跨声速轴流压气机通流计算及模型优化方法

张超; 张夏雯; 许颜博; 李震; 琚亚平; 张楚华

doi:null

您当前的位置：

首页 >

文章列表页 >

跨声速轴流压气机通流计算及模型优化方法

更新时间：2026-09-29

- 跨声速轴流压气机通流计算及模型优化方法
- Throughflow Calculation and Model Optimization Method for Transonic Axial-Flow Compressors
- 西安交通大学学报 2026年
- 作者机构：
  
  西安交通大学能源与动力工程学院，710049，西安
- 作者简介：
- 基金信息：
- DOI：
  中图分类号： TH453
- 收稿：2026-06-23，
  
  修回：2026-08-28，
  
  录用：2026-09-11，
- 稿件说明：
移动端阅览
张超, 张夏雯, 许颜博, 等. 跨声速轴流压气机通流计算及模型优化方法[J/OL]. 西安交通大学学报,2026-09-29. http://zkxb.xjtu.edu.cn/zh/article/172884361/.

ZHANG Chao, ZHANG Xiawen, XU Yanbo, et al. Throughflow Calculation and Model Optimization Method for Transonic Axial-Flow Compressors[J/OL]. JOURNAL OF XI’AN JIAOTONG UNIVERSITY,2026-09-29. http://zkxb.xjtu.edu.cn/zh/article/172884361/.
张超, 张夏雯, 许颜博, 等. 跨声速轴流压气机通流计算及模型优化方法[J/OL]. 西安交通大学学报,2026-09-29. http://zkxb.xjtu.edu.cn/zh/article/172884361/. DOI：

ZHANG Chao, ZHANG Xiawen, XU Yanbo, et al. Throughflow Calculation and Model Optimization Method for Transonic Axial-Flow Compressors[J/OL]. JOURNAL OF XI’AN JIAOTONG UNIVERSITY,2026-09-29. http://zkxb.xjtu.edu.cn/zh/article/172884361/. DOI：

摘要

针对跨声速轴流压气机气动分析设计中落后角与损失经验模型精度低、适用范围窄等问题，发展了跨声速轴流压气机通流特性计算方法，并提出了一种基于多转速特性曲线实验数据的经验模型优化校准方法。利用典型跨声速压气机级的多转速特性曲线的实测数据，对经验模型组合中的15个经验参数进行了优化校准，并在多台跨声速轴流压气机/风扇上进行了通用性验证。研究结果表明：基于落后角和损失系数实测数据的多转速通流计算相对误差小于1%；相较于传统经验模型组合高达6%的通流计算误差，优化后的经验模型可将压气机级多转速通流特性计算误差降低1%~4%；在两级跨声速风扇与三级跨声速压气机验证算例中，设计转速通流特性计算相对误差均降低至1%以内。该研究工作可为多级跨声速轴流压气机分析设计和模型开发提供有参考价值的通流计算方法和经验模型。

Abstract

To address the issues of low accuracy and limited applicability of existing deviation angle and loss empirical models in the aerodynamic analysis and design of transonic axial compressors

this paper develops a throughflow performance calculation method for transonic axial compressors and proposes an empirical model optimization and calibration method based on experimental multi-speed characteristic curve data. Using measured multi-speed characteristic data from typical transonic compressor stages

15 empirical parameters in the model combination are optimized and calibrated

and the generality of the optimized model is validated on multiple transonic axial compressors/fans. The results show that the relative error of multi-speed throughflow calculations based on measured deviation angles and loss coefficients is less than 1%. Compared with the up to 6% calculation error of conventional empirical model combinations

the optimized empirical model reduces the multi-speed throughflow calculation error for compressor stages by 1%–4%. In the validation cases of a two-stage transonic fan and a three-stage transonic compressor

the relative errors of throughflow calculations at the design rotational speed are all reduced to within 1%. This work provides valuable throughflow calculation methods and empirical models for the analysis

design

and model development of multi-stage transonic axial compressors.

关键词

Keywords

references

宫武旗 , 伍儒康 . 求解流线曲率法反命题的一种新型有限差分方法 [J ] . 西安交通大学学报 , 2015 , 49 ( 3 ): 11 - 13 .

GONG Wuqi , WU Rukang . New finite difference scheme for solving inverse proposition of streamline curvature method [J ] . Journal of Xi'an Jiaotong University , 2015 , 49 ( 3 ): 11 - 13 .

范智翔 , 张夏雯 , 李震 , 等 . 跨声速压气机转子通用k-ω湍流模型的机器学习辅助优化 [J ] . 西安交通大学学报 , 2026 , 60 ( 1 ): 180 - 189 .

FAN Zhixiang , ZHANG Xiawen , LI Zhen , et al . Machine learning-assisted optimization of generalized k-ω turbulence model for transonic compressor rotors [J ] . Journal of Xi'an Jiaotong University , 2026 , 60 ( 1 ): 180 - 189 .

SCHMITZ A , AULICH M , NICKE E . Novel approach for loss and flow-turning prediction using optimized surrogate models in two-dimensional compressor design [C ] . ASME-GT2011 - 45086 .

SCHMITZ A , AULICH M , SCHÖNWEITZ D , NICKE E . Novel performance prediction of a transonic 4.5 stage compressor [C ] . ASME-GT2012 - 69003 .

TANG T Q , LIU B . The genetic algorithm-radial basis function neural network to quickly predict aerodynamic performance of compressors [J ] . Proceedings of the Institution of Mechanical Engineers：Part G Journal of Aerospace Engineering . 2021 , 235 ( 5 ): 537 - 552 .

程兰兰 , 李怡 , 黄秀全 , 等 . 基于机器学习的进口导流叶片损失与落后角预测 [J ] . 风机技术 , 2021 , 63 ( 2 ): 21 - 28 .

CHENG Lanlan , LI Yi , HUANG Xiuquan , et al . Inlet guide vane loss and deviation prediction based on machine learning [J ] . Chinese Journal of Turbomachinery , 2021 , 63 ( 2 ): 21 - 28 .

SCHNOES M , NICKE E . Automated calibration of compressor loss and deviation correlations [C ] . ASME-GT2015 - 42644 .

FEI T , JI L C . Application of new empirical models based on mathematical statistics in the throughflow analysis [J ] . Journal of Thermal Science . 2021 30 ( 6 ): 2087 - 2098 .

宋召运 , 王宝潼 , 范腾博 , 等 . 基于正反问题耦合的压气机特性快速预测方法 [J ] . 航空动力学报 , 2022 , 37 ( 3 ): 619 - 628 .

SONG Zhaoyun , WANG Baotong , FAN Tengbo , et al . Rapid prediction method of compressor characteristics with coupling direct and inverse problems [J ] . Journal of Aerospace Power , 2022 , 37 ( 3 ): 619 - 628 .

于佳正 . 轴流压气机导/静叶调节规律平均中径法预测研究 [D ] . 北京 : 华北电力大学 , 2023 .

刘稼昊 , 耿少娟 , 金芸 , 等 . 多级轴流压气机一维性能预测程序开发及应用 [J ] . 热能动力工程 , 2024 , 39 ( 1 ): 12 - 22 .

LIU Jiahao , GENG Shaojuan , JIN Yun , et al . Development and application of one-dimensional performance prediction program for multistage axial compressor [J ] . Journal of Engineering for Thermal Energy and Power , 2024 , 39 ( 1 ): 12 - 22 .

YAN W , ZHENG Q , CHI Z , JIANG B . Improving the accuracy of one-dimensional analysis in axial compressor performance prediction [J ] . Physics of Fluids . 2025 , 37 ( 3 ): 037150 .

LIEBLEIN S . Incidence and deviation-angle correlations for compressor cascades [J ] . Journal of Basic Engineering , 1960 , 82 ( 3 ): 575 - 584 .

BOYER K M . An improved streamline curvature approach for off-design analysis of transonic compression systems [D ] . Blacksburg : Virginia Polytechnic Institute and State University , 2001 .

JOHNSEN I A , BULLOCK R O . Aerodynamic design of axial-flow compressors [R ] . NASA SP-36, 1965 .

LIEBLEIN S . Loss and stall analysis of compressor cascades [J ] . Journal of Basic Engineering , 1959 , 81 ( 3 ): 387 - 400 .

HOWELL A R . Fluid dynamics of axial compressors [J ] . Proceedings of the Institution of Mechanical Engineers , 1945 , 153 ( 1 ): 441 - 452 .

雷凡 . 多级轴流压气机多维变可信度气动优化设计方法及应用 [D ] . 西安 : 西安交通大学 , 2022 .

AUNGIER R H . Axial-flow compressors: a strategy for aerodynamic design and analysis [M ] . New York : ASME Press , 2003 .

张超 . 跨音速轴流压气机/风扇通流计算模型优化及气动设计 [D ] . 西安 : 西安交通大学 , 2026 .

CETIN M , UECER A S , HIRSCH C H , et al . Application of modified loss and deviation correlations to transonic axial compressors [R ] . AGARD-R-745 , 1987 .

SWAN W C . A practical method of predicting transonic-compressor performance [J ] . Journal of Engineering for Power , 1961 , 83 ( 3 ): 322 - 330 .

JANSEN W , MOFFATT W C . The off-design analysis of axial-flow compressors [J ] . Journal of Engineering for Power , 1967 , 89 ( 4 ): 453 - 462 .

KOCH C C , SMITH L H . Loss sources and magnitudes in axial-flow compressors [J ] . Journal of Engineering for Power , 1976 , 98 ( 3 ): 411 - 424 .

MORRIS A W , HOARE R G . Secondary loss measurements in a cascade of turbine blades with meridional wall profiling [C ] . ASME Paper No.75-WA/GT-13 , 1975 .

REID L . Performance of single-stage axial-flow transonic compressor with rotor and stator aspect ratios of 1.19 and 1.26, respectively, and with design pressure ratio of 1.82 [R ] . NASA TP-1338, 1978 .

ROYCE D M , LONNIE R . Performance of single-stage axial-flow transonic compressor with rotor and stator aspect ratios of 1.19 and 1.26, respectively, and with design pressure ratio of 2.05 [R ] . NASA TP-1659, 1980 .

URASEK D C , GORRELL W T , CUNNAN W S . Performance of two-stage fan having low-aspect-ratio first-stage rotor blading [R ] . NASA TP-1493, 1979 .

STEINKE R J . Design of 9.271-pressure-ratio five-stage core compressor and overall performance for first three stages [R ] . NASA TP-2597, 1986 .

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

端壁合成射流激励参数变化对跨声速轴流压气机性能的影响

超声波激励下倾斜表面液滴逆重力迁移的润湿特性研究

碳酸氢钠体系中基于pH特征的聚球藻生长模型构建与验证

采用多状态柔性合成的离网型风光氢氨系统两阶段分布鲁棒调度

直接空冷岛侧部百叶窗防冻性能与适用性研究