Temperature Distribution During Plasma Activated Sintering

您当前的位置：

首页 >

文章列表页 >

Temperature Distribution During Plasma Activated Sintering

更新时间：2025-07-09

- Temperature Distribution During Plasma Activated Sintering
- Vol. 45, Issue 1, Pages: 122-126(2011)
- 作者机构：
  
  西安交通大学金属材料强度国家重点实验室,西安,710049
- 作者简介：
- 基金信息：
- DOI：
  CLC： TB30
- Online First：10 January 2011，
  
  Published：2011
- 稿件说明：
移动端阅览
Temperature Distribution During Plasma Activated Sintering[J]. 2011, 45(1): 122-126.
DOI：

Temperature Distribution During Plasma Activated Sintering[J]. 2011, 45(1): 122-126. DOI：

摘要

以导电性的石墨和绝缘性的氧化铝为测试对象

对等离子活化烧结过程中试样和模具所组成体系的温度分布进行了理论分析和实验研究.结果表明

在200～800 ℃的测量范围内

石墨-模具体系和氧化铝-模具体系内均存在径向温度梯度

试样的温度均高于模具外壁的温度

2种体系的径向温差随温度的升高成抛物线趋势增大.在同一温度下

石墨-模具体系的径向温度梯度大于氧化铝-模具体系的径向温度梯度

2种体系内测温点与试样中心点之间的温差均随两点之间距离的增大而成抛物线趋势增大

这与理论分析结果是相一致的.

Abstract

The temperature distribution of the sample-die system during plasma activated sintering(PAS)process was investigated theoretically and experimentally. For the experimental measurements

the electrical conductive graphite and non-conductive alumina samples were used. The results show that a radial temperature gradient exists in both the graphite-die and alumina-die systems

and that the temperature in the sample gets higher than that in the die in the temperature range of 200-800 ℃. Moreover

at the same temperature

the temperature gradient in the graphite-die system is larger than that in the alumina-die system. With increasing distance between measuring point and sample center

the radial temperature differences in both the systems increase following a parabolic trend

which agrees with the theoretical analysis. And the radial temperature difference exhibits a parabolic increase tendency with increasing temperature.

关键词

Keywords

references

YAMAZAKI K, RISBUD S H, AOYAMA H, et al. Plasma activated sintering transient sintering process control for rapid consolidation of powders [J]. Journal of Materials Processing Technology, 1996,56(1/4):955-965.

JUNG Y G, HA C G, SHIN J H, et al. Fabrication of functionally graded ZrO2/NiCrAlY composites by plasma activated sintering using tape casting and it's thermal barrier property [J]. Materials Science and Engineering: A, 2002,323(1/2):110-118.

WANG Jian, XING Jiandong,QIU Zhibin, et al. Effect of fabrication methods on microstructure and mechanical properties of Fe3Al-based alloys [J]. Journal of Alloys and Compounds, 2009, 488(1):117-122.

EL-ESKANDARANY M S, OMORI M, KONNO T J, et al. Synthesizing of nanocomposite WC/MgO powders by mechanical solid-state reduction and subsequent plasma-activated sintering [J]. Metallurgical and Materials Transactions: A, 2001, 32(1):157-164.

金海云. AlN、SiC可加工复相陶瓷的硏究 [D]. 西安: 西安交通大学材料科学与工程学院,2007.

NEMOTO T, SATO J, LIDA T, et al. Doping characteristics of silver in Mg2Si1-xGex prepared by plasma activated sintering [J]. Thermoelectric Power Generation, 2008, 1044:253-258.

FAN Xi'an, YANG Junyou, ZHU Wen, et al. Thermoelectric properties of p-type Te-doped(Bi,Sb)(2)Te-3alloys by mechanical alloying and plasma activated sintering [J]. Journal of Alloys and Compounds, 2008, 448(1/2):308-312.

VANMEENSEL K, LAPTEV A, HENNICKE J, et al. Modelling of the temperature distribution during field assisted sintering [J]. Acta Materialia, 2005, 53(16):4379-4388.

KAMIYA A. Observation of sample sintering temperature by the plasma activated sintering(PAS)furnace [J]. Journal of Materials Science Letters, 1998, 17(1):49-51.

WANG Yucheng, FU Zhengyi, ZHANG Qingjie, et al. SPS temperature distribution of different conductivity materials [J]. Key Engineering Materials, 2002, 224/226(11):717-720.

WANG Yucheng, FU Zhengyi. Study of temperature field in spark plasma sintering [J]. Materials Science and Engineering: B, 2002, 90(1/2):34-37.

熊家国, 熊焰,何代华,等. 放电等离子烧结过程温度场及原子扩散 [J]. 武汉理工大学学报, 2008, 30(12):11-14.

XIONG Jiaguo, XIONG Yan, HE Daihua, et al. Temperature field and atom diffusion in spark plasma sintering [J]. Journal of Wuhan University of Technology, 2008, 30(12):11-14.

ZAVALIANGOS A, ZHANG J, MARTIN K, et al. Temperature evolution during field activated sintering [J]. Materials Science and Engineering: A, 2004, 379(1/2):218-228.

RÄTHEL J, HERRMANN M, BECKERT W, et al. Temperature distribution for electrically conductive and non-conductive materials during field assisted sintering [J]. Journal of the European Ceramic Society, 2009, 29(8):1419-1425.

ZHANG Jing, ZAVALIANGOS A, GROZA J, et al. The effect of specimen conductivity on current and temperature distribution in field activated sintering [C]∥Proceedings of the 2003 International Conference on Powder Metallurgy Particulate Materials. Las Vegas, NV, USA: Metal Powder Industries Federation, 2003:8-12.

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Thermal Effect of Rotor-Bearing System Considering Synchronous Whirling of Journal

Experimental Study on the Maximum Soot Loading Performance of Diesel Particle Filters

Marangoni Condensation Heat Transfer Characteristics on Vertical Surface with Temperature Gradients

Sound Absorption Properties of Sintered Fibrous Metals under High Temperature Conditions

Aerodynamics of Injection of a Radial Slot Jet

Related Author

JI Dawei

WANG Long

YUAN Qi

LIU Yang

YU Chengzhi

HUA Lun

ZHANG Qiushi

LIU Haitao

Related Institution

School of Energy and Power Engineering, Xi'an Jiaotong University

Impeller Machinery and Power Equipment Engineering Laboratory of Shaanxi Province

Technology Development Branch, Turbine Company, Shanghai Electric Power Station Equipment Co., Ltd.

State Key Laboratory of Engine and Powertrain System, Weichai Power Company Limited

Suzhou Automotive Research Institute, Tsinghua University

⁰