitting issues [C/CD]∥Proceedings of the ASME Turbo Expo. New York, USA: ASME, 2006:GT2006-88112.
SHELTON W, LYONS J. Transport gasifier IGCC base cases, PED-IGCC-98-006[R]. Morgantown, WV, USA: National Energy Technology Library,2000.
MAURSTAD O. An overview of coal based integrated gasification combined cycle(IGCC)technology, LFEE 2005-002 [R]. Cambridge, MA, USA: Massachusetts Institute of Technology. Laboratory for Energy and the Environment, 2005.
ORBAY R C, GENRUP M, ERIKSSON P, et al. Off-design performance investigation of a low calorific value gas fired generic type single-shaft gas turbine[C/CD]∥Proceedings of the ASME Turbo Expo. New York, USA: ASME, 2007: GT2007-27936.
BRDAR R D, JONES R M. GE IGCC technology and experience with advanced gas turbines, GER-4207 [R]. Schenectady,USA: GE Power Systems, 2000.
MARTELLI E, KREUTZ T, CONSONNI S. Comparison of coal IGCC with and without CO2 capture and storage: shell gasification with standard vs. partial water quench [J]. Energy Procedia, 2009, 1(1): 607-614.