Electrical breakdown characteristics of interconnect system on printed circuit board(PCB)under square pulse are investigated with direct pulse injection. And the performance evaluation for the interconnect system insulation is carried out according to the experimental results. Following the fact that the breakdown behaviors agree with Weibull distribution
the curves of cumulative failure rate under the conditions of different insulation gap distances and different injection pulse widths are obtained by statistical analysis. It is indicated that as parallel interconnects on PCB are injected with square pulse
the breakdown field strength increases with the decreasing insulation distance
accompanied with two distinct phases; breakdown field strength also decreases with increasing injection pulse width. Compared with the breakdown characteristics and morphology before and after breakdown
the breakdown behavior between parallel interconnects on PCB is thought as “solid-gas” composite dielectric accompanied by an unrecoverable dielectric strength. The insulation failure rate curves of samples under different conditions are obtained by Weibull statistical methods to provide an important reference for the insulation performance evaluation of similar devices under the impact of square pulse.
关键词
Keywords
references
LEONE M. Radiated susceptibility on the printed-circuit-boardlevel: simulation and measurement[J]. IEEE Transactions on Electromagnetic Compatibility, 2005,47(3):471-478.
HAAKE K, TER HASEBORG J L. Determination of coupling of UWB pulses into complex PCB line structures using multi-alignment measurements[C]∥2008 IEEE International Symposium on EMC. Piscataway, NJ, USA: IEEE, 2008:1-5.
HWANG S M, HONG J, HAN S M, et al. The susceptibility of microcontroller device with coupling caused by UWB-HPEM[C]∥Progress in Electromagnetics Research Symposium Proceedings. Cambridge, MA, USA: IEEE, 2009: 1269-1272.
CAMP M, GARBE H, NITSCH D. Influence of the technology on the destruction effects of semiconductors by impact of EMP and UWB pulses[C]∥2002 IEEE International Symposium on Electromagnetic Compatibility. Piscataway, NJ, USA: IEEE, 2002: 87-92.
NITSCH D, CAMP M, SABATH F, et al. Susceptibility of some electronic equipment to HPEM Threats [J]. IEEE Transactions on Electromagnetic Compatibility, 2004, 46(3): 380-389.
CHEN Jingping, LIU Shanghe,TAN Zhiliang, et al. Experimental study of the damage effects of integrated circuits stressed with ESD pulse[J]. High Voltage Engineering, 2007,33(3):121-124.
CHEN Jingping, LIU Shanghe,TAN Zhiliang, et al. Damage effects of integrated circuits injected by square wave pulse[J]. Journal of Ordnance Engineering College, 2006,18(2):12-19.
QI Shufeng, YANG Jie, LIU Hongbing, et al. Review of experiment investigation latent failure of ESD on microelectric device[J]. Journal of Ordnance Engineering College, 2006,18(5):27-31.
DU B, LIU Y, LIU H. Effect of low pressure on tracking failure of printed circuit boards[J]. IEEE Transactions on Dielectrics and Electrical Insulation, 2008, 15(5):1379-1384.
YANG Lijun, LIAO Ruijin, LI Jian, et al. Estimating lifetime of oil-paper insulation under electrical aging conditions using step-stress tests and Weibull parameters[J]. High Voltage Engineering, 2004,30(6):4-8.
DISSADO L A, FORTHERGILL J C, WOLFE S V, et al. Weibull statistics in dielectric breakdown: theoretical basis, applications and implications[J]. IEEE Transactions on Electrical Insulation, 1984,19(3): 227-233.
PELISSOU S, BENCAAND P, GROSS L H. Electrical properties of metallocene polyethylene[C]∥2004 International Conference on Solid Dielectrics: Volume 1. New York, NY,USA:IEEE, 2004:466-469.
WANG Le, XU Man, SUN Ying, et al. Study on the resistance and electrical breakdown properties of nano silver/epoxy resin composite[J]. Insulating Materials, 2006,39(4):37-40.