Aerodynamic Optimization Design of Vaned Diffuser for Centrifugal Compressor under Stage Environment

您当前的位置：

首页 >

文章列表页 >

Aerodynamic Optimization Design of Vaned Diffuser for Centrifugal Compressor under Stage Environment

更新时间：2025-07-09

- Aerodynamic Optimization Design of Vaned Diffuser for Centrifugal Compressor under Stage Environment
- Vol. 43, Issue 11, Pages: 32-36(2009)
- 作者机构：
  
  西安交通大学叶轮机械研究所,西安,710049
- 作者简介：
- 基金信息：
- DOI：
  CLC： TK474.8
- Online First：10 November 2009，
  
  Published：2009
- 稿件说明：
移动端阅览
Aerodynamic Optimization Design of Vaned Diffuser for Centrifugal Compressor under Stage Environment[J]. 2009, 43(11): 32-36.
DOI：

Aerodynamic Optimization Design of Vaned Diffuser for Centrifugal Compressor under Stage Environment[J]. 2009, 43(11): 32-36. DOI：

摘要

在级环境下采用人工神经网络和遗传算法在对设计工况下的离心压气机扩压器叶片型线进行了优化

并采用数值方法对优化前、后离心压气机级的气动性能进行了对比分析.结果表明:在设计工况下

优化后的叶片扩压器静压恢复系数提高了11.7%

总压损失系数减少了21.12%

离心压气机级绝热等熵效率提高1.64%

达到了86.01%; 非设计工况下离心压气机的气动性能也有显著改善; 优化后离心压气机级在设计转速下喘振裕度有所提高

阻塞裕度略有降低.

Abstract

The vaned diffuser profile designed preliminarily has been optimized using artificial neural network and genetic algorithm under stage environment to improve the aerodynamic performance at the design operation condition. The aerodynamic performance of the stage composed of the vaned diffuser optimized and the original impeller at the design and off-design operation conditions is predicted using the numerical method. The results show that the static pressure recovery coefficient of the vaned diffuser and the isentropic efficiency of the stage was increased by 11.7% and 1.64%

respectively. The total pressure loss coefficient of the vaned diffuser was decreased by 21.12%

and the isentropic efficiency of the stage was 86.1% at the design operation condition. Moreover

the aerodynamic performances of the stage at the off-design operation conditions was improved significantly. In addition

the surge margin of the stage was increased

and the choke margin was decreased slightly.

关键词

Keywords

references

FERRARA G, FERRARI L, BALDASSARRE L, et al. Experimental investigation and characterization of the rotating stall in a high pressure centrifugal compressor: part I [C]∥Proceeding of ASME Turbo Expro 2002. New York, USA: ASME, 2002: 613-620.

FERRARA G, FERRARI L, BALDASSARRE L, et al. Experimental investigation and characterization of the rotating stall in a high pressure centrifugal compressor: part II [C]∥Proceeding of ASME Turbo Expro 2002. New York, USA: ASME, 2002: 621-628.

CELLAI A, FERRARA G, FERRARI L, et al. Experimental investigation and characterization of the rotating stall in a high pressure centrifugal compressor: part III [C]∥Proceeding of ASME Turbo Expro 2003. New York, USA: ASME, 2003: 711-719.

ZIEGLER K U, GALLUS H E, NIEHUIS R. A study on impeller-diffuser interaction: influence on the performance [J]. ASME J of Turbomachinery, 2003, 125(1): 183-192.

ZIEGLER K U, GALLUS H E, NIEHUIS R. A study on impeller-diffuser interaction: detailed flow analysis [J]. ASME J of Turbomachinery, 2003, 125(1): 173-182.

BONCINELLI P, ARNONE A. Impeller-diffuser interaction in centrifugal compressors: Numerical analysis of Radiver test case [J]. AIAA Journal of Propulsion and Power, 2007, 23(6): 1304-1312.

王志恒,席光. 离心压气机叶片扩压器气动优化设计[J]. 工程热物理学报, 2007,28(3):391-394.

WANG Zhiheng, XI Guang. Aerodynamic optimization design of vaned diffuser for centrifugal compressors [J]. Journal of Engineering Thermophysics, 2007, 28(3): 391-394.

IBARAKI S, MATSUO T, YOKOYAMA T. Investigation of unsteady flow field in vaned diffuser of a transonic centrifugal compressor [J]. ASME J of Turbomachinery, 2007, 129(4): 686-693.

ZANGENEH M, VOGT D, RODUNER C. Improved a vaned diffuser for a given centrifugal impeller by 3D inverse design [C]∥Proceeding of ASME Turbo Expro 2002. New York, USA: ASME, 2002: 1111-1122.

ORTH U, EBBING H, KRAIN H, et al. Improved compressor exit diffuser for an industrial gas turbine [C]∥Proceeding of ASME Turbo Expro 2001. New York, USA: ASME, 2001: 19-26.

席光,王志恒,王尚锦. 叶轮机械气动优化设计中的近似模型方法及其应用[J]. 西安交通大学学报,2007,41(2):125-135.

XI Guang, WANG Zhiheng, WANG Shangjin. Aerodynamic optimization design of turbomachinery with approximation model method [J]. Journal of Xi' an Jiaotong University, 2007, 41(2): 125-135.

舒信伟, 谷传纲, 杨波,等. 基于小生境遗传算法和RANS方程的平面叶栅气动优化设计[J]. 航空动力学报, 2007, 22(1): 48-53.

SHU Xinwei, GU Chuangang, YANG Bo, et al. Aerodynamic optimization for cascade blade based on niche gas and RANS equation [J]. Journal of Aerospace Power, 2007, 22(1): 48-53.

王晓峰,席光,王尚锦. 离心压缩机叶轮的响应面优化设计I: 设计方法[J]. 工程热物理学报, 2004, 25(3): 408-410.

WANG Xiaofeng, XI Guang, WANG Shangjin. Response surface methodology for centrifugal compressor impeller optimization design: design method [J]. Journal of Engineering Thermophysics, 2004,25(3): 408-410.

YIU K F C, ZANGENEH M. Three-dimensional automatic optimization method for turbomachinery blade design [J]. Journal of Propulsion and Power, 2000, 12(6):1174-1181.

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

I/O Performance Modeling and Prediction Method for Large-Scale Parallel Applications Using Machine Learning

Integrated and Joint Design Optimization of Centrifugal Compressor Impeller and Casing Treatment at Multiple Working Points

Predictive Combustion Model for Hydrogen-Enriched Compressed Natural Gas Engines Using Machine Learning

Optimized Epithermal Neutron Field Design Based on D-D Neutron Source

Research on the Electrohydrodynamic Effects of Ionic Liquid-Modified Fuels

Related Author

LIU Heng

WANG Ziheng

WANG Qiang

LIU Xindong

LONG Bingzhi

DONG Xiaoshe

LU Yifan

ZHANG Xiawen

Related Institution

School of Software，Xi'an Jiaotong University

Network Information Center，Xi'an Jiaotong University

School of Computer Science and Technology，Xi'an Jiaotong University

School of Energy and Power Engineering，Xi'an Jiaotong University

School of Energy and Power Engineering, Xi'an Jiaotong University

⁰